I have an AC thermostat and a radiator with tadoº valve in the same room. Cant' understand why can't we use the AC thermostat as a sensor for the heating radiator. Should not have to buy an extra sens…
Being able to interconnect with other devices, sometimes produced by multiple vendors in a smart house matters(pun intended), especially when the internet goes down. A smart home is a sum of all its s…
Hello Regarding the application, I would come up with a suggestion that could come to the aid of tado thermostat users who use control panels for actuators, for the boiler but also for the mixing grou…
It’d be great to have an option to add future dates and times when you know you’ll be leaving home in the morning, so that the system doesn’t start heating full on. Since that’s not the same everyday,…
When I say I'm going away, it would be helpful if it let me say until... Eg I'm away - but I'll be back 2pm on Tuesday 7th. It might pop up or email me 24 hours before and let me change that predictio…
Hi, I would like the functionality of using the cost forecast of Octopus Agile for overheating my apartment prior to a high cost period. These seems to be the functionality of Tado Balance for heat pu…
Hi, Hopefully not the biggest amount of work for this one: It would be nice to be able to define “when” you want to get notified from Tado to submit an energy reading. For weekly notifications it coul…
Would love to see the Tado Internet Bridge with Power over Ethernet. This could save us an additional cable because everything can be done with the Ethernet cable. Since the raspberry pi and many othe…
It would be very helpful to enable 2 point calibration for adjusting the temperature measurement to match the middle of the room. Scenario as follows: At low temperature the thermostat reads the same …
The "Intelligent Climate Control Device V3+" should be able to be associated with the same room as a thermostatic valve and be chosen as the reference for the external temperature. This can be done si…
Currently the beta “estimated energy report” appears to be fixed as EUR currency. This should be configurable so users can select their home currency e.g GBP
My GPS is behaving a little bit funky, and the Tado App doesn't set my Home correctly in the Setup Procedure. Thats why I would like there to be an option to manually set the home location.
For district / city heating the bill and meter readings are in GJ. It is very annoying to have to manually convert the units. Should be an easy fix: 1GJ is 277,8 kWh or 31,6 - 32,68 m3 gas.
