Hot water issue
I have a Worcester Heatslave 15/19. It's old and requires the heating to temporarily stop powering to allow the water to heat up.
Since installing Tado V3 I rarely get hot water.
I think the Tado system is not allowing the boiler to shut off the heating to power the hot water.
How do I fix this?
Since installing Tado V3 I rarely get hot water.
I think the Tado system is not allowing the boiler to shut off the heating to power the hot water.
How do I fix this?
0
Comments
-
@smeetoo Hello. For users to help, can you provide details of which Tado products you have installed and which programmer/timer/thermostat they replaced? How has the Tado product been wired into the boiler? Pictures would be helpful.
0 -
Tado V3 internet bridge, wireless receiver and wireless thermostat.
Replaced Danfoss pictured (if i can find how to upload picture).
Wired in exactly as instructions suggest.
I thought the issue was that the boiler cannot supply water if there is a heating draw…and Tado isn't smart enough to stop the heating when there is a demand for water. However, I turned off the heating and my water was still cold.
On a spam block, will upload photo when I'm allowed in 600 seconds!!0 -
previous controller.
0
