Room no longer getting up to temperature
Before Christmas I installed a wireless Tado thermostat to control the whole house. It worked fine but I wanted to be able to control the bedrooms separately so I don't heat them during the daytime.
To do this I bought four smart TRVs to fit on the upstairs bedroom radiators. Since fitting these I've found the system not working as expected. The downstairs being controlled by the thermostat never seems to reach the target temperature and sometimes doesn't come on at all unless I boost the whole system.
I can't work out where I've gone wrong with it.
To do this I bought four smart TRVs to fit on the upstairs bedroom radiators. Since fitting these I've found the system not working as expected. The downstairs being controlled by the thermostat never seems to reach the target temperature and sometimes doesn't come on at all unless I boost the whole system.
I can't work out where I've gone wrong with it.
Tagged:
0
Answers
-
Is the downstairs wireless temperature sensor setup on its own separate room?
You may wish to reboot all the upstairs TRV’s by removing batteries in each for a few seconds, then power them back up, if there is a sync issue with one the TRV’s, it could clear it up and new configuration downloaded to the TRV.
0 -
Thanks for the response. This morning I removed all of the TRVs and deleted the rooms. The thermostat then seemed to work correctly heating the downstairs.
I'm now going to install each TRV and test them as I go to see if they impact upon how the thermostat is working.0
