-
Can I use multiple smart thermostats?
Hello, I have the basic Tado setup with the bridge, and one smart thermostat. I keep the thermostat on my ground floor, but the difference in temperature between the floors can be quite drastic so I'm thinking if it's possible to install another one which I could keep upstairs. I'd like then for the one downstairs to…
-
Have I bought the wrong kit??
Hi all, I purchased the Tado Wireless starter kit V3+ thinking it could replace my old mechanical thermostat and programmer. I assumed I would have to disconnect the old thermostat but the guided instructions don’t mention anything about it and Iv seen various information stating it has to stay connected or at least…
-
Vaillant eRelax termostat with Tado
Hi, I've Vaillant erelax termostat already installed in my home. I buy 7 pcs tado radiator termostats and installed to all of my radiators. The problem is; i would like to disable (always full open) the valves which room that my erelax device in. But i couldn't see such a selection in tado app. If tado closes all of the…
-
Wirder Smart Thermostat, screen is not working?
Istalled just two wired smart thermostats, the first one can show "hi!" and reacts when replacing batteries. I tested also with new batteries. It does not respond anything I try to do manually. Not, if i press button shortly, 3sec, 5sec, 10sec or even 30sec. From app it works, but not from thermostat itself? Is there a…
-
Geofencing not switching heating off
All, Had the system about 2 years all rads on TRVs. Issue is, when I am away, the app shows away, but the heating runs in a sort of “low mode” maybe 15-17 degrees. Why doesn’t it just shut down when I am out. I used to do this, but something changed.
-
Tado is getting worse at tracking my location
I have been noticing Tado stays in Away mode when I come back home and only switches to home when I actually open the app. This happens both on my and my girlfriend’s iPhone. We have the location set to ‘always’ and ‘exact location’ Has anybody noticed the same thing? I switched from Nest to Tado 4 years ago because Nest…
-
Use Tado with shunt valve steering
Hello I am trying to validate if my Tado wired thermostat will be compatible with my setup. I have geothermal heating heating water in a accumulator to a predefined value, on the tank there is a motorized shunt valve that can be controlled via either outdoor sensor with curve steering or via an indoor thermostat. Currently…
-
TRVs constantly cycling zone valve
I have got a wireless receiver and two wired thermostats all based in the garage working which replaces three nest heat link 3rd generation, one for each heating zone. 1) Wireless receiver- controls ground floor zone valve and hot water. Has wireless temperature sensor in office on ground floor. Doesn’t seem to have any…
-
Ref.: Se pueden manejar dos termostatos en dos casas diferentes?
-
Viessmann 100w boiler and Tado setup
Hello everyone, Im a bit confused at the moment regarding the Tado setup. I hope you guys can help me understand the Tado equipment. I'm from the UK and my boiler details are below: Viessmann Vitodens 100-W 35kW Combination Boiler Natural Gas ErP - B1KC025 I was advised by Tado to purchase a Wired Smart Thermostat with a…
-
Tado heating and solar power
Hello. I have been thinking about this for a while and Inm not shure what is possible. I have central heating in my house with a gasboiler completly controlled by tado. But I also have a electric split airco system that also can be used for heating. This is especially usefull on sunny winterdays when I can run on solar…
-
Geofencing Hot Water
I have a hot water tank in my house, with Tado setup to heat water in the morning before I get up, and again in the afternoon before I get home. If I wish to have Geofencing setup, to only turn my heating on/off, but not affect the hot water. I don't want to come home later than usual and find I have no hot water. It seems…
-
Connect via controller
Hi all - I want to connect my Tado wireless stat, via extension to my Horstmann Centaurplus Cll timer/controller (connected to Vaillant combi boiler). Does anyone know the wiring for this. please? Thanks, Chris.
-
Smart radiator thermostat - reliability of reading- Help!
I’ve had the wireless starter kit set up for a couple of months now and have just purchased my first smart radiator thermostat (what I hoped would be the first of many). I’ve installed it in my daughters room. I’m after some other peoples experiences really. Now, when the heating is not on the room (measured by a…
-
Worth getting TRV for bathroom towel radiators?
