Night mode for wireless receiver (no lights)
We have installed the wireless receiver in our son's room replacing the previous controller that was placed there. Everything works fine but at night the lights are like so:
We need a blackout room for our son to sleep (he is nearly 2 years old) and these lights unfortunately keep him awake.
A feature I would like is to be able to put the receiver into "night mode" where the lights do not shine and blink. And to be able to put it on a schedule so I can say night mode from 2000-0700 and during other times it behaves normally with the lights.
Comments
-
Is your boiler also in your son's room ??🤔
The Wireless Receiver is normally placed very close to the boiler......tado° only supply a 30cm cable.0 -
-
@rafm5
Duplicate.....?? 🤔
Wireless Receiver does not equal Internet Bridge........ 🙄0 -
@GrayDav4276 Well said, not sure where I did get the internet bridge from.
¯\\\_(ツ)\_/¯
0 -
Hey @rafm5
Read twice before replying.... 😎1 -
I'm just going to put a blackout cloth over the receiver which can easily be moved up to see the lights when needed and left on top to block the lights as well. £3.99 for a metre from ebay. Probably an easier solution.
1 -
@vab
Sometimes the simplest solutions are the best 👍1