Using Wired Stat Wirelessly

DM932187 · June 7

I'm thinking of adding another room stat to my set up. I could obviously use a wireless sensor, but does anyone happen to know whether the wired room stat, when not used as the zone controller (but merely as a sensor with the zone controller being the existing wireless receiver), still 'relay clicks' on and off, or is it silent? Cheers

samd · June 8

I have both including a wired used as a zone controller and I have never heard it click - sorry!

DM932187 · June 8

Thanks @samd. Is the wired stat connected wirelessly or hard wired?

samd · June 8

@DM932 It is hard wired.

DM932187 · June 8

Thanks again @samd. So you don’t think the wired audibly clicks? Is that the device switching the boiler? Is it perhaps set up to modulate the boiler rather than on/off?

Unknown · June 8

This content has been removed.

samd · June 9

My apologies! I had to go and stand next to it and activate it to hear it. It does click but about as loud as a mouse eating cheese!! Had the system years and never noticed it - sorry.

DM932187 · June 13

Thanks for your comments. I’ve since read here that these wired stats can be configured to work as wireless sensors - anyone know if that deactivates the onboard relay (so makes them silent like the wireless sensors)?

DM932187 · June 14

The answer is no, it does not click when in wireless sensor mode.

Using Wired Stat Wirelessly

Answers

Categories