-
Ext kit replacing danfoss RX1 (vaillant)
Hi Ian a little confused on fitting my extension kit. It’s replacing a danfoss RX1 wireless link on a valiant exotec pro boiler. The set up instructions look like they won’t work with vaillant ebus. Is this right? I have pic of the current wiring but can’t seem to post it
-
Out of reach of the internet bridge
I have a problem with two houses, where house no. 1 has the fibernet entrance (1000mb/1000mb) which is cabled to house no. 2 where the wifi is controlled by 3 mesh routers (all cabled), TP-link Deco x60. House no. 1 is fully controlled via the TADO internet bridge and fully working, while house nr. 2 Thermostats sends "no…
-
Waterproofing a bath radiator thermostat
Hey guys, I need to install a Tado Smart Radiator Thermostat on my bath radiator, but it's close to the shower, so occasional splashes of water are a possibility. Have any of you encountered similar issue? How would you proceed in similar case to waterproof the Smart Radiator Thermostat?
-
I have recently changed router and now the system although it all looks connected is not activating
I have a Bridge older one, smart thermostat and extension kit. All were working ok. I changed internet router and re connect it all. All lights etc show connected and I appear as in my home on the app. When however it should be heating up it doesn't demand heat? The temp is going down and can't get it toter the heating…
-
Installation
Hi everyone! Iam new to this so hope this makes sense.. I purchased a Tado kit over a year ago and could not find the relevant info to install which is why it’s been forgotten about til now! so here’s hoping someone can help ! I have a Vaillant ecoTEC plus 831R1 combi boiler with no thermostat or timer it’s manually…
-
Best way to use geofencing with stored hot water
I've recently installed Tado on a central heating system with stored hot water whereas I've previously used it central heating with on-demand hot water. I'm struggling to work out how best to manage the hot water control as rather than the two conceptual home and away states that make sense for the heating side, I've…
-
Wireless temperature sensor help?
Hi! I recently purchased a tado starter kit mistakingly thinking the wireless temperature sensor was a thermostat… but yeah. Basically I’m wondering if you have the wireless temperature sensor and the wireless bridge which is connected to the boiler, does this override the already existing default wired thermostat? So for…
-
Vaillant hrPRO Cw 4 stays ON
Hi, I have tried a Settingls Opentherm : D01 : Works I mean it starts my boiler automatically but the when the temperautre reached or if I reduce the temperature still my boiler stays on and on (I can here the noise of the boiler when it is boiiling) can you please suggest if I am doing correct setting of Open therm (D01)…
-
Heating comes on when I press water
I have just installed a new tado system with a wireless receiver. I've triple checked the wiring and all seems okay. However, when I press the test heating button the heating doesn't fire up, yet when I press the test water button the heating fires up. Is this something anyone else has encountered and if so is there a…
-
Installation
Hi everyone! Iam new to this so hope this makes sense.. I purchased a Tado kit over a year ago and could not find the relevant info to install which is why it’s been forgotten about til now! so here’s hoping someone can help ! I have a Vaillant ecoTEC plus 831R1 combi boiler with no thermostat or timer it’s manually…
-
Configuration of TADO with district heating.
Hi, I have a new home with district heating. I have 2 pipes, one with hot water and the other is the return. One valve is connected to the pipe and I just need to open this valve to have heating working in the apartment. I connected NO ( normally open) and COM (with neutral) to the thermostat and then the corrected wiring…
-
Can’t get into tado
I was connected to my tado at my lodge my son in law did it whilst staying there all worked fine til he went home to his mums and logged onto her tado next thing is I’m logged onto her tado and neither one of us can access the lodge now his mums partner kicked us both off so I’m not sure what is happening every time I open…
-
TRV Mounting issues
Given that Tado support refuse to answer I thought I'd try the question on here. One of my TRVs recently reported a low battery. However, after replacing the batteries I am unable to remount the unit properly. I keep getting messages that it's not mounted and spanner symbol lights up. I've tried all the options in the help…
-
Mounting radiator thermostat
Followed the guide to pair and re mount radiator thermostat but the spanner icon still remains! What shall I do?
-
Smart Rad Thermostat Won’t Mount
One of the four SRT’s I’ve just bought won’t mount whatever I try. It’s definitely a problem with the actual mounting itself because I’ve tried the SRT on other mounts and it has no problem mounting. But it doesn’t matter which SRT I try, none will mount to the mounting. Sick of the word mounting now :# Has anyone had this…
-
Replace existing system with Tado - is it possible?
