smart AC Control: Automatic mode Selection in smart schedule (heating/cooling/dehum)

The smart schedule now requests you to set the desired working mode when in "non-thermostatic control".

Tado should be able to set the desired working mode (heating/cooling/dehum) based on the temperature reading and setpoint. A changeable dead zone (f.e. 3°K) would be needed where there would be no change in the heating/cooling mode though.

2
2 votes

Active · Last Updated

Comments

  • This is exactly what I am hoping will be available. I have a situation where temperature and humidity vary widely based on a number of factors so dynamic control would be perfect. Would definitely buy additional units.
Sign In or Register to comment.