-
tado API
Does tado have an API ? Where can I find the documentation ?
-
What’s the deal with feature requests?
Hello community, Many of you have expressed interest in learning more about how / whether tado° includes community feature requests in its product development process. Here’s a quick overview of how your feature requests reach tado°’s decision makers. (Please note that ‘feature requests’ refer to posts made in the…
-
The end of IOS 15 Support
Message from tado°: Hello all, The end of support of older iOS versions, as described below, was made with considerations linked to Matter/Thread protocols linked with tado° X To begin, iOS 16.4 is required by Apple for some significant improvements to Matter. (16.1 is the minimum requirement for Matter). Moreover, 16.4 is…
-
December 2024/ January 2025: Community Fibre / Linksys Router Blocking App
Hi, thermostat has been working flawlessly for 2 years+ but now I can't access the app when on local network. I can connect via 4g on phone or local WiFi with VPN. I'm using Synology router where I've made no resent changes. Any suggestions welcome. Thanks
-
Netiquette and forum rules
Dear Forum Community, This forum was created to help users solve their problems, questions, and to make the most out of their tado°. We want to keep the atmosphere constructive, so we ask that you follow these basic rules. We look forward to interesting comments, conversations, and discussions. To make sure that everyone…
-
My wireless receiver daily loses the connection to the internet bridge - why?
My Tado system has worked seemlessly for a number of years and then in the last month or so has started losing the link between the wireless receiver and the internet bridge. The result of this is that the heating ether does not come on or stays on. Each time I have to reset the receiver and then it works again for a few…
-
Installing Tado with UFH and rads
I have a system where downstairs has 5 rooms each with uFH and their own stat, where the programmer next to the boiler is on constant and UFH zones come on and off as required. This programmer also controls HW Upstairs i have 5 rooms each with Rads, but for those rads to work, the programmer next to the boiler needs to be…
-
Converting Vaillant thermostat to Tado smart thermostat
Hello, My house has a Vaillant VRT350 thermostat fixed on wall. I want to change it to a smart thermostat and found Tado to be interesting so far. Which model should I buy? Here are my requirements on the device: I want this new device to facilitate me control the desired temperature by my phone. This should "NOT" control…
-
How Does Tado X Work?
Hello, I plan to replace our Evohome system so bought some Tado X TRVs to test, via an Apple TV. I'm curious about how the TRVs actually use the Apple TV. I also have a couple of Eve Plugs. I added these to Apple Home, and they are visible in Apple Home. Tado X is different. I added the TRVs to the Tado app, and they work.…
-
All Tado X devices disconnected
Hi all, I upgraded from a Google Nest thermostat to a Tado X earlier in December and since the change I kind of had to battle with this system in a way or the other and I see in the forum I'm not the only (not sure if this is actually comforting). Anyway, after buying the second Bridge X I managed to have all the TRVs…
-
Central Heating Does Not Turn Off
I installed the system, and it worked normally for six months. This week, however, my house radiator keeps heating. I removed all cables from CH_NO, HW_NC, and HW_NO. When I tested CH_NO, it still shows 240V even after turning off the central heating in the app or through the wireless receiver (programmer). Could the…
-
Extension Kit problems - please help
Hi, We are having problems getting Tado to change temperature in the morning as follows… Recently, about 50% of the time, when the temperature change in the morning should kick in (to change from a night setting of 13 degrees to around 20 degrees in various rooms) the system does not react. Also, when this occurs the light…
-
Flightd Sparked a Thought – How Flexible Is Tado with Data?
I recently discovered Flightd, which visualizes real-time flight data, while delving deeper into smart technology. I was curious whether anyone had tried integrating such external data sources with their Tado system. Not precisely flights, but perhaps occupancy, weather, or even unique triggers? Inquisitive about what is…
-
How to contact Tado
How do you contact Tado? I'm seriously cheesed off having paid many hundreds of pounds for a Tado v3 Wireless only to find Opentherm isn't there (apparently it's been removed since the numerous videos I watched about the benefits of Tado and Opentherm!) I've submitted a request, tried the chatbot (infuriatingly useless)…
-
Bear Hunter Ninja
Ever wondered what would happen if stealth met sheer wilderness power? Enter the Bear Hunter Ninja —a myth, a legend, or maybe just the ultimate survival fantasy. Imagine a lone ninja, trained in the ancient arts of stealth and shadow, stepping into the heart of bear country, not for vengeance, but for balance. This isn’t…
-
Replace NEST Gen3 with Tado V3+
I have an old but perfectly good Bosch Greenstar R40 HE Plus Combi (UK) which has been controlled with a Nest Gen3 for a number of years but now giving problems and I can get a Tado V3+ Thermostat Wireless Starter kit for a great price. My Next Heatlink is wired directly from the boiler and the thermostat is wirelessly…
-
Need to sell
I have recieved my starter kit v3+ but I don't have WiFi so they are no good too me if anyone is interested pm me
-
Password login deprecation will break Home Assistant
It looks like Tado is removing support for password login on their API today. This will break Home Assistant. Please delay the removal.
