w.Intercom = i;[Feature Request] Notify when room temperature drops below set room temperature — tado° Community

[Feature Request] Notify when room temperature drops below set room temperature

Nisheeth
Nisheeth
edited December 2021 in Suggestions, Ideas and Improvements
I have noticed few times that heating won’t start when water pressure is the boiler is low, it will be useful to know that there is an issue with heating and not wait for couples of hours to realise it.
5
Up
5 votes

Active · Last Updated

Comments

  • MarkDim
    MarkDim
    I have has the same issue, the ther side of this is that, when it looks like the heating is on, although no heating is actually working it can skew the energy iq figures.
    Maybe there could be a way of adjusting the input figures manually.
  • Unknown
    Unknown
    This content has been removed.
  • Montage
    Montage

    Look for a non-Tado solution.

  • Phillip_PAL
    Phillip_PAL ✭✭
    edited February 2023
    I thought this is what 'care and protect' would do, but it always states 'no incidents detected'.

    Discovered that after a power cut the combi boiler doesn't provide heating unless you wake up the tado wired remote first - digital connection, didn't have this problem when it was powered separately and configured for relay.

    Similarly had an old valve fail under the tado TRV - both temp and humidity rocketed skywards but care and protect oblivious to the abnormal swing of readings.
  • Unknown
    Unknown
    This content has been removed.

Categories