I currently have an RF Heating system from Ember which has: 2 RF Thermostats 1 RF 2 Zone Programmer 1 Gateway (which allows for app control). The system is a combi boiler which has a the 2 Zone Programmer connected to a wiring centre which is also connected to the Motorised valves (1 per zone) and to the combi boiler. So…
-
Wet UFH on a separate zone
I have installed Tado in the house and it's worked great. I currently have 10 zones all controlled by TRV's On my Gas central heating system, I have a separate zone for a wet UFH system with 1 zone. This has a separate thermostat.(Salus RT500RF) I haven't managed to work out what I have to do, or even if it's possible to…
-
Wireless thermostat and radiator thermostat
I purchased the V3+ starter kit with the wireless thermostat, internet bridge and radiator thermostats. I have installed the wireless thermostat in my livingroom where there are two radiators. I want the wireless thermostat to "control" th radiators vis the radiator thermostats? Is this possible?
-
Bug report: "Heating Activity" incorrectly includes activity from independent heating zones
I have a single boiler and thermostat, and a variety of SRTs/TRVs. All but one of the SRTs/TRVs are in the thermostat's heating zone and the "Heating Activity" looks correct in these cases. However, the one other SRT is deliberately not assigned to a zone controller (and is instead set to "Independent") because I'm using…
-
I'm about to get a Air-to-Air heat pump... will it work with Tado?
Hi, I'm moving to a new house, I'm used to the smart thermostat but where I'm going there's a new garage with space for a big office where I will install a heat pump. As I still have to buy it and ask to be installed, I was wondering, why not get one that works seamlessly with Tado now, rather than trying to get help to…
-
No internet bridge in new house set up
Hi all I’ve just moved into a house with Tado. The boiler is set up and I have the thermostat box, but no internet bridge to link it all. Do I need to buy all of the system again or do they work independently from each other?
-
Extension showing 'Connected' in app when turned off
Hi there, How long do I wait? I turned the Extension Kit off while trying to track down the cause of a pattern of LED blinking which I cannot identify. Strangely, though, the Extension Kit still shows as 'Connected' in the App, even tough the power is off and there are no LED light at all... regards, Allan
-
Advice before purchase
Hello to the community, I’m looking forward to moving to Tado, but I need some advice/confirmation of my plans before purchase. I currently have one Nest wireless thermostat and “dumb” thermostatic valves in all rooms/areas. I want to move to a system where each room has its own schedule and temperature control, which I…
-
TRV active when system off (Frost Protection)
I’ve recently installed Tado and have TRV’s, two in one bedroom and one in another bedroom. The weather’s warm so everything is switched off (frost protection). The other night, about 03:30 all three TRV’s performed a couple of rotations which woke us all. What would cause this? I thought maybe it was a temporary loss of…
-
How does the app work
I`ve downloaded the app to my Ipad but can`t any further than add zone/remove zone. What information do you put in the add zone,is it my home address or something else?
-
Username and email
I need to change either the username or email address for this account on the forum. Drives me nuts when a forums has no apparent facility for doing this but maybe I'm missing the obvious. So can anyone explain how to do either of the above. Or even delete this account on the forum and I'll start again.
-
Wireless -> wired thermostat? Or buy a new one
I've been having two wireless thermostats to control valves and now I'm moving to the new apartment with the floor heating. I see, TADO suggests to buy new wired thermostats, but what I see on the back side of my thermostats are the opened connectors and I suppose, they are used for wired connection in the wired version.…
-
Siri defaults to “cool” mode
Hi there guys, I have a Tado Smart AC Control firmware 59.5 and iOS 14.7.1 controlling a Daikin Zena split aircon. Everything works ok, except when I use Siri to turn on my heatpump. If I say “Hey Siri, heat up the kitchen to 25 degrees”, it turns the heatpump on in the “cold” mode, despite Siri responding “ok, heating to…
-
Thermostat instructions
There were no user instructions in with my v2 smart thermostat. I've got it installed OK using the instructions on the website, but where can I now find usage instructions?
-
What do I need to connect to the hot water tank?
My boiler has 2 zones, one for house, one for hot water. The current system (not Tado) seems to have some temperature sensing device connected to the hot water tank and another wireless thermostat that is in the house somewhere. When I go for Tado, I understand I will need the Wireless starter Kit…