-
What has happened following the update of the App to 8.24? Some Radiators now stuck on hot...
hi, Can anyone help here? We have just updated the App to 8.24 (the latest) and now one of our TRVs is stuck on hot. There is no effect when we adjust temperature on the app so the only way we can stop it staying hot is to switch off the whole house thermostat. It was OK until the app was updated three days ago.
-
Tado X, is "Return to Schedule" possible via the Apple ecosystem?
We tend to use voice commands to alter a room temperature if we just want a bit of a boost. With v3 and Google Assistant it was possible to set a Google Home automation to "Return to schedule" as part of a Goodnight routine to ensure no overrides were left heating empty rooms. When we switched to the Apple ecosystem Tado…
-
Confused on setup - underloor heating + radiators (TadoX)
Hi, In the middle of a house renovation and struggling to understand the setup I should be going for. House setup is as follows- - Basement = 4* radiators (and where of CV Ketel / Gas boiler is located) - Ground floor = underfloor heating throughout - 1st floor= underfloor heating throughout - 2nd floor = 4* radiators…
-
Upgrading - advice sort please.
Hi people I’m about to upgrade my heating system. To understand what I’m trying to do, I will set out my heating system now and what I’m trying to do in in the future. It might be helpful to explain my system as of when we moved in four years ago, today and hopefully the future. We live in a detached bungalow and have 9…
-
Use wired add-on smart thermostat as Wireless Temperature Sensor
Hello, I'm struggling to get hold of an add-on Wireless Temperature Sensor, and support at Tado has been anything but incapable of offering more than 2 sentences. It's been out of stock since November 2024, and I can't buy it from other retailers either. I also interested in purchasing from the Tado official site because…
-
Installation help
I’ve recently moved house, and brought our tado system with us. Always worked without missing a beat, so was excited to install in the new place. I’ve now tried to install it several time with no joy. My system is using a British Gas UP2 control unit alongside a Drayton digistat SCR and portable thermostat. I originally…
-
Wireless Temperature Sensor X - Factory Reset
I’m trying to factory reset a Wireless Temperature Sensor X following the instructions on the tado website. https://help.tado.com/en/articles/8943122-how-do-i-do-a-factory-reset-on-my-tado-x-devices I get the FR on the screen as expected but I never get the flashing “Discoverable” icon.
-
V3+ users can now request Offline Schedule
Dear community, We are happy to announce that, as part of our ongoing tiered rollout, the V3+ Offline Smart Schedule is being made available to interested tado° users via the community forum. Due to compatibility considerations, this offer is only available to community members with V3+ heating starter kits or add-on…
-
Tado V3+ wireless and Vaillant Ecotec Pro eBus install
Hey all, My installer (Aneil from A&E Plumbing) just installed the tado V3+ wireless for combi boilers with my Vaillant Ecotec Pro (from 2008) through eBus (for modulation). V3+ has native support for Vaillant eBus. After some trial and error, here's some key findings through the install process to get modulation working:…
-
Is Tado X wired compatible with my boiler?
I have an Ideal Logic Combi 35 boiler and danfoss valves for the dual zone heating in my home. I currently have two Nest thermostat E’s in the home. The receivers for these are wired where the old thermostats used to be. Would the Tado x wired thermostats be compatible with this setup? The website does not list Ideal as a…
-
Login issues with partner's invite
Hi, my partner has just got a new phone and I've sent her an invitation to join our 'home' using the Tado app, to her email address. I created a tado account for her, but when she attempts to accept the invite she is directed to options specific to setting up a new device. There is an unresponsive button for accepting an…
-
Extending my system into an area of poor reception
I have been running a Tado system for about 2 years now. I originally developed the current system from simple beginnings with just a downstairs temperature controller and a wireless receiver. I now have both upstairs and downstairs radiators separately controlled with 4 smart radiator valves upstairs and 6 smart radiator…
-
Return backbto off state after timer on manual action
With my tado v3, everytime when the heatint is turned of and someone manually turns it on , the timer does not return to the off state, but it activates the schedular again. I don't want that. How can i prevent that ?
-
Tado x question
Yesterday I bought a tado x thermostat without smart valves .I set the temperature at 20.5 When temp went to 20.4 the thermostat said that the heating is on but nothing happens ,until temperature went below 20.4 It does not seem that the thermostat has problem to turn heat on but despite it said is heating start the…
-
Anyone else having problems with radiator thermostats over heating rooms when they should be off?
As I told Tado support after emailing them over and over again about this issue and still not getting it resolved... I am interested to see if other people are experiencing the same as me. I fitted Tado radiator thermostats to all my radiators along with a room thermostat in the living room and extension kit on the boiler…
-
Nightmare user experience - failed to add a new user to our home
I sent an invite to a new user to join our home They received the email, clicked the link in the email to join our home, this took them to downloaded the tado app They created a new account but can't see our home in the app We've gone round in circles many times - they click on the link in the invite email, that takes them…
-
Tado & Worcester Bosch Greenstar 30 Cdi Classic System Boiler with internal Diverter Valve
Our Installation: Worcester Bosch Greenstar 30 CDi Classic System boiler - Installed in 2013. Control is by: LP20RF Programmer& Receiver and Digistat+RF Room Thermostat. Boiler has internal diverter valve that switches between HW and CH as required, controlled by the Programmer. Therefore no zone valves installed.…