How to connect?

Hi,

Currently i have a Nest V3 connected and want to replace it with a Tado. See attached info for how the Nest is connected.

If i connect the T1/T2 red/blue wire to Tado on COM/NC it should work right?

Regards,

Dennis

Best Answer

Answers

  • samd
    samd ✭✭✭
    edited February 2020

    @DennusB I had the Nest bridge in my set up so was slightly different but finished up with t1/t2 wired to NO/COM not NC/com. Have you not received full wiring instructions from support?

  • @samd Thanks. I haven't received any full wiring instructions from support actually. I was trying to fix it myself haha.

  • samd
    samd ✭✭✭

    @DennusB No probs - good luck, ask away if any help needed - there are some experts on here!

  • @samd thanks! Just checked and it’s now connected to COM and NO as said by you. Is there an easy way to check if this works?
  • Hi
    I am looking at exactly same swap?
    Did you connect wire from 2 and 3 to COM and NO?
    That's it? What about the cable positive and Negative in the nest. Shall I not connect these in TADO?