-
Wireless thermostat and radiator valves
I have installed a wireless thermostat and two radiator valves. I have the same set up up stairs and on my app the upstairs shows as main bedroom in one box and controls the valves fine. I have now tried to do the same in my lounge but my app shows lounge in 3 boxes instead of only one box. Not sure what I’ve done wrong…
-
Linking to air source heat pump
Do we need to replace the transmitter on our heat pump with the Tado one or can the smart thermostat link to the existing one?
-
Setup Tado smart ac control v3+ without original IR remote?
Hi, I'm thinking of buying a Tado smart ac control v3+ for a duct system mounted in the ceiling. The brand is Haier, currently controlled via a wired remote on the wall. The wired remote has an IR-eye but I dont have any IR-remote. From what I've read it seems like I need an IR remote to configure the Tado? Will I not be…
-
Compatability with Vaillant Combi Gas Boiler
I have a Vaillant ecoTEC plus combi boiler with a vSMART wireless controller, I'm considering installing a tado system with at least 6 rad controllers. My question is ; is the tado system compatable with my Vaillant set-up The tado compatibility chart suggests it is, see attachment, but before I commit to £350 worth of kit…
-
Replacing existing wired controlling and programmable thermostat
I have a Worcester Greenstar 24i system boiler connected to a Honeywell ST2400C controller which is connected to a Honeywell CM907 programmable thermostat. I do not know if the current wiring to the programmer etc is via a wiring centre as the wiring from the boiler to the controller is boxed away and access extremely…
-
App on saying heating but no warmth in rads
Hello! First post, I tried searching for this but couldn't find anything so apologies in case this is a frequently answered question! I have the Tado in the room I am in set to heat to 20c, it says it's heating (and is shaded on the little chart) but the temp is not going up and the radiator is cold. It's currently 13.4c.…
-
Hur kan man undvika att riktningen på luftflödet ändras på IVT aero vid start.
How can you avoid the direction of the air flow changing on the IVT aero when starting and stopping.
-
Extension kit is completely dead
My Wireless Extension bridge, or device, the one connected to the heating system and the electrical supply, is now dead. I have tested both the cable from the plug with a measuring instrument and it shows 240V on the poles of the device, also there is about 80V coming from the heating system on the heating system relay…
-
Heating rooms individually without having to turn on main thermostat
Hi, Just need a bit of help please, just installed the tado kit and trvs yesterday, all works fine but I'm struggling with one thing. Can I just slide up in the app let's say for bedroom 1 and then the boiler gets triggered and turns on? Right now I am having to do the following: Turn up the main thermostat and then…
-
Maximum Boiler Temperature Fail
Set my open therm maximum boiler temperature to 60 degrees a two days ago and checked the boiler flow and return temperatures which, at a point, were 59 and 32 degrees. Just checked this morning and they were 80 and 65. How can this be?
-
Why does one particular radiator come on whichever room I try to heat?
Hi, I have a Wireless Thermostat and two radiator thermostats in my dining room. I also have radiator thermostats in our three bedrooms, the bathroom and the living room. In the evening, I just want to heat my children's bedrooms, as we have a woodburner downstairs. Whilst I can heat the two bedrooms, one of the radiators…
-
Deleting account on the community.tado.com site
How can i completely delete my account on the community.tado.com site thanks beforehand
-
Heating on, but no indication why......
Hi everyone I had a situation a few weeks ago where my Wireless Receiver lost connection with the internet bridge and kept the heating on until it re-established a connection. This happened overnight so I only noticed when I woke up in the night and realised all the radiators were on full blast at 2am! I reported this to…
-
changes not displaying on grouped TRVs
Hi, Ive just recently installed my Tado system and so far everything has been great. One curiosity however is Ive noticed that the grouped trvs in one room arent displaying changes unless physically tuned. I have 3 trvs in 3 rooms and then another 3 fir radiators in our open plan living room. When changing values on the…
-
What are the Basic Line TRV limitations
Hi, I have several Tado Smart TRVs installed but Im curious what the difference is with the Basic Line of TRVS. There are a couple more radiators that I wouldnt mind installing TRVs on, but perhaps I could get away with using these cheaper version for less important rooms (bathrooms for example). Im assuming they are…
-
Help with what to buy!
