Controlling UFH main flow using tado radiator valve

Options
Athanassiadis
Athanassiadis ✭
in General Questions & Topics
Hey tado friends,

I have tado set up in all rooms with radiators and then underfloor heating downstairs. However the UFH is not running as smooth as I hoped. The valve that control warm water flow into the UFH is a dumb knob which I have to set manually.

My idea was to set a tado knob on that valve and then sync it with tado thermostat in the living room.

I haven’t seen anyone here doing that so wonder if that is a known bad idea?

Comments

  • mojomoomoo
    mojomoomoo ✭
    Options
    I tried it recently, it worked just about. It didn't open enough to allow correct flow.
    Tado should do a wirless actuator for this
    The correct way is to have an actuator for each zone controlled by a wired thermostat.

Categories