HERMANN SPAZIOZERO 4 CONDENSIG EBUS
I have had a new Hermann Spaziozero 4 condensing boiler installed. It uses Vaillant's eBus bus. So I reset my Tado V3+ using the ebus with code D07. The boiler makes hot water correctly and turns on the heaters. wanting to check the Tado settings on the Max Flow Temperature in modulation, either from your site or from the tado installer appa by entering the bridge data, the system reports that it is not compatible. but instead everything is working. i just want to be sure that the temperature does not rise above a limit because condensing boilers have to have a lower temperature.
Am I forced to configure it in RT without modulation or actually can it run in bus
Translated with www.DeepL.com/Translator (free version)
0