-
Need an installer in Glasgow area
I am not good at diy. So looking for heating engineer? in the Glasgow area. Also what would the price be? Ideal combo boiler and wireless thermostat. Got the tado free from ovo due to energy crisis
-
Offline Schedule Storage
I note a thread from 2019 where many users enthusiastically wanted some form of offline schedule capability but I have seen no response from TADO and no such feature. The Uk ( and possibly Europe too) faces the real possibility of recurring power cuts this winter which, among other things, will highlight the deficiency in…
-
Wallplate for wall-mounted radiator valve
Hello all. I am migrating all of my radiator valves to Tado smart radiator valves. And I've run into a minor issue. I have a radiator installed in the floor with a vent to heat my dining room area. The radiator valve for this heating is installed in the wall. And there is a wallplate (similar to what you would use for a…
-
Connect Tado Extension Kit to Thermomotor
Hi, I would like to setup an Tado extension kit to a Roth termomotor (which is not officially supported by Tado) The Roth thermomotor is a simple on/off device that expand/shrink when a 24v (1w) signal is on/off. As far as I can read from the manuals, I have to use the low voltage relay interfaces: A and + in a potential…
-
Cost per kwh
The price per kwh on the energy IQ widget differs by my tariff price set in the app by quite a bit. Is this correct?
-
Rads heating on their own
so I have just tried to turn on the heating in one room, the TRV is connected in the app but has some blinking lines on the TRV, turned on in the app but it didnt call the boiler, I guess there is a communication issue between the TRV and the network interface and for some other reason the app isnt sending/updating I also…
-
Bosch Condens 5000W
Does anyone know how to hook up the tado wireless thermostat to this boiler type ? Service desk says its compatible. Appreciate your help in advance
-
Manual control knob problems
VA01 Smart Radiator Thermostats I have 4 of this in my home. I have next problem: When I turn the manual control rosette to the right, the temperature drops from 25 to off When I turn the manual control rosette to the left, the temperature rise from off to 25 Three have this problems and one no. It is normal this problem?
-
Keep getting 'Accessory Already Added' error, when trying to add Smart AC to HomeKit
The Smart AC Control is not in HomeKit anymore. I have removed it also from Tado Home and reset it to factor setting several times, but to no avail. Even removed and created a new home in HomeKit, but that didn't help either. Also, changed my Wi-Fi to 2.4GHz as instructed. Nothing seems to help. What's up?
-
AC app timeblocks
Hi. I'm using a Tado AC control on a bedroom AC unit that I want to run from 11pm to 7am. I can't find a way to organise the timeblocks to do this without a break at 12am. The problem is the AC unit does a beep at the change at midnight which wakes me up. Is there a way to organise the timeblocks without a break at…
-
Ecodan heats water only to 39C with heat pump in warm weather
My Ecodan only heats the DHW (Domestic Hot Water - in the boiler) to 39C by using the heat pump while it is 30C outside. I have to use the immersion heater (= pure electric) to increase the temperature further!? My installer tells me that this is normal, because heat pumps are designed/optimized to work in moderate…
-
Instructions for AC Control V3 touch pad?
Are there any specific instructions on how to use the touch pad? It’s the middle of winter here and 80% of the time when I turn on the heat pump from the touch pad it goes to COOL mode. Sometimes if I go off and on again a few times it’ll turn to HEAT which is what I want. But I can’t figure out how to reliably do this? Am…
-
Welcome! I'm trying to set up my Gree Comfort X climate with a Tado Smart AC V3, but for some reason
Welcome! I'm trying to set up my Gree Comfort X climate with a Tado Smart AC V3, but for some reason after sensing the remote, it says the climate is unrecognizable. What could be the problem? Maybe the climate is not compatible with the device?
-
Clicking Smart Thermostat
Hi Folks Wondering if anyone else has noticed this behaviour? My system is made up of extension kit, wired smart thermostat and a number of Smart TRVs. The extension kit turns on/off the heating so the relay in the smart thermostat should always be closed However, I occasionally hear the smart thermostat click rapidly for…
-
Would Tado connected to Junkers CG2200W BUS ever work?
Hi! Are there any chances for tado software to support digitally the above mentioned boiler? The available relay mode is the least energy saving solution of all and not very environmentally friendly. This is a modern boiler using hysteresis to control the flame, allowing to use it for the most of time at minimal available…
-
Is my installation correct? Heating not turning on!
