-
Balance AC: "No saving times scheduled yet" error
A question for those of you that are using Balance AC. A few days ago it stopped working, showing this message: No saving times scheduled yet. Please check again tomorrow. Is this something that happens from time to time? Any other input in this?
-
Fault in Tado App heating schedule
The tado app changes our heating schedule without any input whatsoever from our side. Geofencing is off. We don’t subscribe to Auto-Assist so seemingly it’s the App that ‘s at fault. Any suggestions what we can do would be a great help.
-
Replacing ESI water programmer with Tado Receiver
Hi everyone, I've got an ESI programmer, ES2247B, which I'm replacing with a Tado Wireless Receiver. The problem is the wiring; I should have some wiring according to the instructions. In reality, it's different. Here is my current wiring The problem is that instructions tell me to put the NR 1 cable into HW NC and NR 3…
-
Replace MySon Touch RS with Tado Wired Thermostat
Hi All, i have a few myson touch RS thermostat thats hooked up an UFH system. is it possible to switch it out with the tado wired thermostats? i have tried to look up how to replace them but couldn't figure out how to do it.
-
Q re upgrade from v1 to latest version and radiator thermostats
Hi. I have the very first Tado, v1 which is not compatible with Apple or add ons. I have a very old non-combi boiler which I am in the process of upgrading to combi. Due to compatible issues and a failing battery on the v1, I’m tempted to upgrade to v3 and go with rad thermostats all around so I can can be precise on where…
-
Heating partial load/ range rating
Hi Folks, Hope you can advise. Keen to reduce usage/cut bills. How do I find the range rating on Vaillant Eco Tec pro 28? Looking to see if it's auto or should be lowered? (To what?) I'm in a top foor/2nd floor 3 bed flat all on one floor, built around 2000 and I've 10 radiators. Gas does rads and hot water and electric…
-
tado V3 not support Mitsubishi air conditioners
:'( Just replaced two Mitsubishi air conditioners for my new home, when I setting up for the new machine, tado can rec the rc signal but the apps keep saying we couldn't identify your AC model Signal detected Could not identify AC AC model : 1) Mitsubishi SRK53MWKH1 2)Mitsubishi SRK25MHIP1 Any one can help? No any reply…
-
Towel rail valve fitting.
I would like to put a thermostatic radiator valve in the bathroom towel rail. I tried an existing tado valve I have with the standard fitting. The metallic ring screws in, but the plastic bit is a bit loose. When I try to fit in the valve itself, it does not lock in as the pin sits too tall. I tried the various valve…
-
Wiring for baxi 800 with LP722
Hi, I have a baxi 800 boiler with a Drayton LP722 controller and a Honeywell T6360B thermostat. I followed the instructions inside to tado app to replace the LP722 controller and everything seems to start up ok but my heating does not seem to work at all. I'm now not sure if I should've followed the instructions for LP722…
-
Energy IQ not generating consumption.
Hi I've installed 4 wired thermostats to the 4 underfloor heating zones and 1 wired thermostat to the upstairs where I have radiators. I've also installed 6x tado TRVs and all working fine. Only issue I have is the energy IQ does not load any consumption data even after 24hrs, I've put my tariff in and meter readings but…
-
2 zone problems
Hi people. Wonder if anyone can please help? Im going of my nut. I have a 2 zone we'll call house amd room, room is just 1 radiator and house is lots. The house works with all trv's and the little white thing you plug into the router and the thermostat that replaces the house one. The room is just a trv and is governed by…
-
TRV Showing Incorrect Temperature
I woke up a few days ago with the heat very high in the main room. The thermostat was reading 17 degrees even though the room was about 25. I tried resetting by removing the batteries but had the same issue. I contacted support and did not get a response but I suspect they did a remote reset because I had a strange error…
-
Moving from Nest Thermostat to Tado Wireless Thermostat [UK]
Currently have Nest Thermostat, and installed Tado Smart TRVs late last year. I want to move my Nest thermostat to a wireless Tado Thermostat, instead of having to turn on Nest Thermostat in order to control the TRVs separately. Before transitioning from a Nest Thermostat to a Tado Thermostat, I'd like to understand any…
-
Radiator thermostat moving the valve pin in/out?
Hi I'm new in tado. I started to mount bridge, pairing main thermostat and for the start mounted two radiator thermostats. Everything looks fine, thermostats did a calibration, when i connected to my FAR thermostatic valves. OK, my boiler is off , main tado wired thermostat is not yet connected. But when i changing…
-
Hysterese afstelling
Kan iemand mij vertellen wat de Hysterese afstelling is,en of ik deze kan aanpassen?
