-
Support 2 point calibration for adjusting temperature offset (Temperature Guesstimate)
It would be very helpful to enable 2 point calibration for adjusting the temperature measurement to match the middle of the room. Scenario as follows: At low temperature the thermostat reads the same as the temperature measured in the middle of the room e.g. 15°C so no offset required but at higher temperature the…
-
Intelligent Climate Control Device V3+" as an External Temperature Sensor for Thermostatic Valves
The "Intelligent Climate Control Device V3+" should be able to be associated with the same room as a thermostatic valve and be chosen as the reference for the external temperature. This can be done similarly to how it is done with a second thermostatic valve, an external temperature sensor, or the thermostat. If present in…
-
Change currency on estimated energy report
Currently the beta “estimated energy report” appears to be fixed as EUR currency. This should be configurable so users can select their home currency e.g GBP
-
Manual Home Placement for Geofence
My GPS is behaving a little bit funky, and the Tado App doesn't set my Home correctly in the Setup Procedure. Thats why I would like there to be an option to manually set the home location.
-
GJ unit in Energy IQ
For district / city heating the bill and meter readings are in GJ. It is very annoying to have to manually convert the units. Should be an easy fix: 1GJ is 277,8 kWh or 31,6 - 32,68 m3 gas.
-
Improve calibration by requesting heat
When no heat is requested, the pressure in the system can be so low, that the radiator valve pin does not spring out fully. This can result in an E4 error, or invalid calibration. This can be manually resolved by enabling boost heating before mounting the smart radiator thermostats. However, I suggest that the Tado…
-
Heating advance
Hi, This is an old idea that hasn't occurred to Tado as yet. My old school heating controllers have always included a Heating Advance Button. It's a simple idea - if you have a day that starts a bit earlier than usual, you just advance the whole heating programme with a single click, or turn of a knob. The next programmed…
-
Combined bridge power/ethernet wire
The included 30 cm power wire and ethernet cable contradict the advice that optimal positioning of the bridge should be vertical and not directly behind the router. It is very hard to get the bridge into a vertical position and on the wall while not being very close to the router. Tado also suggest the use of powerline…
-
Voice assistant missing command
A command to restore the schedule both by room or whole system is vital. I keep forgetting to manually restore at night and wake up to cold or too hot rooms. This command could be used as part of a 'goodnight' voice or timed routine.
-
Release a smaller, cheaper Wireless Temperature Sensor for the Smart Radiator Thermostats
The recently released "Tado Wireless Temperature Sensor" is essential, in many scenarios, to have accurate operation of the Tado Smart Radiator Thermostats. Which, due to their proximity to the radiator, are not typically able to measure the actual room temperature themselves. However, many find the price (£69.99 / 79,99€)…
-
Become truly environmentally friendly
Tado speaks about being environmentally friendly but my radiator thermostat broke. The resolution is to share a receipt and they ship me a new one (across multiple countries) and then I return mine (again across a long distance) I was told Tado does not have a repair department which begs the question of why it cannot be…
-
Better preseve room temperature
I noticed that tado is not good at keeping a stable room temperature. Instead of turning the heating on in advance while temperature is dropping close the level, it turns on when it’s just below. But that will be too late and thus after some time it increases the power to get the temperature higher which is waste of…
-
Ability to limit heating level for each room or each thermostat
It’s usually lot of waste of heating when heating is on level 3. Tado is not able at effectively run preheating economically. Its ability to learn this effectively gets complicated as the many things affect this such as X if room door is opened or not, or how often door is opened/closed. The temperature outside the door. X…