-
Pairing internet bridge to new router
I have changed my router, how do I pair the bridge to it please
-
interference
Hi, I want to use some extension sockets etc made bu ENERGENIE (.com). They use a hub. Will there be any interference between their hub and the TADO one?
-
New Boiler Vailant eco TEC pro VUW 246/5-3
Hi! I have my Tado smart Thermostat for about 2,5years and it is working perfectly. Now I have installed new boiler and the termostat does not connects to this new boiler and proffesional mounters tells it doesn't work. Can you help with this?
-
Tado Wired V3+ and Worcester Greenstar CDi Compact - Digital Connection
Hello. I have a Worcester Greenstar 28CDi Compact boiler with no thermostat, only the inbuilt digital controls. I'd like to replace this with the Tado Wired V3+ with a digital connection for modulating and weather compensation. Tado speaks EMS Bus I believe? So I think after disconnecting the inbuilt digital control's…
-
Combi and 2 heating zones, how do I wire this up?
I have got the starter kit plus an extra thermostat. The stat I want to be wired, I have changed to a zone controller in the ap. Just don't know how to wire this all up. Do I need to utilise the hot water output of the wiring centre in some way?
-
Help with Tado and Worcester 28i installation
Would someone kindly help me understand if my wiring is correct! In the photo wires connected are coming from the manual clock. https://ibb.co/K2kg2j3 I assume I can remove that completely and replace with the tado wires, and ignore black wire, then in the tado controller use switched live? Is that correct?
-
How to associate a TRV with a specific thermostat (Dual Zone)
I've got two thermostats as my heating is dual zone. I've added the first TRV which seems to be working correctly and turning on the heading downstairs when it calls for heat, but now I am adding my second TRV but it needs to be associated with the 2nd thermostat upstairs. I've looked around the UI but I can't see where I…
-
New setup with existing devices with underfloor heating
We have recently replaced our boiler and hot water tank with a new combi-boiler (Worcester-Bosch Greenstar 36 Cdi Compact), and the introduction of a new hot water underfloor heating system. I want to setup Tado as the control mechanism for the new combi-boiler, the underfloor heating and radiators. I have sketched a…
-
nest to tado wiring
this is a follow up to my previous thread - https://community.tado.com/en-gb/discussion/13948/replace-nest-wireless-receiver-with-tado-wireless-receiver finally took possession of the new property. the boiler is an Alpha E-Tec 28 which does indeed support opentherm. UK combi boiler so will be heat only. it currently has a…
-
Dual hot water control
I have installed 2 V3 wireless thermostats when I installed the first one I set it up to control 1st heating zone and the hot water for the boiler. When I installed the second one for heating zone 2 I don't get the option of a second hot water chanel which I was going to use to control the immersion heater through a…
-
Fritzbox 7490 - cloud light blinking
I access my home Internet connection with a fritzbox 7490. When trying to connect the Internet bridge for the first time, the power and router lights stay lit up and fixed, but the cloud light is always blinking. I have been unable to find a solution to the problem and am unable to connect the Internet bridge. Which…
-
tado 3v Does it not support Mitsubishi air conditioners?
Just replaced the Mitsubishi air conditioner, Identifying your AC model , We couldn't identify your AC model Signal detected Could not identify AC
-
Can I control 3 boilers with tado?
I have three boilers that heat different parts of the property. Ideally I'd like to use one wireless kit plus two wired thermostats but if that isn't possible then I can run cable so that all three are controlled with wired thermostats. Will this work?
-
UK Modulating Boilers with Tado
Hello I'm in the UK. My boiler has reached the end of its life and needs replacement. The replacement will almost certainly be heat only, working with a hot water cylinder. I am quite invested in Tado, with a v2 extension kit, wireless thermostat and lots of smart radiator valves. I'd quite like to get a boiler which will…
-
Hot Water not firing up boiler?
