Vroege Start met lagere aanvoertemperatuur (efficiënter)

Sinds kort heb ik een Atag i28ECZ ketel waarbij ik een Atag ONE thermostaat heb gekregen. In de handleiding [1] zie ik het volgende:

In the ONE you can put in a time schedule by using a smartphone or tablet (android or iOS). The preheat takes care of the fact that the room temperature set-point is reached for the selected time schedule. It does this in the most efficient way, so it will take a while before the temperature is reached because the ONE will try and do this with a low as possible flow water temperature.

In short; the max preheat is the number of hours you allow the boiler to start heating up the property to the room temperature set-point before the selected time of the scheduled program.

The preheat function will calculate from the past 10 days on when the boiler needs to start. From initial installation it needs 10 days to learn the suitable heating up time. After the initial 10 days it is a rolling 10 day calculation.

[The] boiler starts a maximum of [1/2/3/auto] hours before the timed schedule setting and will calculate the lowest flow water temperature to achieve the room temperature set-point within the set time limit.

Het zou natuurlijk geweldig zijn als Tado hetzelfde zou doen. Tado kan nu al leren hoe vroeg er begonnen moet worden voor een "Vroege Start", waarom niet meteen kijken of dat binnen acceptabele tijd bereikt kan worden met een lagere aanvoertemperatuur? Dat bespaart stookkosten en komt de levensduur van de ketel ook nog eens ten goede. Tado heeft daarbij beschikking over de buitentemperatuur en de geleerde eigenschappen van de ruimte en het verwarmingssysteem. Tijdens het opwarmen kan het zonodig worden bijgesteld.

Wat ik nu zie is dat de Tado altijd opwarmt op 100% (Care & Protect -> Verwarmingsactiviteit -> Verwarmt momenteel 100%) en pas later terugschakelt naar lagere percentages (vaak zelfs te laat, waardoor de vraagtemperatuur wordt overschreden). Vanuit de fabriek stond het maximum bij mij op 85°C, wat veel te hoog is voor efficiënt stoken en voor mijn huis ook niet nodig is. Van mij mag Tado er 's ochtends best iets langer over doen als dat de efficiëntie ten goede komt.

[1] https://cdn2.hubspot.net/hubfs/6255552/App-Portal-UserGuide-One-GB-v171116.pdf

5
5 stemmen

Active · Laatst bijgewerkt