-
TRV thermostats open without requesting heat for a back boiler stove
I have a back boiler stove that heats my radiators and hot water when we use it. - in addition to our burner Every time I do this, I have to unplug all the TRVs manually. My friends laugh at me because of this. Why is there not a mode to open the valves without requesting heat? This would also help with bleeding radiators…
-
Viesmann DHW Control - Set Temperature in ECO mode
I have Viessmann Vitodens 100-W B1kF connected via OpenTherm to a Wireless Receiver (EU) version. There seems to be a problem with DHW and I would like to share my experience after investigating and talking to Tado about it. I hope this suggestion will help others so that maybe Tado implements it. Situation Viessmann has 2…
-
my.tado.com : support for 2FA
Hi. There is a ETA for support 2FA for the accesso to my.tado.com ? Best regards
-
Air source heat pump linked to UK's Octopus Energy Agile Tariff
Tado should add the ability to heat up the water cylinder using an air source heat pump based on the cheapest energy rate of the UK's Octopus Energy Agile Tariff. This could save lots of £. It would need some AI or the like to spot what is likely to be the cheapest rate for the day, though that may be quite stable and for…
-
Use the zone controller name in the selection list
When you select the zone controller for your radiator thermostat, you only see the serial numbers. Can you show the room name of the controllers as well? That would make it easier to select the right one. Oh, and while you're improving that screen, there's no need to repeat "When this room calls for heat, this Zone…
-
Temp graphs in web version
Web version does not show the nice temp graphs that the app versions do. This should be added also to the web versions.
-
Connect to existing wireless receiver
I have searched this forum and looked at installation videos and general searches. It seems that despite many heating systems having wireless thermostats for turning the heating on and off, via a signal to a receiving box wired to the boiler, your system requires replacing this receiver with some slightly scary rewiring.…
-
more than one property
It would be so helpful if one could flip between two different places, each with the Tado system installed, without having to sign out of one account and into another.
-
Smart AC Control 10° setting
Supporting frost protection in the Smart AC Control commands
-
Energy IQ cost to account for standing charge
I find the estimated gas cost estimate to be reasonably good, but the cost shown is for the consumption cost only. It would be useful for option to include the cost of daily standing charge such that the total month prediction / comparison reflects the total bill for gas not just the consumption.
-
Standing charge for energy IQ
It is well know factor within UK for all the providers to charge daily charge (standing charge). Could you please include this option within Energy IQ to be able to set and see the graph with or without (with slider ON/OFF)to represent monthly charges. This will vastly improve accuracy or shown readings in correlation to…
-
Standing charge
It would be nice to add the standing charge as a feature.
-
Reset of meter counter
Hi, I have recently got replacement of meter device from gas company, and it has counter "reset" to some value that is smaller than last value I have entered in application. Current support recommendation is to delete all past records, and to start over from time when this meter was installed - with loosing all history…
-
Full TRV child lock
The TRV child lock is great for keeping the room set point unaltered but the TRV still lights up when played with. This is enough to keep my daughter entertained and means no manner how many times we move her away she still wants to play with the TRV next to the potentially hot radiator. I propose extending child lock with…
-
Short Boost
It would be very helpful if there was a ‘short boost’ feature, allowing users to turn a device on for a set period only (eg 30m). In my case it would let me heat my hot water outside its schedule without having to remember to turn it off again.
-
Launch a range extender or upgrade to mesh network
Tado ticks many boxes but it's behind the competition in its lack of signal booster / wireless repeater. I'm unsure whether to take the risk and buy the system for my relatively large stone house given the risk of radio dropouts. If I knew I could add a range extender if required, I'd have the confidence to buy. Perhaps an…
-
Multi Property Support
As a lettings agent, we'd like to be able to install Tado in several properties and be able to access them all from the same app, which we understand can be done by other systems. Is this something that is been worked on for the future, or will it never be implemented ?
-
Extend your gateway coverage
For those who are desperately asking Tado for years to add some range extender option to their product line-up, what follows may be worth reading :-) Recently, as I was in the process of adding TRV's in rooms located in my attic, I faced the "good old" historical coverage issue of Tado's gateway. The big issue is the fact…
-
Tado Widget
I don't understand why there isn't a widget for the app, to be able to see the situation at a glance would be easier that opening the app every time.
-
Switched Fused spur / smart plug controller
Hi, I really like Tado and we have smart thermostats on all our radiators. However, we also like our electric fire on in the living room from time to time. It would be nice if there was a switched fused spur or smart plug option so we could control all our heating devices through Tado. We could control the fire through a…
-
EnergyIQ to include Hot Water usage as well
It would be great to see Hot Water usage along the heating in EnergyIQ. Thanks
-
Add a hot water 1 hour boost button in app
To save going into scheduling for short periods or having to switch hot water off rather than defaulting to the next change please add a simple 1 hour boost button.
-
Show current temperature on TRVs
Would it be possible to have an option to show the current temperature on the TRV? I have the child lock enabled on all my thermostats and when you spin the wheel it flashes the programmed temperature. It would be nice if there was a way to nudge the dial and display the current temperature without having to open the app…
-
Show hardware version in the app
Simple suggestion, display the hardware version in the app along with the rest of the device settings. It might save a lot of support queries looking for this information!
-
Better control of away mode
Hi! I'm using my AC as a heat source for my summer home and away mode is very important for me. "Away mode" is not just "over the day", "while at work" in this situation but the major mode of operation. The problem I have is that you can't create time slots in away mode, so the AC have to stay on and cost money more then…
-
Change room colour in app when heating
Can the app be changed to highlight those rooms that are heating
-
Customers' data and statistic processing, storing, keeping and access
Dear tado° (community) I have a feedback-concern regarding privacy in your service. Recently I had a case with a malfunctioning (I believe so) thermostat head device. While the discussion is still going in that thread, I have another concern: during our conversation the support engineer mentioned: > The last time your…
-
Make Auto-Assist and Energy-IQ tiles active upon subscription activation in the Tado app
Hello, I activated my annual Auto Assist subscription yesterday, but the Active-Assist and Energy-IQ tabs remained the same (advertising the service). I had to contact support about this, just to be told that it is expected behaviour, and that data will get populated after a month. While that makes sense, it also makes for…
-
Smart home automation
Is there a way to set trigger for when humidity is at the set level to send notification via Alexa or Google or any third party integration? Ideal would be to look at the humidity inside and compare to weather forecast humidity level and if outside is lower than inside send notification to Smart home devices or phone to…
-
Recycle unused adapters
Hello. I haven’t needed any of the supplied radiator valve adapters, so I have 7 unopened packets. Be a shame for these to go to landfill. Many others must not use theirs. Can Tado offer a way to return so they can be reused?