-
Why do I have to reboot my thermostat almost every day ?
Hi, Since a few weeks, I have to reboot almost every day my thermostat to make it work. When I press the button, it display the temperature but doesn't move to the part when I can change the desired temp. And the App show the installation as being offline. Pressed the button ~10 seconds, it reboots, reconnect and…
-
Boiler reads lowest temperature of Tado radiator valve when set to Off.
Hello all, I've been digging into a problem I have for the last few weeks, and I'm out of ideas. I'm hoping this community can help me. My situation: Generally I'm only heating all rooms in my house during the winter, when it's freezing outside and temps in the bedrooms gets too chilly. That is not yet the case, so I have…
-
How to replace Honeywell thermostat with Tado wired thermostat
I am currently using Honeywell T87G1006 Round On/Off - I want to replace this with Tado wire thermostat. I am stuck with the wiring to connect to Tado thermostat. Please find the image for your reference.
-
Where are we placing the thermostat
Hi in the UK and have placed my wireless thermostat on the wall in place of the old one and have no trv on the hall radiator, but reading up I see it’s recommended to have the thermostat in your main room, so what’s correct? Thanks
-
Wired Thermostart Starter Kit + Extra Wired Thermostat + Baxi DuoTec 24 Boiler
I have replaced my 2 Danfoss WT-P thermostats with 2 wired Smart Tado Thermostats. The tado part with the 2 thermostats and the internet bridge all work correctly. But there is no connection to the Baxi Boiler COMBI 24 H EA. We have 2 Zones of underfloor heating controlled by the 2 thermostats. We have followed the wiring.…
-
Wired Starter - dual zone opentherm and valves
Hi folks I’ve been looking round the forum for help on my specific case before purchase, and I think I’m being confused by some info referring to out-of-date kit. I’m in a new build with a combi boiler and dual zone heating. Ideally I want to use 2 wired Tado thermostats to replace the existing dumb ones, TRVs in each room…
-
Newly announced opentherm model for Worcester Boiler
Hi all - I've seen in the latest Heat Geek video that the Wireless control now supports opentherm (if bought on the pro store of theirs - all a bit confusing). I have a Worcester Greenstar 37CDI and was hoping someone could be kind enough to let me know if i can connect it to this bus terminal, or I'd have to get down and…
-
What happens to my existing boiler control unit in a wired setup?
Hi, I have a two zone heating setup with hot water. I'm going to replace my two existing thermostats (very simple temperature dial units) ) with Tado wired. What happens to my existing control unit, does it just stay on all the time or is it bypassed? I'm a bit confused! Thanks.
-
Replace Danfoss TP5000 Wired Thermostat with Tado
Our electric central wet system consists of an electric boiler (Heatrae Sadia Amptec C900), a hot water tank (Cyclone CY200), a wired Danfoss TP5000 thermostat and multiple TRVs in each room. I am not able to see any receiver attached to the electric boiler. Hot water is heated up at specific pre-programmed times (off peak…
-
Smart Thermostat SCREW size (at the bottom)
Does anyone know the size of the little screws at the bottom of the Smart Thermostats? I've lost one.
-
Necessary equipment & set up for multiple UFH zones, rads, hot water (& ideally A/C)?
Hi, I am doing a large house renovation with new underfloor heating and trying to figure out how much of my ideal configuration is possible with Tado. Any guidance or feedback appreciated. Here is what I am aiming for: UFH: 8 zones of wet UFH over 2 floors (multiple different rooms and I don't want to heat all of them at…
-
What am I doing wrong?
Hi all, i installed a new tado v3+ in my house at the weekend together with 4 smart TRVs. I was hoping that I would be able to heat a single room on it's own but it would appear that the room radiators only come on whilst the room with the wireless thermostat (hall) also has the radiator on. Is this right, can I not heat…
-
Tado bridge affecting WiFi range?
Installed the Tado system today and since we installed the bridge, the WiFi range in my house has been terrible. Literally doesn’t go much beyond the room the router is in. We’re also having intermittent periods where the wifi has no internet access, even within the room containing the router I’m confused as to how this…
-
New multibus/opentherm wireless receiver
Hi! I'm just about to buy a new combi boiler and wanted to make sure the new wireless receiver: will be able to modulate my possible replacements. Worcester Bosch Greenstar 8000: https://www.worcester-bosch.co.uk/products/boilers/directory/greenstar-8000-life-combi Viessmann 100-W/200-W:…
-
What to buy?
