-
Tado X support for hot water?
I currently have a Nest controlling the radiators and hot water, and a Drayton programmer controlling 3 zones of underfloor heating. Both demand from the gas boiler independently. I think I’ve worked out that the V3+ supports this configuration with a wireless receiver and 3 wired thermostats. But am I right in thinking…
-
Upgrade to X and lifetime auto assist
Hi! I am wondering whether upon upgrade to X tado will honour the lifetime Auto Assist subscription that was available with some of the previous editions of the kits. I understand that V2/V3/V3+ can't co-exist in one account with X, but I am wondering if it upon upgrade and removal of the old bridge, the subscription would…
-
Tado X and home assistants (adding important elements)
I added official integration, but for tado x I see only outsite temp, localization, solar energy (prediction) and tado mode nothing else. I need hetting status, actual temp., sett. temp., humidity , opened window status, etc. For all added thermostats. For version V3+ all info is available in home assistant (google home…
-
Connecting a Smart Wireless Temperature Sensor X to the bridge
Dear community, I joined newly the Tado community. At home, I have installed so far 4 Smart Radiator Thermostat X and one Bridge X. My first impression were OK. I wanted to add Smart Wireless Temperature Sensor X to have a more accurate temperature measure. During the installation in the app, I receive a failure "Thread…
-
Tado X and Home Assistant
I purchased the new X thermostat and valve system. I am hoping for more Home Assistant integration, as is the case with the V3 system; it doesn't offer much at the moment.
-
Tado x smart thermostat and Junkers boiler
Hi everyone, I have a Junkers boiler and a Fw120 thermostat that I want to change for a tado x smart wired thermostat that I just bought. My Fw120 thermostat has b1 and b4 wires connected, also a b2 wire not connected. Do you know where those wires from the boiler should be plugged on the tado x smart thermostat? I tried…
-
time to send the order from the app
Hi! I have a tado X thermostat and when I use the app to turn on the boiler, it takes about 1 minute to send the signal. It's normal? It takes a minute to turn off too
-
Daikin Heat Pump Compatibility
I am looking for a smart home heating solution and contacted support to assess compatibility for Tado X which states it accommodates under floor systems. Support informed me that Tado X is not compatible with Daikin Altherma R F - EHVH-CB and Daikin ERLQ006CAV3. I would suggest adding compatibility as this is a widely…
-
Tado X Smart Radiator Thermostat - poor battery life
It has been less than 2month since I installed Tado X system and the batteries in the TRVs started failing already. The system has hardly been used (apart from testing) so battery depletion seems really premature.
-
Tado X add to current Home with V3 versions
If you already have several Tado V3 TVRs if you purchase an additional New TVR X & the new X Bridge do they get added to the same home as the current Tado v3s or does the app create a 2nd Home? I would like all my Tado devices to show upmon the same Home screen?
-
Tado X suggestions
(I originally messaged this direct to Tado but they asked me to repost it here.) I have read that currently your Tado X heat pump controller supports only some makes of ASHP as of yet but based on customer requests you will add more. I am therefore contacting you to suggest both Samsung Mono HT Quiet, and Daikin Altherma 3…