Strange Calibration of SRT ?? 🤔
Options
GrayDav4276
âœâœâœ
I've just noticed what appears to me to be a very strange action with 1 of my SRT's.......
I had just disabled the "Notification" for an "Open Window Detected" for one of my rooms......but strangely my SRT in the room went through a "Calibration" cycle......why would the SRT need to recalibrate ?? 🤔
I then enabled the Notification.....and once again the SRT recalibrated......so I repeated the process again and the same thing happened.....WHY ?? 🤔
I can't see any reason why it needs to recalibrate just because I changed the Notification status.
What a waste of battery life.
I had just disabled the "Notification" for an "Open Window Detected" for one of my rooms......but strangely my SRT in the room went through a "Calibration" cycle......why would the SRT need to recalibrate ?? 🤔
I then enabled the Notification.....and once again the SRT recalibrated......so I repeated the process again and the same thing happened.....WHY ?? 🤔
I can't see any reason why it needs to recalibrate just because I changed the Notification status.
What a waste of battery life.
0
Comments
-
Just tested and mine did the same. Wonder if it’s to ensure the valve isn’t closed if you happen to turn off when detection is activated. You would think Tado would know the pin position though without needing this though.0
-
You may be right......but it seems stupid to me.....it's a Notification request status that's been changed......can't see any requirement for a Calibration to be done.0