Hi All I'm hoping someone can let me know what Tado system to buy for my house as I've become very confused by the info I have read! The house is a brand new build, and has got a boiler on the ground floor in the utility room, next to a programmer that we currently use to set the times for heating and hot water. Then there…
-
2 zone setup
Hi - looking for some clarity on how I can do this please. I have the Ideal Atlantic boiler, Tado Extension Kit and 2 wireless smart thermostats. I have radiators round the house and underfloor heating in the kitchen split by a 2 port valve off the boiler to each set. How can I control them independently and control the 2…
-
Tado Homekit 'no respons'
I hoped that the 'no respons' issue would be fixed in the new Homekit, but no. I reset the internetbridge, added back to Homekit and 10 minutes later one of the STV was already 'no respons'. Any thoughts?
-
Ideal Vogue C40 and Nest with Tado Smart Radiator Valves
My current heating setup consists of an Ideal Vogue C40 Combi (Gen2) with a wired Nest Thermostat and Heat Link. All the rads have standard inlet/lockshield valves. In the next couple of weeks I’m having all of the valve sets replaced with Drayton TRV4 valves (the one in the hall where the Nest is located will be left on…
-
I need help with setting up the app to control the heating with a schedule I program it but it just
I the heating just stays off on my schedule it doesn't come on.any help be good how to program the app .
-
Opentherm wireless hub wiring.
I am currently about to wire up my tado eu starter kit that contains opentherm connections and theres a yellow label stating no mains by the opentherm connections. I assume its saying not to wire mains power into the opentherm terminals and that the hub itself still needs mains power into the L and N supply points? I…
-
How to stop tado AC controller v. 3 from turning from heat to cool
Hi, I just installed a AC controller to control a Panasonic heat pump. Basically, living in Norway, I wonly want this to heat, never to cool. However, the tado now and then changes the mode from heat to cool. Can I stop this in any way?
-
Wiring into ideal logic combi
LWaiting on support but thought to ask here if I have wired this correctly or if I need the switched live option, removed the link wire and connected the CH COM and CH NO into the two external stat terminals on the boiler that had the link wire, as diagram A, but boiler won’t fire up, any help ?
-
Wireless thermostat not turning on. Can I turn the heating up?
Batteries replaced and still not turning on. Internet bridge is working as well as wireless receiver. Have submitted a request but waiting a response.
-
Wireless reciever and wired thermostat?
Can I wire the wireless reciever to the heating junction box together with wire from the wired thermostat so that the trvs call for heat via wireless reciever, also still have thermostat hard wired incase Internet fails, or will this back feed thermostat when wireless reciever turns heating on? Thank you
-
Should I buy a Wired or a Wireless Tado Thermostat?
My existing thermostat (not a smart one) is in the hallway. Although I could replace it with a Tado Wired Smart Thermostat, it seems to me that it's not a clever idea to control the boiler based on the temperature in hallway. It seems to me that having a Tado Wireless Smart Thermostat in the living room where we spend most…
-
Replacement parts
Hi everyone When removing a thermostat to replace the batteries my father has snapped one of the clips on the adapter attached to the radiator. The thermostat will stay in place but is throwing up errors so need to replace the part. Does anyone know where I can order a replacement for the radiator attachment? Thank you all
-
Installing a new opentherm compatible boiler (veissman 050) with Tado on/off relay only controller?
I currently have a tado system which is wireless thermostat+receiver, and smart TRVs on all radiators. Its a UK model so is (I have now found out after buying) is on/off control only. My old combi boiler is needing replacement and my likely choice is a veissman 050w 30kw. There is an option with the installer to provide a…
-
Connection Issues 24/7
To be quite frank, we’ve had this system for over a year now and i’m extremely dissatisfied and pissed off with it. I read reviews that that said it was better than the hive so i took my chances but i’m too embarrassed to recommend to even a friend and wouldn’t do after the experience i’ve had so far. The service is…
-
Instillation question
I have 3 wired Honeywell thermostats, also a wireless thermostat going to 4 actuators I need to change the stats to Tado and on the one that controls the upstairs radiators, I need to install 6 Tado TRVs Can anyone help with whats required. I am an electrician and installed the basic set up but not this
-
Wired Thermostat for UFH
I would like to replace the basic wired heatmiester thermostats I am currently using with the UFH on my ground floor. I am using Tado TRVs on my upper floor. Both the Tado extension kit and the heatmeister thermostats are all wired into a UF4 wiring centre. If I replace the heatmiester thermostats with Tado wired…