I have 6 radiators with the smart TRV, plus one without it - to act as a bypass? I'm not sure if that is required, but there you go. I'm wondering about the 2 bathroom towel radiators, currently I guess they are effectively acting as a bypass as well, but this means they pull heat when any of the others request it. Should…
-
Three zone setup wiring with ebus
I have purchased a wireless starter kit and two wired thermostats to control the three zones in my house. I have a vaillant ecotec plus 637 from 2020 which I’m hoping has ebus and hoping I can take advantage of that. My system is an a plan setup with an unvented hot water cylinder. I currently have nest controlling the…
-
Single Smart Radiator Thermostat overwriting Wireless Temperature Sensor for whole house
Hello, I had a single wireless temperature sensor setup in the hallway which I had initially used for heating up the whole house (as it came with the kit). It worked fine, with all the radiators starting and stopping when they were meant to. To make the system smarter, I have recently installed a smart radiator thermostat…
-
No remote access in two rooms
I'm getting a no remote access for two rooms that are furthest away from the bridge / router Im guessing its due to the distance. is there anyway this can be resolved by any accessory etc?
-
Bridge not connecting - need some technical information if possible
My full fibre network operator rolled out an update to their network which has killed my bridge. The "cloud" LED is now constantly flashing. The router logs are sparse and do not give any clues and I'm hoping that someone here is able to tell me the ip address that the bridge connects to so I can pass that information to…
-
Wired and wireless thermostat use
I have a wired thermostat in the hallway which means the sitting room is dependant on the hall temperature. Is there a wireless thermostat I can get which would override the wired thermostat if required?
-
Worcester Greenstar Boiler always on
Hi Anyone with any experience or solution for the following: Woke this morning to the house melting hot as the gas boiler was firing away. The smart schedule was set to heat to 16oC overnight (app indicated that no call for heating had been made in that time) however House was sitting at 23oC and boiler appears to be…
-
Trvs calling for heat but Tado doesn't activate boiler until hot water comes on
Hi. In the app I can see some of my 6 trvs calling for heat but the boiler and pump are silent. However if Tado settings call for hot water ON then everything kicks in and both HW and CH heat up. It's like Tado is ignoring my trvs. All of them point to single controller
-
Boiler on but radiators aren't?
I've just set up my new tado wireless smart thermostat starter kit and 2 RTVs. They're working fine in that if they're below the required temperature they can trigger the boiler (logic combi) to turn on however the radiators remain cold? Prior to installation I had two thermostats in the house controlling different zones -…
-
Modulating boilers with S-plan DHW
Hi All, A quick one just to ask if it is possible to have Tado dictate two separate outflow temperatures depending on what is calling for heat. For example, can I have my S-plan system with multiple heating zones and a hot water cylinder set up such that if only the radiators are calling for heat then tado requests a low…
-
Keeps login off the app
Hi Tado fellow-users Anybody still haves trouble with app signing off (every day in my case), needs to re-claim my phone and going through the geo-fencing questions? We are 2 persons in the household using the same username and 2 diff. mailadress in 2 seperet phones. My wife has a iPhone and I have Huawei Honor 10.
-
What's the remaining Smart Valves remaining position when getting out of battery??
Hi, I'm a relatively new Tado user with a multizone system with multiple Smart radiator valves, and I'm tracking how long the batteries last for which I've seen some other posts; so far I'm seeing a batt lifespan of about 2-3 months which is slightly worrying. The idea with a multizone control is powerful but the achiles…
-
What is needed to connect Tado to my boiler
Hi there I have tado smart radiator valves throughout the house and the bridge connected to the router. Im now wanting to replace my valiant vsmart system on my valiant ecotec plus boiler so tado can control the boiler when specific radiators in the house need heat. Which of the add on’s would I need to do this and why?
-
Frustrated with my Tado setup, numerous issues
Hey guys, I came here looking for advice for a few annoyances I've started having with my Tado system and fallen into a rabbit hole because it seems that these are fairly widely reported and nobody seems to get anywhere with Tado themselves. I don't mind finding technical issues with products as long as the company behind…
-
Using Tado with Daikin air source heat pump.
I have replaced an old oil-fired boiler with a Daikin air source heat pump. However, the heat pump is objecting to the short on-off cycles that low and medium heat demands are calling for. High heat is fine. I’m told that the minimum on time and repeat time can be set by Tado, but I’m not sure what values to request. I…
-
Is it safe for the boiler if I have a smart radiator valves fitted to all my radiators?
I am thinking of installing smart radiator valves to all my radiators but my plumber says that is a bad idea and risks overtemping the boiler. Because if they all close off, the boiler could get damaged. It appears I do have an auto bypass valve fitted to the boiler system, so I can’t see the problem. He says you should…