Hi, I have installed my tado kit last night. However the CH is not turning on when calling for heat. Can someone advise me if my installation is correct please? For reference my set up is two radiator zones with two thermostats (upstairs zone and downstairs zone) hot water tank (unvented)
-
Tado resuming schedule at midnight
Since the start of Spring, I’ve had my thermostats set to off (frost protection). I’ve done this with the slider in the app and set it to stay off until I resume schedule. The upstairs thermostat seems to have a mind of its own - staying off for days but then randomly resuming schedule at midnight. The heating then kicks…
-
Wired thermostat live switch for UFH connection to boiler
Hey! I have set up a wired thermostat as a live switch for 2 mechanical thermostatic valves that control the flow of the UFH. With the wired thermostat set as a separate heat zone, it controls the valves just fine but it doesn't know how to communicate with the "main" thermostat to request heat from the boiler. If I change…
-
Cuando abro el agua caliente se enciende la calefacción.
Tengo una saunier Duval isofast F 30 E H-MOD. He comprobado que cuando abro el agua caliente, al poco tiempo empieza a perder temperatura el agua sanitaria. Y comienzan a calentarse los radiadores. Pensaba que podía ser una avería de la válvula de 3 vías. Pero si quito Tado y dejó el mando de la caldera funciona…
-
Adding hot water control
I bought a Smart Thermostat Starter Kit - v3 and several smart radiator thermostats back in 2018. It's worked well for the heating but we've never been able to control the hot water separately from the heating as we don't have a three way valve to enable that. However, we're now looking into getting a completely new tank…
-
2 homes connection
Hi I have brought 2 of the starter kits 1 for home and 1 for our static caravan the one at home works fine but the one in the van just will not connect it all seems to pair up but that's it any ideas or do I need 2 phones to connect the 2 systems thanks in advance.....
-
Wireless sensor set to measuring device in a room with no zone controller still activates the zone
I am intending to control a bathroom's ufh by replacing the original wired thermostat/timer (on the outside wall of the bathroom with a remote wired sensor inside the bathroom) with a TADO wired thermostat combined with a wireless TADO sensor inside the bathroom. I'm trying this out first by using the Kitchen TADO wired…
-
How do I re-link my Hot Water connection?
Due to Storm Eunice I lost my internet connection and ran the the Tado system via manual control on the extension kit. Internet connection is back up and running and everything is working as per schedules EXCEPT my hot water. I can’t seem to control the hot water via app. What do I do?
-
Two AC units in same room
Hi We have two AC units in the same room (its a large open office). Both are set to the setting. We want to connect both AC units to one Tado Smart AC Controller. Effectively we want to set a schedule where both come on at the same time and then both at the same time, with the same settings. Is this possible and if so how?
-
Poor reliability
I have constant issues with my system not behaving correctly. At the moment, hot water seems to be working according to the schedule, but the heating is not coming on, either manually or on schedule. I have reset the wireless receiver and the internet bridge, to no avail. I have checked the boiler and it appears to be in…
-
"More than one device" when using Alexa to set temps.
Anyone else come across this? It's driving me mad! I have smart thermostats in most rooms and I used to be able to say "Set the hall to 18 degrees" and that's what happened. Now Alexa complains that "i found more than one device called 'hall'. Give them unique names and run discovery again". When I log into…
-
Wirder Smart Thermostat, screen is not working?
Istalled just two wired smart thermostats, the first one can show "hi!" and reacts when replacing batteries. I tested also with new batteries. It does not respond anything I try to do manually. Not, if i press button shortly, 3sec, 5sec, 10sec or even 30sec. From app it works, but not from thermostat itself? Is there a…
-
Use Tado with shunt valve steering
Hello I am trying to validate if my Tado wired thermostat will be compatible with my setup. I have geothermal heating heating water in a accumulator to a predefined value, on the tank there is a motorized shunt valve that can be controlled via either outdoor sensor with curve steering or via an indoor thermostat. Currently…
-
Connect via controller
Hi all - I want to connect my Tado wireless stat, via extension to my Horstmann Centaurplus Cll timer/controller (connected to Vaillant combi boiler). Does anyone know the wiring for this. please? Thanks, Chris.
-
Using Tado with Daikin air source heat pump.
I have replaced an old oil-fired boiler with a Daikin air source heat pump. However, the heat pump is objecting to the short on-off cycles that low and medium heat demands are calling for. High heat is fine. I’m told that the minimum on time and repeat time can be set by Tado, but I’m not sure what values to request. I…