Installing Tado with UFH and rads
I have a system where downstairs has 5 rooms each with uFH and their own stat, where the programmer next to the boiler is on constant and UFH zones come on and off as required. This programmer also controls HW
Upstairs i have 5 rooms each with Rads, but for those rads to work, the programmer next to the boiler needs to be on, as well as a room stat on the landing.
How do i go about replacing this with Tado?
I have wired the Tado in, but the upstairs rads dont turn on the boiler, i assumed i would replace the wall stat upstairs with a wired tado stat, which would allow he the tado radiator values to connect to that, which in turn would turn on the boiler. but it doesnt.
What else do i need to do ,is this possible with Tado?
Where in theory i could have one room in the house that has rad to call for heat, that will turn on boiler, or one room with UFH to call for heat?
I tried adding the wired stat as zone controller, but that didnt seem to work and had issue of the boiler not turning off, even though tado said it was all off
Answers
-
with some chnages by making the wired stat a zone controller and the trv use that for heating zone it fires boiler and rad gets hot, however, when turn off trv, the Tado heating goes off, but the boiler stays on
0