-
Introducing myself
As suggested by @samd, I am making a short post to introduce myself as the community forum’s new admin. Hello! My name is Emcee, I live in Munich, Germany and am a member of tado°’s Customer Experience team. I hold a M.Sc. from the Technical University of Munich. My thesis was focused on hydroelectricity. I worked in the…
-
Redesign internet bridge and provide longer cables.
Hello. I would to suggest that: 1. The internet bridge is designed so that the cables come from the top not the bottom of the device. This would allow the device to stand upright freely away from the wall (2 requirements for best placement) 2. I would also like longer cables to be provided for the internet bridge - the…
-
Adding Wireless Thermostat change my zone config - not right to me
I have a number of wired thermostats downstairs all working for about 6 months. Then added a wireless controller and thermostat upstairs. But all the downstairs ones had their zone changed to use the wireless controller as the zone controller and I dont remember saying this was OK, i did set up the pair of controller and…
-
Apple Carplay / Android Auto
Develop a very simple Apple Carplay / Android Auto interface to allow basic control. e.g "Resume Schedule All Rooms" "Turn Off All Rooms" "Boost Heating All Rooms". The geofencing doesn't work well for me and this would be a good alternative.
-
Be able to see when heating was on in all rooms on one chart.
I like that I can see what times of the day the heating came on in a given room, but it would be great if I could see all the times the heating came on, in all rooms, at the same time in the same chart. This would help me to see my usage much better than checking 7 devices separately and reduce energy usage. E.g. I may…
-
1hr boost
It would be very helpful to be able to set a timer for boosting a heating zone. Some time I would like to have the heating on either upstairs or downstairs outside the scheduled times. More often than not I set it manually but I always forget to turn it off. Since I have underfloor heating the temperature raises very…
-
Multiple Wireless Underfloor Thermostats
Having moved from a single heating zone house with Tado to a new house with multiple heating zones (1 radiators + 4 underfloor) controlled by a Lightwave system. I would dearly love to convert the new house to Tado which is far superior. The only problem is that apparently Tado do not currently support multiple wireless…
-
Plasma Quad Mitsubishi
Hola, tengo un aire acondicionado Mitsubishi MSZ-AY42VGKP y este lleva incluido Plasma Quad que es como un purificador de aire. Este se pueda activar/desactivar desde el mando a distancia original pero al sincronizar Tado y gestionar el aire acondicionado con vuestro producto no me deja activar el Plasma Quad desde Tado y…
-
Vertical Radiator - Towel Rails - Smart Thermostat interface
In modern houses, we now find a lot of vertical radiators - they are space savers and also act as features. In my home, I have three vertical radiators I cannot interface TADO with, its frustrating as I cannot control these rooms/areas as I can with the rest of the house. Can TADO review the interfaces and advise of a…
-
Remove 10 room limit
I don’t live in a castle, but I exceeded the 10 room limit. So one room could not control the boiler after adding a temperature sensor to the room. Was ok before. To get round it I had to group two rooms together. Not ideal. I don’t see why 10 is a limit. Can’t Tado increase that please.
-
App should be able to shutoff manual settings of starterkit
For the use of Tado (starterkit) in rooms which cannot be accessed by you in person, such as; guestrooms, B&B, kids bedroom, other privacy sensitive situations, etc., it would be welcomed if the app can shut off the ability to change the roomtemperature manuallly. EG. We have a B&B and we have programmed the temperature…
-
Improve the temperature differential by applying a feedback loop
Every house is different. Boilers and plumbing is different. This leads to the temperature rising gradient being specific to each installation. So far so good? Now we often find a situation where a tado rad stat or room stat is set for, say, 18 degrees cent, but one later finds that the actual temperature is higher. It…
-
Hide Tiles
On the homescreen there are tiles that I never use and would like to hide. It would be nice to be able to hide the following tiles: auto-assist, air comfort, energy IQ, Care & Protect.
-
Color of tiles
The color of the tiles is now fixed at blue/green till 18 deg and orange/red from 19 degrees. We never set the temperature above 18,5 and therefore the colors are always blue/green. It would be nice to be able to set other limits. Having different limit for bedroom and living room would also be nice.
