Ich würde gerne in meinem Bad ein weiteres Tado Thermostat installieren. Aufgrund eines Platzploblems mit der seitlichen Duchabtrennung kann ich das Thermostat nur komplett montieren. Ich kann also nicht mehr die Kappe abziehen und das Batteriefach öffnen, um die Adaption zu starten. Gibt es hier für eine alternative Lösung. Ich denke z. Bsp. daran die Adaption über die App zu starten(sicherlich nicht so schnell machbar).
Please add MON-THU, FRI, SAT, SUN as groupings as most people who work need to get up and go to bed at the same times MON-THU but probably stay up later on FRI, get up and stay up later on SAT and get up later but go to bed earlier on SUN.
Also, please make it possible to copy settings from one day to another day. With the copy feature in place the day grouping would be less relevant.
You should be able to save multiple sets of schedules and then switch between them easily; for example, you could have one schedule when you and your partner are both at work, then one if you're at home (day off, sick, ...), another when your partner is at home, and another if both are at home; even better would be if you could link each set to the presence of you or your partner in order to switch between the sets automatically; however, one should still be able to switch manually.
Why do I have to go into a room to see the humidity? There’s enough space on each room tile to add the humidity figure.
Once you selected a room you should be able to just swipe to the next room but have to come out of the room to go back to the home screen and then select the next room; this is rather cumbersome and was much easier in the pre-v3+ app
Please allow us to change order of tiles in the v3+ app; in the pre-v3+ app we used to be able to change the order of the room stripes.
Weil, bin Schichtarbeiter.
Als mijn dochter uit huis gaat, maar moeder thuis is zou ik graag willen dat de knop van haar kamer toch naar beneden gaat. Zodat je per persoon ook nog kan besparen.
Problem: old leaky house that is unable to retain heat, potentially with mixed heating modes.
Second problem. How to make best use of a boiler firing when zone is not expecting it.
Solution: introduce 2 new modes for Smart TRVs - Passive and Passive Limited.
The idea would be that (for example on a cold night) the TRV would move to a passive mode. This would set the TRV to full open and in the case that another heating zone called for heat, then this TRV would benefit from the heat too. This is for bedrooms where there are several cold rooms but one that needs to stay at a steady temp (baby room) but the other kids rooms would benefit from the heat too.
In a passive (limited) mode, then the behaviour would be the same except that it would cap the temperature of the room. The trv would stay open until a specific temperature was reached and it would then close. This is essentially the same as a normal TRV.
Again this would be for bedrooms.
These passive behaviours would particularly benefit houses with mixed underfloor and radiator heating where the ufh needs to be on several hours before the radiators, but once the boiler is on, it may as well pump hot water to the radiators too, but the heating wouldn’t be on otherwise.