-
Will tado work for my house?
I don’t know anything about heating systems. But my goal is managing the temperature of each room separately, make it comfortable and save money. I have Eneco district heat with Honeywell chronotherm IV in my leaving room. My house has 2 floors and 7 radiators (normal ones not floor). 1st floor 3 radiators - 2 in the…
-
No Heat! How do I fix it?
Hi All, I had someone install my tado v3 kit a few days ago. I have since found I have hot water but no heating. The App says it's on, and the light on the wireless reciever is on, but the pump in not pumping and the boiler is not firing. I have attached a picture of the current wiring. Can anybody tell me if this has been…
-
Starter kits
Just to confirm this is still correct with wireless starter kits at this time. uk version with weather comp euro version with open therm Thanks
-
Temperature change
Hi, I have my Tado set to a schedule but i have noticed the temperature goes up from the set temperature in a couple of rooms and I need to press the schedule button to re set !
-
Hot water just turns itself off when using Alexa
I use Alexa voice control to turn the hot water on, but I'm finding sometimes it will stay on for an hour or longer, other times it will randomly turn itself back off after only 10 mins. I don't have any schedules or time blocks set and I've tried it on both home and away modes and still have the problem. Hoping someone…
-
Underfloor and radiators system
Hi, I am looking for some help on which Tado products I need for my heating system... I have a gravity fed Y plan system with 1 zone underfloor heating downstairs in our kitchen/diner and the rest of the house on radiators. I would like to control the underfloor separately to the rest of the house, how do I go about this?…
-
Best setup for central heating from building
Hi, I’m new to this topic and would appreciate help in selecting best setup. Many thanks in advance!! Setup - I live in a building with communal heating (central boiler runs 10-22hrs, I cannot control it) - heating reaches my apartment through a main valve at the entrance, which is controlled by a radio “dumb” thermostat -…
-
Heating not going off
I have just fit the tado V3+ starter kit to my glow worm ultimate 3 30c combi I have got everything paired up as per instructions but the heating will not turn off even though the heating indicter on the receiver is off. I have noticed the Htg symbol on my boiler display flashing which it does when a Htg demand is req.…
-
Tado TRV Brass Colours
I hope someone can help. We are doing a big renovation and will have polished brass radiator valve housings. We’re happy to replace the tops with our existing Tados but that little silver thread that connects it to the body of the TRV is so annoying. Anyone had any luck replacing these with brass ones? Or any other smart…
-
How to add wireless temp sensor to hot water control
I had a working system for a few years then my wireless temperature sensor seemed to die. So I replaced it with a new one. I can't figure out how to add it to the hot water control. It now only shows the main box where it also displayed my previous wireless temp sensor which I've now removed from my setup. Hot water had…
-
Warum funktioniert bei mir in der App der Button für die Zeitplan Programmierung nicht?
Ich habe heute die App installiert und 3 neue Heizkörperthermostate angebracht und ebenfalls installiert. Die Thermostate funktionieren und ich kann diese auch in der App steuern , aber die Zeitprogrammierung kann ich nicht öffnen. Der dafür vorgesehene Button reagiert nicht. Was mache ich falsch?
-
Two boilers, two protocols, two thermostats?
So... I'm looking into replacing my current Nest thermostat with Tado. Our situation is as follows: Old part of the house: 8 radiators, wired thermostat on boiler one (opentherm). New part of the house: Floor heating, no thermostat yet on boiler two (EMS). Now I was thinking of getting the following, but I'm not sure this…
-
Changed boiler now Tado won’t communicate
I recently changed my boiler and moved to a new position. Tado receiver has not moved. Trying to re wire the new boiler back in and tado receiver is not turning heating on or off. The receiver clicks and lights up when I use the app but the boiler does not respond Could someone one help confirm that I have the wiring…
-
Issues with Tado keeping valves closed this season?
Hello, I have been using tado sind september 2022. The overall use of the system in that season was satisfying. However, since I started the system last Sunday, I have noticed weird behaviour of the system. First indicator was looking at the „Energy IQ“ module of the app. There I could see the predicted costs have reached…
-
Replace Danfoss RX2C and Danfoss FP715Si
I have a Danfoss RX2C with a wireless room thermostat and a hot water thermostat. These are all linked to a Danfoss FP715Si controller. I recently purchased a Tado V3+ starter kit and in the instructions for the Wireless Receiver I can select either the FP715Si controller or the RX2C, but as far as I know these 2 do not…