S-plan system: hot water LED on when only heating required?

I've got a tado system with wireless receiver. My heating system is an S-plan. When I program tado to only make hot water for the hot water tank, the right valve opens and the valve for the heating system stays shut. However, when I program tado to only deliver heat and no hot water, both valves are open + both LEDs. If I had somehow wired the system incorrectly, I can see how both valves might open up even though I only call for heat., but the LEDs are both lit, so although I'm not requesting hot water, the wireless receiver is nevertheless calling for it when I only call for heat.

Any suggestions as to what might be wrong?

Answers

  • Sounds like it’s set up for a gravity feed system. Look at section 6 to change the configuration

    https://cdn.brandfolder.io/607DGEMS/as/tqh86npbjjhws5gwkxfncbfh/104172-DIGITAL-WRP01IB01-INSTALLER_MANUAL-TA-UK-00-V2.pdf