-
Tado Temperature Sensor to log temperatures below 0 degrees C
Hello, I'm using the Taco Temperature Sensor in my garage to purely measure the temperature. I found that there are hardly any temperature sensors that are connected to the cloud and can be read without being connected to the local wifi network. In my garage, it sometimes gets below 0 degrees C. The Tado app doesn't…
-
Tado...in the clouds!
Tado is unreliable,i use it for a while but disappointed,just an app for a lot of money,sistem has many many flows cause is cloud based,that is the main issue. Lucky me i have my old thermostat and i am using weather compensation with it and my trouble with Tado has ended,no connection lost,no lost of heat and less gas and…
-
Two ideas
1). For Combi users, develop a sensor that monitors system pressure and always when low. 2). For oil users, develop a decent tank monitoring system. I'd buy both. Tom.
-
Can we get smaller buttons?
I don't see the point in having to scroll down to see all the rooms, and then all the environmental buttons. It would be great if there could be an option to resize the buttons (e.g. specify how many in each column). Likewise, the quick buttons at the top require horizontal scrolling when again they would be in columns.
-
Confirm boiler shutdown before closing last rad valve
Hi, If the Tado app made sure it turned the boiler off before it closed the last radiator valve then this would allow the whole heating system to have tado valves on each radiator. In our house we have a nursery radiator which comes on regularly through the day and night. Because some radiators don't have thermostats…
-
Show radiator and boiler relay status in app
Hi, I think it would be nice to see the valve position status in the app. Obviously if the set temp is above the actual temp then Tado wants to open the vale, but it would be nice to see the feedback so you have some confirmation that it has happened without needing to be near the valve. The same would be true of the…
-
Notification on Phone when Window is Open
Would it be possible for the Tado app to create a notification pop up on your phone to let you know that a window is open?
-
Create an option for the Radiator Knob to NOT trigger the boiler
For houses with a floor heating system the setup how TADO Thermostat works with the radiator buttons not ideal. If one of the radiator buttons requires the radiator to heat up, this will now trigger the boiler and will then trigger the floor heating as well consuming a lot of unwanted heat. Suggestion is to create an…
-
Fireplace detection
During winter season I regularly use my fireplace, the increasing temperature will soon enough shut off my ac unit (heating). So far so good. I usually set he ac unit in fan mode to help distribute the heat. I’ve tried to automate this without much success. I see no support for this in the Tado app. Since HomeKit does not…
-
Master Temperature Control
I want my whole house to be 18 degrees. I don't want to have to go onto each room
-
Multiple schedules in one room
It would be great to be able to generate different schedules for different devices in the same Room. I have an UFH with wired thermostat and a radiator with RTV in the same physical room. Weekday mornings heat is only needed for one hour, so UFH better stays off. The radiator would be much better controlled by a wall…
-
Water damage / Fire detection
Not directly related to heating management, but will be a great asset: using the sensors available (temperature/humidy) to notify user of probable inprogress water damage (very high humidty) or fire (very high temperature). Would I had received such a notification, this would have greatly reduced the extend of damage that…
-
Introduce a learning ability to Early Start for radiators
Using the data a thermostat picks up about how your house heats and cools, and the time taken to reach/maintain a temperature introduce custom smart start/finish to scheduled events . At least add a 'radiator' version of Early Start.