Active

Scheduled "Call for heat"
atm we have the option to enable or disable a zone controller, and this stops the room calling for heat from the boiler. But, I think due to the cost of living crisis around the world atm, it would be a good option if Tado˚ could move this option to the Scheduling screen. My idea would be for each time block in the…
Feature to turn off LEDs Internet Bridge
I like to have the availability to turn off the LEDs Internet Bridge.
Entering your Energy IQ tariff with pence not pounds
Recording tariffs in the UK would be much more accurate if the app allowed pence/kWh rather than pounds/kWh???
Internet bridge improvements
Any chance you could add the ability to use two different internet bridges on the same account as I can only position mine at one side of my house or the other and it occasionally leads to loss of signal at some of my thermostats. Either that or create a new internet bridge with a stronger signal so that it reaches farther…
Add 'Cubic Feet' to Measurement Units
I have figured out the main reason why the EnergyIQ does not work for UK users without a smart meter - the older style gas meters are imperial units, and the readings are in cubic feet, not cubic meters. Are you able to add this as a measurement unit on the app alongside cubic meters and kWh?
EnergyIQ - Display volume-based monthly forecast
In my opinion, a volume-based metric is more suitable because it is a consistent metric. Volume indication is not subject to change when energy prices/ contracts/ taxes change. Therefore, I suggest showing it alongside the "expected monthly heating cost". Or even better - change it along with the [€ | m3] toggle next to…
Combineren van (actieve) Tado Smart Thermostaat en (passieve) Ventilatieroosters
Ben erg happy met Tado Thermostaat en Smart Radiatorknoppen. Ik vroeg met af of het nuttig zou zijn om ook de ventilatieroosters op ramen en deuren automatisch open en dicht te schuiven. Bijvoorbeeld als radiator op uit dan ventilatie rooster automatisch open, en als radiator aan het ventilatierooster dicht tenzij bepaalde…
ZAPIER integration ?
Hello. Does anybody know if TADO will be allowing ZAPIER integration ? This would obviously allow TADO to be controlled by many devices on ZAPIERS list and also allow many scenarios to be played out.
Gestione di più abitazioni con la stessa APP tado°
Mi è stato chiesto dal servizio clienti di tado° di postare la mia richiesta tecnica in questo forum, visto un mio problema irrisolto. Sarebbe utile (almeno per me) poter gestire con la stessa APP tado° più abitazioni cosa oggi possibile soltanto creando un nuovo utente e gestendo una abitazione con la APP e l’altra da…
In App Firmware Update Notification
It would be good if there was something in the App to suggest a firmware update is being performed on a Tado device. Just spent 30 minutes troubleshooting why all my SRT's were reporting 'No Remote Access' and were not communicating with the Extension Kit. After rebooting the Extension Kit & Internet Bridge it turned out…
SET to a VALUE (MIN or MAX)
Hi, One important feature is missing on the app. All the settings are related to the temperature measured by device. There is no selection for "FULL OPEN" or "FULL CLOSE" what sometimes we need to. I have Vaillant Boiler with Vaillant eRelax Room Termostat. While i'm using it together with tado on my all radiators, there…
Programmation "simple"
Bonjour Serait-il possible, plutôt que d'utiliser votre programmation intelligente qui est une véritable "usine à gaz" a programmer de pouvoir simplement démarrer et arrêter a une heure dite tout simplement !! Début à: , Fin à:, Froid ou Chaud, Température et c'est tout ! Merci d'un retour PS J'ai eu plusieurs échanges…
Provide configurable option for TRV to be a zone controller
I have noticed that in Energy IQ certain rooms consume more energy than others with Bathrooms, and Kitchen being higher on the list. Although these rooms are smaller, it is clear that the temp drops quicker due to ventilation and extractor fans. As such these TRV's switch on and call for heat at times that the boiler would…
Add new "Consumption" menu to web interface
Hello there, Please add new "Energy IQ" Consumption menu to web interface. It only available on the app (i dont know, why...) It more comfortable that see it in web interface
[Feature Request] Notify when room temperature drops below set room temperature
I have noticed few times that heating won’t start when water pressure is the boiler is low, it will be useful to know that there is an issue with heating and not wait for couples of hours to realise it.
Return to schedule in Alexa
Through Alexa routines I can use my Hue remote to turn up the heating in the room when I turn the light on which is great. But the only option is to turn the heating off or to a set temperature when I turn the light off. Would be useful if one of the options was return to schedule.

Active

Discussion List