-
Merged: After several years still no range extension?
This discussion has been merged.
-
Warn about two day instruction wait time with compatibility check
I've just had to change my boiler, and I followed all the Tado advice about asking for a compatibility check. I thought all was good. The boiler installer engineer was here getting towards completion. I went to the Tado app to change the boiler. Found the boiler… and it said something like "Please wait for up to 2 days for…
-
Better collaboration with Air Source heating system
I have an air source heating system in my home and the projected forecast costs are not reflected well at all with the app. I input my energy usage each month and never get anywhere close accurate costing suggestions. The data input screens are clearly for gas/oil systems, and not designed for Air Source systems. Our Tado°…
-
Heat release valves
If there would be an option on valves to setup not to close the circuit when reaching the heating point, just send the end signal to the themrostat, then there should be circuits where the remaining heat should release and this extra heat could be useful in bathrooms or other higher heet needed rooms.
-
Valve moving when out of heating season
It's usual that the long pressed valve needles are stuck. If the valves move them on a setupable time period (daily, weekly, etc) this should be avoidable.
-
Temporary extend current schedule
Time to time I get into the situation when I know I will work a bit longer in my work room. Currently I can do two things to extend the heating, 1) wait until the switch and then set to the same temperature as before with a (optional) time limit 2) set the temperature +/-0.5C before the schedule switching off with…
-
Fault detection if no temperature change detected
If a room has an temperature increase demand but there is no change in temperature for a given time period a warning should be triggered by Tado. My boiler has an issue that it needs resetting Every soften I only find out after an hour so after i get cold. That the system is not working. But the Tado ‘care & protect’ tab…
-
Heating Activity - Real Time
Hello, Whilst "Heating Activity" is good at showing which zone/room is currently heating, what is not in anywhere near real time is the Total Today value. It will sometimes take hours before the Total Today time changes when I know the heating has been on for more than the total of 11 minutes it has kept telling me.. I may…
-
Volledig open, volledig gesloten instelling
Beste Tado, Het zou zeer handig zijn om een kleine instelling toe te voegen aan de instellingen voor de slimme radiatorknoppen. Namelijk een instelling dat hij volledig open gaat als er warmte vraag is, en volledig gesloten gaat als er geen warmte vraag meer is. Dus een instelling toevoegen voor niet stapsgewijs inregelen,…
-
Temperature cap by room
Can we please have the ability to set a cap on target temperatures by room on the app
-
Pouvoir changer la température hors gel
Bonjour, J'aimerai pouvoir changer la température hors gel par défaut pour pouvoir éteindre mon installation simplement quand je quitte ma maison de campagne pour quelques jours plutôt que de devoir utiliser le sélecteur vertical de température qui m'oblige à changer également jusqu'à quand ce changement de température…
-
weekly activating of the valves during the sommer periode
Hi. Older heating systems have problems with the valves getting stuck when the heating period starts. This means that I have to dismantle all the Tado thermostats and exercise the valves so that they can work again. It would be an idea, however, if Tado once a week "turns on and off" the thermostats, so that the valves…
-
Mehrere zuhause pro Account
Bitte bitte bitte, ich warte seit Jahren darauf, dass ich endlich mehrere Tados in einem Account nutzen kann. Mir
-
Meter readings
Around 18 months ago we had our electricity meter changed to a smart meter. The TADO problems that followed were : 1, it wasn’t possible to enter the meter readings for the new meter so I had to calculate how many kWh we had used that day and add it to the original meter reading. 2. This manipulation worked well until the…
-
Have an option to dim or extinguish the lights on the wireless receiver.
The LED lights on the wireless receiver are very bright in a dark room, e.g. a bedroom at night. It would be a useful feature to be able to dim or extinguish the lights on the wireless receiver.
-
Tado app to set only the tempature.
Why not create an app where you can set only the tempature. It's not handy that every app user can make changes to all settings. We could defently use it. For oure building.