-
Switching to electric boiler
I had until yesterday a system boiler that did both my hot water and central heating. I have installed a fischer aquafficient battery water heater and on Monday will have commissioned an 8kW WHBMULTIKW heat only from Fischer. I have a solar array and batteries so electric is more efficient to me than gas. I have an…
-
I have a radiator and the thermostat regulator contains a remote sensor in it.
I have a situation in my living room where there are two radiators controlled with one thermostat. The thermostat they have used looks like the one in the pictutre below and I would like to replace this one with tado smart thermostat and wondering how to include the remote sensor into the feed? Is this even required in…
-
Smart thermostats not controlling correctly
Hello, I've installed six smart radiator thermostats along with a wireless temperature sensor. I've also set up a wireless receiver and internet bridge, both of which are confirmed to be working. However, I'm encountering a significant issue. When I request heat for one thermostat and set others to frost mode or off, the…
-
Wireless Receiver Offline Strange Behaviour
Had my Taco installed for just over a year and has worked mostly fine. There's been a couple of occasions annoyingly where a temperature change as part of a schedule has not been sent to the Wireless Receiver, but by the time I've noticed it's all online and working again. Yesterday the Wireless Receiver went offline…
-
Combining a wired thermostat with wireless receiver?
I have an F&E system boiler comprising of: Kitchen: Gas Combi boiler with a wired thermostat in the living room 1st floor: Hot water cylinder with wired hot water and heating controller Attic: Cold water tank I have purchased: 1 x Internet Bridge (to be placed in basement) 1 x Wired thermostat to replace the living room…
-
Looking for some installer help...
Currently I have an deal Logic Combi2 C30 wired up with x2 Danfoss TPOne-M thermostats in dual zone (Upstairs and Downstairs) How would I go around getting Tado installed with dual zone and OpenTherm? Currently I bought two wired Tado's but think these are just running as on/off
-
Tado V3+ EU & Ideal Logic+ 24 Combi Setup. [UK]
I've currently moved into my first home and am looking to install the V3+ StarterKit. I've read quite a few posts here and still find myself largely confused with how to proceed. ( I have absolutely zero experience with any of this stuff ) I'm in possession of a Ideal Logic+ 24 Boiler which is OpenTherm compatible, and I…
-
Equipment List and Setup Query
Hi All, We are undergoing some building works and i am trying to plan my new UFH systems to help explain to the installers how i think it should work as part of switching to Tado which they are not familiar with. Is the below correct and what equipment would we need to achieve the below? The two extensions are having UFH…
-
Tado installation
Hi completely useless at this bought a wireless tado V3 starter kit but I have a wired thermostat in my hallway does this mean i have to get a wired tado thermostat instead of this wireless V3 one I bought and whatever one is needed how easy is it to setup or install. Thx in advance
-
Default settings for manual overrides
Am I the only one who keeps everything turned off and manually turns up a room of cold? The trouble with the way the app is configured for this way of working is that the default is to leave the room at the manual temp you set until the next scheduled change… this can mean it’s on for ever and defeats the objective of…
-
Wiring Sanity Check
Hi! My house has two heating zones, upstairs and downstairs, and a combo boiler so there is no hot water control. I'm replacing the existing in room thermostat with a Tado wired thermostat. The existing wiring looks like I was going to wire the Tado wired thermostat as: Old -> New N -> P1 L -> COM NO1 -> NO Strip back the…
-
Has anyone succeeded in making a ideal logic c24 work with Tado. I’m having issues
I have followed the instructions and I can’t seem to get tado to control the boiler.
-
Unable to connect on ipad
Old fella struggling to see Tado on ipad. 1. Works fine on my win11 pc and win7 laptop, all rooms visible and controllable. But on trying to get on my elderly ipad it will not connect. 2. Worked fine on my ipad several years ago but after bringing out of long term mothball I cannot login. 3. On page ‘app.tado.com’ it…
-
Tado installer in Cambridge
Can anyone recommend a Tado installer for a gas combi (logic heat h30) in Cambridge? Thanks
-
Can I use a Tado Smart Radiator Thermostat with: 'Danfoss FHV-R' ?
