Anyone fit an extension kit to ideal logic heat H15 ?

Been sent the wrong instructions and awaiting new ones....i hope.

I dont some one has any for the boiler ?

Thanks

Martyn

Answers

  • [Deleted User]
    [Deleted User] | Admin
    edited December 2019

    Hello nytram,

    We have seen that you have since contacted our Support Team,

    For any further questions, please do not hesitate to contact us.

    Kind regards,

    Joey

  • Hi nytram, I fitted the extension box to an ideal h15 boiler. Hardest part was getting 4 earth wires connected. Didn't seem enough space. What programmer do you have? I had Danfoss TP9000 programmer with TS2 sensor in hall. L, N, 3 & 4 with 5 &6 disconnected and stowed as went to heat sensor in hallway.
  • Hi.

    We had a danfoss tpone -M which did water and heating and -B that was just a thermostat.

    Do you have the instructions as i currently have the extension kit on the wall instead of the -m

    Id ideally like to put the extension kit in the airing cupboard with the boiler. Did you wire it in to the danfoss wb12 connector ?

    Then i can put my extra thermostat on the wall.

    Thanks
  • Also did you do anything with opentherm to get the water temperature ?
  • Hey @nytram i have the exact same setup as you in terms of Danfoss + Ideal. Did you ever get it setup how you wanted?