Tado and Heatmiser UH4
I am in the process of extending my Tado setup to include the underfloor heating zone we have in one room. Currently that is still controlled by an old Dataterm multi zone system. So I have a bit of a complex wiring set up, and I can't control the UFH from Tado. So I installed a wired Tado thermostat and ran a cable back to the controllers. Not connected yet, but here is my diagram how to use a Heatmiser UH4 wiring centre attached to the Tado receiver. This might be of interest to anyone trying to do the same.
0