Can I use a Tado Smart Radiator Thermostat with: 'Danfoss FHV-R' ? (Regulating Combi Valve) As a replacement for a 'Danfoss FJVT'. https://assets.danfoss.com/documents/75214/AI147986474603en-010701.pd…
-
copy of online receipt
how can i get a copy of my receipt - bought my system from your online shop dave
-
System not operating as per schedule
Hi, I installed my system last year consisting of a wireless temperature sensor and 8 smart Trv valves for each habitable zones. It's installed on a bridge with a WiFi module connected to a Worcester Bosch greenstar 26i junior. It had been working fine. Now, it's not controlling on the schedule correctly. Once it reaches…
-
Garantiebeleid Tado
Na net iets meer dan 2 jaar na aanschaf van mijn Tado-systeem heeft een van mijn radiatorknoppen een probleem. Na uitgebreid overleg en opsturen van talloze fotos en videos concludeert Tado dat mijn garantietermijn van 2 jaar is overschreden. Ze bieden niet aan de knop te repareren (ook niet tegen betaling) en er is geen…
-
Controlling UFH main flow using tado radiator valve
Hey tado friends, I have tado set up in all rooms with radiators and then underfloor heating downstairs. However the UFH is not running as smooth as I hoped. The valve that control warm water flow into the UFH is a dumb knob which I have to set manually. My idea was to set a tado knob on that valve and then sync it with…
-
Internet / Wifi Keeps dropping out since installing Tado
I installed the Tado Starter Kit V3+ (EU version) last week. Since then my wifi connection keep dropping out on all my devices, phones, TVs, tablet, laptop. through out the day. Some days are worse than others with more frequent dropouts. the drop outs usually last a second or two while devices reconnect, but sometimes it…
-
Connection to boiler non digital.
Can anyone help with the following after doing a system check I’m getting the following errors, can anyone give me advice on how to fix / change the wiring to a digital connection? Thanks 🙏
-
Can I find a wiring diagram for a Hive to S plan Tado receiver?
I'm replacing my Hive system with a Tado wireless system - both with hot water. I have an S-plan system installed on an Ideal Vogue Max boiler. When I wire the Tado Receiver I need to know the difference between the S and Y wiring.
-
Nest to Tado - Just Checking
Looking at these 3 pictures (wiring/Nest Pinout/Tado Pinout) . I think that the 12v to the Thermostat are redundant since the Tado doesn’t support that as it’s battery only. Earth gets added to earth on Tado (obvious) .. No idea what “Parking” is … Connect N &L from Nest to the N & L on Tado simply connect wires from Nest…
-
Over target temperature, still heating
From the start of this heating season, I've been experiencing Tado intermittently over heating rooms As an example, the room I'm in at the moment, the target temperature is 20c, but the temperature is 20.5c and going up. It's only room active, Dashboard notes "Heating to 20c" and boiler is firing. I've had to intervene a…
-
TADO v3+ wired with Vitodens 111-W B1LF Opentherm
Hello, I've just got the TADO v3+ device (wired) to replace my Honeywell Home T3. The system is currently wired on the ports T-T in Opentherm. From the doc, I know the correct configuration for TADO is "D1". However, both wires are black! How can I know which one should be on the digital "+" et which one on "-" ? I've read…
-
Radiator compatibility
Hi I have installed a Tado wireless starter kit V3+ this afternoon. I replaced a Drayton SM2, very old Honeywell thermostat and the boiler is a Worcester Greenstar Ri (I forget which number only just moved in) the hot water is a separate tank. Hot water works fine but the boiler won’t fire up even though the app thinks it…
-
Tado radiator valve under a desk
I have an office room with a desk on top of my radiator. It has a grill to allow for air flow, so it is not completely covered on top. The front-side is also fully open, so nothing obstructing that. I've installed an Tado radiator valve on it, I've added an offset to the room (-2.5 C seems to be as close as it can get),…
-
When can we expect multi-home feature to be ready for use?
When can we expect multi-home feature to be ready for use? We would like to be able to manage more than one home/location from single account/app. Is this feature on the list to be implemented or not? Thank you.
-
Auto Assist Subscription - Multi home
Hi, I have two homes with tado, both using different email addresses. I use both on a set of devices which are under the same Apple ID. When I purchased the 2nd auto assist subscription, the one for the first house stopped working. I can only see one active subscription in my Apple Subscriptions page. Safe to assume you…
-
How do I use Tado in two different houses
I have 2 tado systems and would like to install them in 2 different houses, how do you set up the App to do this or do you need to set up 2 accounts with separate e mails ?