-
Multi zone, rads and ufh design
Hi all, I have a few design questions: I have 8 rooms, 3 zone valves (+ hot water valve), due to constrains all zones need wireless temperature control. zone valve 1 = 4 rooms / 4 rads zone valve 2 = 3 rooms / 3 rads zone valve 3 = 1 room / 1 ufh As far as I can work out i need the following: z1 (+ hw) = Wireless Smart…
-
Thermostat no longer works
For 6 years my Tado system has worked without issues. It is a simple setup, just a bridge and 1 thermostat. No changes made in the setup, but suddenly the Thermostat no longer works. Symptoms are the following: - Thermostat doesn't show the temperature if you press the button at the front. - No connection via the app on…
-
Heating
I have smart thermostats on all my radiators however whenever I turn the living room radiator on, one bedroom radiator heats up even though that thermostat is turned off. I have tried the usual steps like re-calibrating and swapping thermostats but the problem remains. The bedroom thermostat shows as off but still heats up…
-
Energy iq
Installed Tado and a new smart meter on same day Tado energy is saying usage 781kwh Meter reading 61kwh Anybody else with same problem
-
Tado rad thermostats pop off
I have danfoss ra valves and when the thermostats are installed onto the adapter it can pop of the threads, read that these adaptors are not a perfect fit and there is a metal alternative. Anyone know where I can get these metal adaptors? In the meantime I have had to use thread tape on the threads to keep the thermostats…
-
Drayton Wiser
I have had Tado coming up to a month and although it is working fine, I can'tget over issue is lack of local scheduling in the event of cloud failure etc. I think this is because I previously had Hive. I know with Drayton Wiser you can configure it to set up a local network enabling you to set/amend schedules in the event…
-
Hive to Tado wiring terminal mapping
Hello, I'm attempting to replace my existing Hive setup (SLR2 + SLT3) with a Tado Wired Thermostat, but I'm confused by the instructions. Here is how my Hive dual-channel receiver is currently wired: Note that it says NL1234, and with two other wires going into the earth by the side. But the tado backplace looks like this:…
-
Who has SRV's only on part of the system and how is it working out?
Hello, when fitting SRV's to half of the radiators or less, which rooms did you choose, why and how have you set it up to operate? I ask as I thought that it would make sense in my house to just do upstairs for now and keep them off a lot of the time like an upstairs zone but someone I spoke to recently told me he has them…
-
GAS kWh used.
Guy's, I'm interested to know what your GAS usage has been like, I have just ordered a Weather Compensation KIT for my Baxi 836 Combi Boiler (atm I am using OpenTherm), and I'm interested to know if you think I can get more efficiency out of my boiler, I have attached my GAS usage by day since December 2022, and I would…
-
Hot water schedule not activating
Hey guys, Had my system installed and working fine for the last few weeks. Last night Sunday as the clocks went back tado failed to activate our hot water schedule but everything else worked Cold shower this morning so not very happy. Working again now but why didn't it activate
-
Battery Life - Smart thermostat
Hello all, I’m experiencing a very annoying issue with my smart thermostat. At the moment I have to replace the three triple AAA LR03 almost weekly as they die. The thermostat is less than 10 metres from the Hub and is free from any dust or debris. I was wondering if anyone has come across any similar issues and how they…
-
Wrong temperatures
Our bedroom TRV is set to 16C but the app shows 20C. I have a digital thermometer in the room and it’s showing 12.5C. Please help!
-
Smart Radiator Thermostat Not Powering
One of my smart radiator thermostats (which I bought back in December) is now not working, despite working perfectly during the last season. It does not power up, even with brand new batteries, and everything has been checked with support and they have suggested a replacement. The issue is that although this device is…
-
Tado SRV's suitable for humid shower room or bathroom?
Hello, are the Tado SRV's suitable for a small shower room which will get very humid and possibly dripping condensation forming on some surfaces but no direct splashes or water? Or a bathroom, used occasionally for baths, which gets a damp atmosphere but again, no direct splashes of water from the bath? Shower room, humid…
-
Hot water comes on if heating on. But doesn't work on it's own
Just installed a Tado wireless thermostat, internet bridge and wireless receiver. The hot water works ok when the heating is on. When i put hot water on seperately, it tries to start but eventually the boiler just trips out and i have to reset it. The boiler is a Worcester Bosch Greenstar ri. I am thinking the 3 way valve…
-
underfloor heating pump control
Hi. I have a wired room thermo controlling boiler via digital controls. I also have wet underfloor heating that comes on via a flow item sensor so that when heating turns on and the underfloor heating sensors detects heat, it switches on. I would like to control the UFH with tado. I believe I cannot use the relay on the…
-
Water Heating 'pad' on app disappeared!
