-
Radiator thetmostat offline
One of my radiator thermostats repeatedly goes offline. I reset knob by taking out batteries like suggested in app. It then works for half hour then goes offline again. This is a new issue. Previously connection worked fine. Any suggestions?
-
Overall boiler uage
As well as all the individual charts in the app, how about one that merges all others to show the demands on the boiler over each day? This would allow a better judgement as to whether to use a steady state or on off strategy.
-
Replacing a tado v1 thermostat due to battery holder breaking
I want to replace my Tado thermostat V1 with what.is the replacement straightforward.
-
Will this work for a 2 heat and 1 water zone system?
Hi, I have an "incompatible" controller according to Tado. It has separate zones for heating downstairs, upstairs and hot water. I'd like to do the following and I would appreciate advice and feedback? Two wired smart thermostats to replace the room thermostats on each zone, then a wireless receiver to replace the existing…
-
Tado device already registered in another home
I just bought a tado smart ac control v3+ at a retail shop. Noticed that it had been returned by another customer since the package was opened. Tried to register the device but was told that the device was already registered in another home. Contacted chat and sent the serial and reciept.. No response.
-
Registering Failed
Hello, While registering the elements of my new Tado - Bridge and Wired Thermostat, I received the following message with the Bridge: "This device is already registered to another home" (see screenshot) Please find attached proof of purchase on Amzon.fr and a photo of the bar code. Hoping to receive a response from you.…
-
Possible to have an SRV not call for heat?
I'm just getting started with tado so I don't have any of the kit installed yet which is limiting what I can find by poking around in the app. I'm trying to work out whether it's possible to have the typical setup with a wired thermostat, SRVs on the radiators in most rooms, but have the SRV in one room open and close the…
-
Tado with Alpha eTec33
Has anyone had experience of install a Tado to Alpha eTec 33? We had our boiler replaced and the installed never installed the Tado back on. He came back out but we couldn't get it to fire the boiler up. The Tado backplate was thrown away so I had to buy a UK standard backplate (I dont think this make any difference but…
-
Wireless connector clicks but no boiler powering up?
Hi all Have a ideal logic maxi C35 combi. Removed the old wireless receiver pre install. It's an ideal one that simply pushes Into an opening in the boiler front. Checked wiring as per instructions. All was correct. The boiler just doesn't respond.
-
Ideal Combi C30 boiler installing Tado Smart thermostat
Hi All, I had an Ideal Combi C30 boiler install done last year. They give us a standard on/Off timer. We would like to install the Tado smart thermostat my son's got me for father's Day. But I've confused myself about the wiring between forums, manual and Tabo apps....lol Can anyone help
-
Replace existing Hive with Tado
Hi, i currently have a Hive system connected to my Baxi 600 combi boiler but have decided to replace it with the Tado system & i have a question regarding the wiring of the Tado wireless receiver to my boiler. The existing Hive receiver has mains in/out & a black & a grey wire which are both connected to the PCB on the…
-
Converting from Hive to Tado
I have a Hive wireless receiver. Does anyone know the wiring to replace it with Tado
-
What is the LED on top of the smart radiator valve for?
When is this LED ever used?
-
What do I need to setup my flat
Hi All, I'm quite new and I'm still puzzled what I should get to setup my flat (community heating). I was thinking about https://www.amazon.de/gp/aw/d/B09ZPZFZBM/ref=ox_sc_saved_image_2?smid=A3JWKAKR8XB7XF&psc=1 + 3 of these https://www.amazon.de/gp/aw/d/B08D6VJVFG/ref=ox_sc_saved_image_3?smid=A3JWKAKR8XB7XF&psc=1 and one…
-
Worcester Bosch Greenstar Life 8000
I hope someone can help as Tado customer service seem incapable of providing a simple answer. I wish to switch from Hive to Tado as I understand there are additional benefits of using Tado since they’ve reintroduced modulation to UK models. Can someone tell me which up to date wireless thermostat I need. Also, is it quite…
-
AC V3+ is totally useless since it's pushing cool air when switching to a lower temp time block
When there is a "smart" schedule set and the next time block has a lower temperature, the controller puts the AC on pushing cool air, even if the AC is set to Heat in the scheduled block in the Tado app. That is making the controller totally useless since it pushes out cold air when it should just stay inactive until the…
-
MANUAL TEMPERATURE CHANGE TIMER FAIL
All my "rooms" are set to resume manual changes "after an hour". Today any changes are actually showing "until next time block". Anybody had this problem? or any knowledge of it?
