-
thermostat mode
Hello, the choice to eliminate the possibility of setting the operating mode on the thermostat (legacy mode) to turn off the air conditioner "manually" is wrong; it was a very useful option.
-
Comfort screen settings
Ability change the comfort range and set a min/max in the comfort toggle
-
Default for adjusting a TRV should be “until next change” or at least set as default
I quite often increase the heating in the front room using the TRV. That seems to set the temperature “until you resume the schedule” whereas if you use the app the default is “until next change”. This has resulted in me leaving the heating set on 20oC overnight a few times. Is there a way to change the default setting? If…
-
Temperature Display
Hi When you blink the display from the app can it display the current temperature rather than a pointless message. Regards John
-
Show Actual Status of Wired Thermostat Controller
Hello Team, Currently Wired Thermostat shows heating on only when it's manually Switched ON to a heating setpoint or scheduled ON. It would be good to see when the controller switched ON the Heating device based on the requirements of Room TRV Controllers.
-
Different setting based on who is at home
Firstly, this function may have been mentioned before. I couldn't find it though. There are 4 of us in the house, me my wife and the two children. All radiators in all rooms have the Tado radiator controls. All 4 of us have access to the app and use location tracking. When just the two of us (my wife and me) are at home, I…
-
Option to select between load compensation or weather compensation
Hi Could you add an option to select between using load compensation or weather compensation using internet weather data, this would let you try both methods to see what works best for your particular house. On all digital buses craig
-
Allow full configuration of all tado devices in the system by default
When trying to set up SRVs, I initially only had the option of selecting the wireless receiver as the zone controller. After talking to tado support, they added the option of selecting one if my thermostats instead. It would be good if this kind of setting was user definable from the beginning, with better documentation…
-
The Tado is not Smart Enough
I worked on heating systems before the Internet. Commercial Heating systems used Optimisers. They were quite complex in operation and learned over time. But the controls were simple. It had an outside temperature sensor and an internal temperature sensor as a minimum. You programmed in occupancy times. If the outside…
-
Please vote: Meer bridges en zones in dezelfde app. / More bridges and zones in the same app.
Op het forum heb ik vaker gezien dat Tado in grotere gebouwen zoals onze pastorie met parochiezalen en dagkapel, niet toekomt met één bridge. De oudste verzoeken daaromtrent in het forum zijn al van een paar jaar geleden. Ook kan in de app maar één bridge worden aangesloten en kan je bovendien maar één gebouw invoeren. De…
-
Minimise Boiler Running
I have smart radiator valves in every room. However I have found that individual rooms heat and cool at different rates, which can lead to the boiler running more often. Eg. Room A cools and demands heating but Room B isn’t yet cool enough to demand but is cooling down. Room A warms up and cuts off and the a short time…
-
Add modes / scenarios
Add the option to create modes/scenarios and tie custom schedules to them. Some examples - work from home - Child week - Party As it is today there is a constant change of the schedules when I for example decide to work from home instead of the office or when it’s my week with my daughter.
-
Help!
I’ve installed this Tado and extension kit for a customer. I cannot fathom out how it controls a hot water valve. There’s no instructions and I’ve had to download all sorts on my phone to even get the instructions. I’m really not happy with the customer service, it’s impossible to talk to anyone or get any information. I…
-
Traploze aanvoertemperatuur
Momenteel wordt de aanvoertemperatuur aangestuurd in stappen van hele graden Celsius, kleinere stappen of traploos zou pendelgedrag behoorlijk kunnen verminderen.
-
Please set more home control
Hi everyone, i think it s must to have a multiple home control from the app tado, i have many tado devices but when i found out it was impossible it has been one of the worst nightmare. How is that possible. I think it s obvious to let people control another house, as example, the holiday house in the mountains… i hope it…
-
Valve pin position indicator
My Bosch system which I got rid of in favor of Tado included in the app a place where you could see the position of the valve pin. This was useful to determine if TRV was fully opening or closing the valve pin and other temperature issues. I think this would be useful on the Tado system as well
-
Firmware update to include EMS2 support
Having upgraded my boiler to a greenstar 4000 30kW, I am disappointed to find out that tado cannot connect digitally, only via relay. There will be a lot of customers facing the same issue and this should be set as a priority to be resolved as I can’t imagine a firmware update to include the new language being too…
-
Improve feedback in app when geo fencing stops working
Yesterday when I got back home from work the temperature in our house was very low. I checked the Tado app and it showed that Tado was working in 'away' mode for the full day while my wife, that has Tado on her phone, was home all day. Last week everything was still working fine so I checked the Tado app on her phone. When…
-
Multi home support
Still waiting after all these years
-
Integrate with smart meter
Stop wasting my time with app notifications to key my meter reading to get smart eq working
-
Temporary manual override for childlock on TRV
I would love to have the ability to configure an override code to allow adjusting the temperature on my child locked Smart Radiator Thermostat without using the app. The override code should be first configured via the app and could consist of for example three numbers indicating how many clicks the TRV needs to be turned…
-
Draadloze Temperatuursensor ook met deel graden laten werken
Ik vind het storend dat als ik in de app mijn max temperatuur op 20,5 graad zet, de draadloze temperatuursensor toch de kamer laat verwarmen naar 21 graden. Met de radiator knoppen gaat dit wel goed. Zelfs met tiende graden instelbaar. Waarom neemt de draadloze temperatuursensor dan niet de ingestelde temperatuur in tiende…
-
Show amount of hot water available
Not sure if this is possible, but with all the tech these days, why can’t the app show you how much hot water you have available and therefore you know if you need to heat it up before you actually run out. Based on your usage it could even suggest and automate schedule. Seems quite simple!
-
Interazione pompa calore irragiamento
Per la gestione tramite Tado degli split pompa di calore, sarebbe molto interessante un interfaccia con un sensore di irraggiamento, da installare, in modo da fare funzionare gli stessi solo quando il fotovoltaico produce una quantità decisa dall' utente. Potrebbe anche andare bene una lettura della produzione di energia…
-
improve Care&Protect by reading bus-codes (OT)
care & protect is currently not reading out bus codes which display the error codes on my heater/boiler (Nefit Proline HRC24 - OpenTherm). In my recent case this led to low system pressure which I was not aware of and could damage the heater. luckily I found out quite early. Despite the heating request to the heater, the…
-
All rooms temporal scheduling
Sometimes you need to set a schedule for all the rooms just for a while, or just for one day because it is a holiday and everyone is in the house, and the reset it with the touch of a button to keep the regular schedule. I think having a button to set a temporal schedule for all the rooms would be useful, instead of…
-
Économie Energie
Bonjour, Il serait intéressant voir nécessaire de pouvoir éteindre les leds du switch internet comme sur la plupart des box et autre objet connecté
-
Multiple homes
Hi, I am commuting on a weekly basis and decided to set up my secondary home with tado° as well. However, I quickly realized that there was no way of handling multiple homes through a single account and as my account features (such as auto-assist) cannot be set up for an additional account this really minimizes the…
-
Simple UI improvements
Great system, nice app. Here are my suggestions on how you could improve the user interface (UI) in the mobile app for better usability and utility. In order of impact to the experience: Show humidity readings for each room on the Home view tiles - this would give more utility than the current solution - having to tap down…
-
Individual Radiator TRV Control
It would be extremely useful if there was a way to set individual radiator smart thermostats to away or home mode. There are times when out of the house and others are still in but will only use certain rooms but if they are on app the whole house will be regarded as "at home" under the geo fencing rule. Also when kids are…