Just upgraded from an early Tado version that had failed after 6 years but the hot water pad on the app has disappeared. I have reloaded the app, no success, deleted and re-installed the app, no success. I see that this link was posted in an earlier thread…
-
V1 V2 V3 V3+ Hardware Version
Very simple question. How do I tell what version of hardware I'm running? Been a user since 2015 and retired my system while we had building work done, Now looking to run underfloor heating via Tado instead of existing thermostats but I need V2 or greater and I just can't see it. Sorry if it's obvious. Yes I can check…
-
Unfinished installation
Hi, I have just replaced my tado bridge, but after nearly 3 hours it is still showing as unfinished installation, I have pressed the continue Installation button but still not complete, cannot remove device to restart Installation, any ideas anyone?
-
Black smart trv?
I wonder if Tado will ever release a black smart valve? Drayton wiser have an anthracite version, I think Tado are missing a trick, especially with the popularity of anthracite now!
-
Battery Indicator
I get notifications about low battery for TRVs that show green / full battery status (from rooms & devices section). I've only ever seen full/ green, or empty / red. Is this the granularity if the battery indicator - basically completely empty or not completely empty? Related to this I've had low battery notifications…
-
Is the temp sensor talking to receiver
How can I check if the temp sensor is talking to the receiver, the actual temp in the house is about 4/5 degrees above the set temp, what's going on?
-
Do I need to replace my wired tado thermostat
Apologies in advanced I’m sure I’ll ramble. I have a wired Tado thermostat and internet bridge and Tado radiator thermostats. I also have an old boiler with separate water tank. Do I need to replace my wired thermostat with wireless plus the add on wired receiver to control the hot water? It seems to be a hit or a miss if…
-
Which adapter can I use for this valve?
Which adapter can I use for this valve? I have tried several, but no one seem to fit, which prevents me from installing the thermostat. The existing thermostat says "Caddy", but I can find model number or anything else. I have tried different 34mm RAV and RAVL adapters, but no one with a proper fit. I found one 34 mm RAV…
-
Boiler modulation on Worcester Bosch 38cdi classic erp
Hello to the community. I’m hoping someone more knowledgeable than myself can shed some light on this. I have had the above combi boiler for 5 years now and it has been controlled using the supplied Worcester comfort 11 RF wireless thermostat/programmer and the associated wireless receiver unit which was fitted into the…
-
my thermostat has stopped working- images below-- can you assist please? I have tried on another rad
My thermostat is unresponsive. I have tried on a different radiator also and changed batteries but it is still unresponsive
-
Why are my traditional TRVs not working well with TADO setup
I got a registered TADO installer to set up my new TADO wireless thermostat system. I now have 3 rooms where I have 4 new TADO Smart TRVs installed in areas where I need to tweak the settings regularly. They work really well through the app. I still use traditional Drayton TRVs in all other rooms and the wireless…
-
Can a faulty Extension Box (V1) cause my incoming mains supply RCD to trip?
With the extension box manually bypassed and L connected to 3 & 4, my HW & CH works properly albeit with no Tado control. With the extension box in place the RCD trips! Can anyone throw any light on the problem please? Tado chat says the extension box can’t cause the problem!
-
Radiator is always on when it is set to off
Hi, Please can you help. One of my Radiators turns on when it is set to be off in the Schedule. It also comes on when I turn on any other radiator. I have tried pretty much everything. I have taken out the batteries and put them back in. I have recalibrated the radiator. I have deleted it from Tado and reinstalled it. And…
-
iOS notifications inconsistency
1 - Open window reminder is active even if open window detection is disabled in settings. The option should remain greyed out, similar to geofencing: if Include Device's Location is off, notifications are greyed out. 2. Energy IQ - Reminder - all set to off, notifications still appear! Please sort this out.