Hi All, Before I go ahead and purchase I want to be clear on the right kit. I have a system boiler in the kitchen with a hot water tank upstairs in an airing cupboard. 1 x Bathroom - On/ TRV 1 x Bathroom - On/ No TRV 4 x bedrooms - On/ TRV Living Room - On/ TRV Kitchen - Off / No TRV Hallway - On/ No TRV Current setup -…
-
OpenTherm Water Temperature
Hi there, today I have bought new boiler (Baxi Duo-tec Compact E 24) which supports OpenTherm and is connected by wire to Tado Smart Thermostat. Hot water control for washing hands is regulated by temperature setted up in Tado App and cannot be regulated in boiler - which is correct. Hot water going to radiators also…
-
Tado Smart Radiator Thermostat and Heatmiser Thermostat
In my home on the first floor passage I have a Heatmiser Thermostat which controls the heating in all bedrooms on the first floor. If I were to fit Tado Smart Radiator Thermostat's on all the radiators is it possible to control when the actual boiler turns on by replacing the existing Heatmiser Thermostat with a wired Tado…
-
How to remove old wireless stat. Alpha boiler with Alpha easy stat
I have an Alpha Etec 28 boiler with existing wireless Alpha thermostat. I have hardwired in the Tado, but In the instructions it did not mention how I remove the old stat from the boiler. The old one is interfering with the Tado, and I need to remove it for the Tado to work. Does anyone know how? Thanks very much.
-
Tado control algorithm
Hi, Imagine the following case with a Vaillant ecotec plus and Tado thermostat connected via Ebus. The Tado ebus is demanding the CV heater for a CV water temperature of 58°C. The CV heater has a parameter that limits the CV water temperature to 45°C. By doing this I am influencing the timing/parameters of the tado…
-
Is my thermostat working?
Hi, I have 4 smart rad valves, internet bridge, wireless room thermostat and wireless controller running a Worcester heat slave oil boiler. The system also has another 5 radiators with ordinary TRV’s. The smart rad valves work satisfactorily but the thermostat is a bit of a mystery. I had assumed that when the smart rad…
-
Hot water Boost
Is there a way to boost the hot water for a short time at a period when the schedule would normally have the water off.
-
Smart thermostat appear offline from remote location
Hello, I have problems with my Tado Smart Thermostats installed at home. Tado app is showing some devices offline when I'm using remote access outside home network. When I'm at home and connected to the same network as Tado bridge devices are back online. I do not know what is happening and what is the reason. It was…
-
Temperature variation between thromostat and room
Hi there My thermostat says 20,4 degrees. 2-3 meters away, I have put a thermometer (different brand) that reads 18,7 degrees. Isn't that an unusual variation? My thermometer is set by the window, so that might affect the temperature a bit. My radiators are also by my windows, but under. I have a similar setup in another…
-
Warum schließt das Tado Heizkörperthermostat nicht immer vollständig?
Ich habe meine Heizkörperthermostate DN15 (Fabrikat Heimeier) mit den Tado smarten Heizkörperthermostaten ausgerüstet. Hierfür habe ich jeweils raumweise Zeitschaltkataloge angelegt. Leider schließen die Ventile im Automatikbetrieb nicht immer vollständig, so dass die Heizkörper auch außerhalb der eingestellten Heizzeiten…
-
Installing tado to replace Sunvic controller with Glowworm boiler - gone wrong
Hi, We tried to install a tado wireless thermostat today but no luck, and when we tried to put the old controller back the boiler won’t work at all now. Details: -Sunvic select 107xls -Glowworm flexicom 24cx Below how we tried to install tado. We believe the wires were originally as shown on the Sunvic but unfortunately we…
-
I cannot go further than 21 degrees on my rooms. What can I do?
Looks like the Tado thermostat controllers stops when they measure that is 25 degrees, that would be ok if that was true, the reality is that in the room is 21 degrees, that might be true next to the radiator not in the rest of the room. So currently I cannot go further of 21 degrees with tado installed. It should be…
-
Hot Water Always On
We have a split system, Vaillant Boiler with a HW tank. Our electrician installed a wired smart thermostat for upstairs and downstairs to replace the old system. Under the old system we only paid for hot water when we used it. Every other time of day our energy bill showed 0kwh. Now with the new installation it is showing…
-
Thermostat
Tado app indicates batteries need replacing, having replaced with new correct batteries and in correct polarity order and checked terminals were clean thermostat still doesn't show temperature and app still says batteries are needing replacing.help please.
-
I changed my broadband supplier, now my thermostat won't connect to the internet.
I changed my broadband supplier, now my thermostat won't connect to the internet. I tried pressing the button bottom right corner for 10 seconds bot no joy.