Replace Danfloss setup with Tado
Hi,
I've a Danfloss CP/FP715 along with two manual thermostats.
The Amazon deal of the day is this:
Deal of the day: tado° Wireless Smart Thermostat Starter Kit V3+ Incl. Stand – Full Control Over Your Boiler And Hot Water From Anywhere, Save Energy, Easy DIY Installation - Works With Amazon Alexa, Siri, and Google https://amzn.eu/d/2MV2aOL
Can I use these? I've no experience in this so is it difficult and will it include instructions? Can I remove the wired thermostats and just put a blank plate over the gap?
This question has probably been asked lots so sorry for the repetition.
I will buy another thermostat on top of the above as well.
Thank you
I've a Danfloss CP/FP715 along with two manual thermostats.
The Amazon deal of the day is this:
Deal of the day: tado° Wireless Smart Thermostat Starter Kit V3+ Incl. Stand – Full Control Over Your Boiler And Hot Water From Anywhere, Save Energy, Easy DIY Installation - Works With Amazon Alexa, Siri, and Google https://amzn.eu/d/2MV2aOL
Can I use these? I've no experience in this so is it difficult and will it include instructions? Can I remove the wired thermostats and just put a blank plate over the gap?
This question has probably been asked lots so sorry for the repetition.
I will buy another thermostat on top of the above as well.
Thank you
0
Answers
-
Dead easy to install, just make sure the app guides you through the correct installation as it thought I had something else, not FP715. It should look like this: so connect CH and HW ON and bridge COMs. Thermostat has two wires which you just bridge with a clip provided by tado, providing it is an on/off set up. I assume you do not have a modulating boiler and have a hot water cylinder. All is working well for nearly a year now!
1
