-
Display on/off on home screen
It would be good if we can see which radiator is on or off without having to click into the room.
-
Comfort Zone - Change comfort temperature display
I find 20 degrees too hot for “comfort” and prefer to be able to adjust when it shows as orange and when it’s too cold or hot for ME. Comfort zone is a known Zone, not absolute and different for different people, what is hot for one person might be cold for another. Our comfort temperature changes in response to the…
-
Unlock SRT manually
Would it be possible to allow a feature (that can be activated or not) to manually unlock the SRT using a 3 digit “code”. You could configure a code in the app and then input it using the SRT, turning it up and down in a certain sequence (like for safe) to input the code to unlock it when you don’t have your phone.
-
Master temperature
I’d love it if there was a way to have a unified master temperature. It’s always baffled me why you would not have the option to set the temperature of the rooms/thermostat and then just alter the on off times.
-
Heating to text size
Please make the heating to text size and font colour more readable.
-
Add Sunrise/Sunset to Graphs
By adding sunrise and sunset to graphs would allow most novice users to understand the natural thermal gain/loss purely from outside temperature and pressure on their homes and differences to different rooms. B)
-
Bring back Modulation (OpenTherm) to their wireless thermostat (UK)
Currently only the wired version supports modulation (OpenTherm) where as the wireless version in the UK ONLY does not support modulation. The EU version does. I think Tado should bring the EU version features to the UK product. It's essential for energy saving and would add more competition to the market and make Tado…
-
Hot water control when away
At present if your geolocation setting is set to away then the hot water status can either be on (constantly) or off. This does not work well if you have a regular heating pattern for water (say 3 times a day) and you are out during one time period which stops the heating cycle. It would be better to give an option to…
-
Option to submit meter readings using ft3
I have quite an old gas meter and the display works in ft3. Is there a way, or can there be a way to use ft3 for readings in the Tado app?
-
To support measurement units ft3
As soon as I subscribed to the auto-assisted plan, I cancelled it. Why ? Because it does not support measurement unit ft3. Tado PMs and senior executives probably not understand the fact that smart meter owners usually have what Tado Energy IQ is offering from their energy suppliers. Tado should aim as the gap in the…
-
Smart AC & Smart Thermostat/Radiator integration
Hey, I am using Thermostat and Smart Radiator since my house has central heating, but for cooling reasons I need to install two AC's LG Split, more to cool than heating because I already have a central heating system. I am thinking of adding Smart AC Control to my Tado System so that I can integrate everyone on the same…
-
Smart AC control V3firmware 103.3 does not support quiet mode
2 x Panasonic AC & 1 x mitsubitshi A-A, all with quiet mode, which is one of the reasons they were bought. unfortunately Tado seems not to be supporting "Quiet mode", lowest setting on the fan speed does unfortunately not do it. request for this feature has been going on since 2021, how long time will it take to fix it ?…
-
Multi home
Please will you rewrite the app so that you can use Tado in several homes from the same app using the same names, passwords and login details
-
Smart meter integration
Smart meter integration for the uk market and maybe world wide for better understanding of energy bill within the app
-
easier accommodation of Landlords for BTL properties
Hi, I have Tado in our home. We have smart thermostats on all our radiators and I really like the system. I am also a landlord for 2 BTL properties and wondered about setting it up in them. I can't see how to go about this with the current system. I wouldn't want tenants to pair devices to their own account, because…
-
Booster
I think it would be a good idea to have the option to add or remove the booster button on the app as some time it get pressed by mistake and it cost a lot more to use as well due to high prices of gas
-
Open thermostat with empty battery.
It would be very helpful if there was an option in the app to leave the thermostats open (perhaps with a choice of 0-100%) when they run out of power. I currently have three thermostats, one of which constantly reports that it's out of power even when it's not, and this one also runs out of power much faster, requiring a…
-
Helpful for Tado to revert to the original temp when turned back on again, not just the default 21C
As you can see from the screen shot below, on a Friday there are 7 different time / heating slots in one room - all of which may need to be turned off when occupied and then turned back on again - often on an alternating weekly cycle Ideally there would be a second Heating on/off toggle switch that works for the entire day…
-
Automatic temperature/ventilator speed for TADO Smart AC control.
A growing number of people use air conditioners (AC) to heat their houses (cheap, available, efficient). Temperature measurement is done in the AC unit, close to the ceiling of the room.This location results in poor temperature control in the room (stagnant warm air layer). With the TADO Smart AC control you can measure…
-
Colour coding for rooms heating up
Can I suggest using a different colour in the app for those rooms that are heating?
-
Enable manual override timer when 'Turn off all rooms' has been enabled
I am writing this as the 'Turn off all rooms' button looked really useful but then if someone turns up a rad it will just stay on rather than turning off again in line with the manual timer selected. For example select 'turn off all rooms' in summer and if there was a particularly cold room or cold night then anyone in the…
-
Improve "Climate Report" graph
The horizontal grid lines in the "Climate Control" history graph currently behave very inconsistently and are not very clear to work out the temperature from. There are three fixed lines, the top and bottom have a label which varies depending on the range of the currently displayed graph, but by having fixed lines, this…
-
Verbetering usercase Slimme Aircobediening V3+
Ik gebruik de Slimme Aircobediening V3+ in combinatie met een Fujitsu Airco installatie. Deze Fujitsu heeft een aanzienlijke afwijking tussen de waargenomen temperatuur en de werkelijke temperatuur waarbij de Fujitsu een tot wel 5 graden hogere temperatuur aangeeft dan de door Tado gemeten temperatuur. Doordat de Slimme…
-
hrll
safacasfvasfvasfvcasgfvsdgbsdgbsdgbsdbsdbsdbsd
-
Clearer indication of what rooms are currently heating up
Hi, I hear the heating coming on in the house and I want to know which rooms think it is too cold - as I want to see if I agree that it should be on and potentially reset their temperatures for the future. However, the home screen on the app only indicates in words "heating to...". Each room colour is set to green, amber,…
-
Daily schedules
Ability to have a different schedule every day if you want. And the ability to save the schedule to be repeated by month/season so it is easy to change betwee different schedules throughout the year very easily.
-
App display bug
I have two radiators in lounge that have linked tado smart valves. Recently, I found that one of the radiators was not getting warm. Investigation showed that the return spring on the valve pin had failed and the valve was stuck down. Because I couldn't get around to depressurising the system to swop out the valve, I…
-
Schedule by month/season
Ability to set schedules for a wider period than monday-sunday. If I cud set every day for the calendar year would be helpful/batch up months and seasons. Easier!
-
App “Advance” button
I have a suggestion for the tado app. On my old boiler time controller I had an "Advance" button that advanced the settings to the next time period and then reverted back to the normal schedule once the next time period finished. On the tado app to bring on the heating earlier than scheduled, I think I have to go into…
-
Improve reception range of the Bridge
The connection with the radiotors is often lost. The Bridge has a short range. A more powefull Bridge or a mesh system would be great