-
Tado x smart thermostat and Junkers boiler
Hi everyone, I have a Junkers boiler and a Fw120 thermostat that I want to change for a tado x smart wired thermostat that I just bought. My Fw120 thermostat has b1 and b4 wires connected, also a b2 wire not connected. Do you know where those wires from the boiler should be plugged on the tado x smart thermostat? I tried…
-
time to send the order from the app
Hi! I have a tado X thermostat and when I use the app to turn on the boiler, it takes about 1 minute to send the signal. It's normal? It takes a minute to turn off too
-
Daikin Heat Pump Compatibility
I am looking for a smart home heating solution and contacted support to assess compatibility for Tado X which states it accommodates under floor systems. Support informed me that Tado X is not compatible with Daikin Altherma R F - EHVH-CB and Daikin ERLQ006CAV3. I would suggest adding compatibility as this is a widely…
-
Tado X add to current Home with V3 versions
If you already have several Tado V3 TVRs if you purchase an additional New TVR X & the new X Bridge do they get added to the same home as the current Tado v3s or does the app create a 2nd Home? I would like all my Tado devices to show upmon the same Home screen?
-
Tado X suggestions
(I originally messaged this direct to Tado but they asked me to repost it here.) I have read that currently your Tado X heat pump controller supports only some makes of ASHP as of yet but based on customer requests you will add more. I am therefore contacting you to suggest both Samsung Mono HT Quiet, and Daikin Altherma 3…
-
Tado X installation help
Hello my dear Tado Community, I am facing some challenges while installing my Tado X smart thermostat. I currently have the following Thermostat at my place. Posting some photos oh how my valve looks like. I am unable to mount the smart X thermostat by using any of the adapters provided in the box. Can anyone help me in…
-
Merged: Manage more than only one home-house in one/each account
This discussion has been merged.
-
Can I use tado thermostat X for heating control and my existing wired programmer for hot water?
Hi all, I am considering to get into this while preparing a baby room and would like more control. I have a relatively simple deployment of one heating zone and one hot water. My current thinking is to just remove the existing wired/dumb thermostat, install the thermostat X, install radiator thermostats to my 8 radiators…