-
Worcester Bosch Greenstar 8000 and EMS
Hi, I have a Worcester Greenstar 8000 boiler installed in an S-Plan system. On the Tado side have a Wireless Extension Kit and use a combination of TRVs and a Wireless temperature sensor. I'm also using a Mixergy hot water cylinder. I'm planning to have an internal diverter valve installed in the boiler so that I can…
-
Can no longer manually control thermostat
I think a recent app update has stopped my thermostat from being manually controlled. It may have been since the ‘sparkle’ update. But now the up and down buttons on both of my tado thermostats no longer work. Any ideas?
-
Vaillant EcoTEC Pure VUW 236/7-2
Hello, I have a Vaillant EcoTEC Pure VUW 236/7-2 and the tado Wireless Smart Thermostat V3+. I did all the wiring on eBUS as per tado manual with the D07 config code (https://cdn.brandfolder.io/607DGEMS/as/j4mjvsgpjtghjkm57fkx5q7h/104204-DIGITAL-WRB01IB01-INSTALLER_MANUAL-TA-EN-00-V3.pdf). Now, everything looks fine, but I…
-
Make the consumption in the app work correctly
I have been inputting my gas usage on a daily basis now into the Tado app. On the usage report from Essent by gas company the Gas usage is 38 m3 costing € 77,74 In the app the gas price is correct for October (excluding other charges) is correct In the app the Gas usage should be correct as I enter it from the meter every…
-
Smart thermostat turning itself off
Hi all, My tado has been working fine for over a year. Over the last few weeks however it is turning off before my rads heat up. It also happens on manual control. It will come on and then after about 5 mins or less I can hear the relay click and it will turn off. According to the app and the display it should be on as…
-
Turn on CH System on all time - S Plan - live to CH NO?
I have just installed a Tado system with the Wireless Reciever and Two Smart Thermostats. Without getting into the weeds of Tado, I want to energize the CH system all the time. But Why? I have two thermostats which control a demand valve each which when opened kick the boiler and the pump in. The challenge is that the…
-
Radiator valve closed while calling for heat
I'm fairly new to the setup, but I have an interesting one. I've noticed, since installing the whole thing, that when temp difference is 0<0.4 degrees, the radiator valve/thermostat will request heat, and the boiler will start (with half the temperature, as expected due to just one curly line) but the valve would not open.…
-
Radiator valve always open
Hello people, does anyone here have experience with putting in a TADO smart thermostatic valve? I'm running into an issue where, when I turn on the main heating supply of this house, this particular radiator is always on at full power, which, I guess, means that the TADO is not able to push on the pin to stop the supply of…
-
Why does my radation valve turn itself to "OFF" every night?
One of my rad controls turns "OFF" at midnight. I have to reset it using the app every morning. Its very annoying. There is no "off" setting in the program i have created.
-
Wired Thermostat going Offline
Hi, Recently installed a Wired Room Stat and keeps going offline, ive moved Router nearer to the room and reset Router and Stat. Still same problem, happens at least twice a week. Any Suggestions? TIA Barry
-
Hot water not lighting on wireless receiver
Hi, Just installed the wireless receiver and heating controls working fine but hot water not lighting or clicking ??
-
TRV calling for heat
I have two wired smart thermostats installed, one for radiators and one controlling under floor heating. On my Horstmann controller I leave those two channels set to on, so both heat channels are controlled by the tado smart stats. I’m adding some smart radiator valves and have a question - how do these call for heat? I…
-
No Remote Access. Wifi + Error lights blinking on wireless receiver
Hi, Had tado installed on Tuesday. Working fine until a few hours ago, when 'No Remote Access' started showing in the app for all rooms. Three solid lights on bridge, router OK (restarted just in case), wifi fine to other sites from smartphone. The wireless receiver linked to the boiler has the wifi and error lights on,…