Home Suggestions, Ideas and Improvements

Delay before closing valves

When the setup has been reached, Tado closes immediately the valves of that zone.

Boilers normally run their pumps for a variable time, from 1 to 3 minutes, after having reached their OFF command to let the heat go out of the chamber through the radiators. This becomes noisy and obliges the user to let a radiator always open (no TRV).

Please set up a manual delay before closing the valves after the setup temp has been reached.

2
2 votes

Active · Last Updated

Comments

  • Alternatively, opening the zone valve on the hot water storage tank so that excess heat is dumped to hot water rather than over heating the house would be useful.

Sign In or Register to comment.