TL DR; Hot water won't come on even though no errors seem to be present in either app or wireless receiver. Hi there, This is a long shot as I know very little about plumbing in general but gave it a go as all the instructions were relatively straight forward, but before seeking professional advice, I wanted to ask here.…
-
Temperature WAY off
Hi, I have a Tado smart thermostat first generation. It has a remote temperature sensor, placed in a central position of the house, far from any radiator. this setup has worked well for several years and nothing changed. Lately, it's showing a temperature which is WAY off... I see a temperature of 34.2 °C while in the…
-
Myson 24v
Hi all, Can someone point me in the right direction… Our underfloor heating controllers are analog and 24v but can’t find the right wiring setup for them These are the thermostats we currently have: https://www.mytub.co.uk/myson-24v-room-thermostat-50507-product-108386 Thanks in advance
-
Energyiq now predicting a £0 gas bill for October
It had been predicting a £47 bill now it has dropped to £0. The tariff is set correctly, at £0.10 kWh at 400 kWh I would expect a £40 bill but EnergyIQ is estimating a £0. While very excited to see the charge drop, I am sceptical of its accuracy. I am new to Tado, is it really this flakey?
-
Ideal vogue c32 gen 2 tado installation
Advice needed! This is the current wiring in our boiler. The white wire is the mains cable and the black is the Condensate Pump.according to instructions I need to connect to L, N & room stat. The L & N already have 2 wires wired in, room stat has 1 in each terminal from the condensate pump. Where do I go from here?!
-
2 apartments in one account?
Hi, I have 2 apartments heated by the same heater. Tado scheme D, but each apartment has its own wi-fi. If I connect new internet bridge at the rental apartment, everything tries to connect to this new bridge. Is there any way how to do it? I think about inconvenient option to have the rental apartment on different account…
-
Anyone else find the new app changes annoying?
Just updated the app on my Samsung phone and noticed that I now can't easily change a room/HW to a manual period e.g. it used to be possible to tap on the HW button and the app would then change to manual mode and you could edit the time required for the HW to stay in that state. Now you have to change the state OFF -> ON…
-
I have Underfloor heating (3 Zone ) and radiators.
I have installed 2 x wired Thermostats where the Underfloor is in the Living room and and Separate Wired Thermostats in the other Zones in the House , But it will only heat either the Rads on there own or Underfloor on there own . Can anyone please help as to how i can make this happen. They are separate on the oil Burner…
-
Why is the boiler suddenly pumping out heat 3 or 4 degrees above the set temperature?
My basic system is about 6 years old and is only for the heating. Just switched the boiler on for the winter season, but the boiler is heating way above the target temperature. Simple wall mounted thermostat. Installed by D&G and always worked well to date. Thanks for any advice
-
Heating constantly calling for heat
Hi, just installed a V3+ kit and second thermostat for the upstairs replacing a Danfoss 9000 downstairs and 5000 upstairs plus the TADO downstairs thermostat/temp controller replaced a little matchbox sized Danfoss temp reading device, the two wires from this I just put in the block connectors provided by TADO. Upstairs…
-
Don't know if change the thermostat can help.
My home is using a conventional boiler which provide central heating as well as connecting to a water tank for hot water. A honeywell programmer is next to the water tank cupboard, then the wireless receiver. The Honeywell wireless thermostat is in the lounge. The bathroom have a towel rail (full flow without TRV, and all…
-
Install Issues
Hi, New user here. ive set up and installed the below and wondering and hoping someone can guide me in the correct path. i have 3 Zones in my House which control oil-based heating system. Zone 1 Downstairs Rads Zone 2 Upstairs Rads Zone 3 Downstairs Living /Dining & Kitchen Area underfloor Heating (Water Based) i recently…
-
I cant get my system to work via the schedule only through manually turning each room on.
I have rebooted the Internet Bridge, I have taken all the radiator valves off and change the batteries and put them on again. They paired successfully. I have rebooted the thermostat. Now I don’t know what to do any suggestions?
-
Does the thermostat shut the valve when no rads are calling for heat?
My thermostat is in the same room as a radiator. If I have a smart thermostat on the radiator and it is set at a lower temperature than the wireless smart thermostat will the thermostat shut off the valve or still be calling for heat even though the radiator has shut off?
-
Limitation température à 25
Pourquoi limiter la température à 25 degrés ? Pb hardware ou firmware?
-
How come all rooms are keeping a constant temperature but one room is overheating ???
How come all rooms are keeping a constant temperature but one room is overheating???