-
Heated towel rail
I have an oil fired combi boiler and five radiators. All 5 radiators have tado thermostats. There is additionally a wireless Tado smart thermostat in the living room (connected wirelessly to the wired extension kit. They are all working as they should, bar some hiccups with one of the radiator thermostats. But we also have…
-
Wiring smart thermostat EPH R17
Hello everybody! I was installing my wired Tado and while taking off the mask from my previous thermostat (EPH R17…) I noticed there are different bridges and cables around. Basically in my configuration I have 2 cables in N, 3 in L (one to the main Live, one to an installed fuse, and one bridged to COM), 1 in NO, and 2 in…
-
Accuracy of Tado
I’m really live my Tado system but I’m really struggling to understand the accuracy of it. I have no doubt that it balances the temps of my rads to what I have set - when I want. But on the other side of the coin it’s telling me that of my £308.44 gas bill last month - only £22.14 was for heating! My smart meter tells me I…
-
4GEE Wifi Mini Connection Issues
Hi, I've recently bought and set up a 4GEE Wifi Mini to use in an unoccupied house to be able to use Tado smart heating remotely to make sure the heating works (temperamental boiler I'd like to keep an eye on). I've connected a TP Link wifi extender with an ethernet port to the 4GEE wifi, and use this to connect to the…
-
how to set up valve fully open?
is there a setting option to set up valve openning style? currently I noticed it can open in 3 levels 1 2 3 bars. although it seems sensible to do in this way to make temperature changes smoothly. However the result for small and big rooms are quite different. you should make judgement on the room size by measuring the…
-
Thermostat differential.
I've had the starter kit v3 for some months which all works fine except the room thermostat differential varies wildly and can be as little as 0.1 degree or even 0 degrees. The wireless receiver is in the kitchen so I can see it going on and off. Anyone else had this issue as it seems to be wasting a load of gas heating…
-
Tado Android app crashing
New Tado user here. Just installed 4xTRVs in 3 rooms plus bridge. Tado app installed on Android mobile phone (Xiaomi 12/Android 13) and Android Tablet (Xiaomi Pad 5/Android 12). Phone App works fine, Tablet app keeps crashing. I can deinstall, reinstall and start again and it sort of works for a few hours, but 2 of my 3…
-
TRV not working after battery change
Good evening, I had low battery warnings on 4 of my TRV’s. I change 2 successfully but the other 2 are unresponsive following the battery change. Any ideas?
-
Bridge location
For confirmation do the TRVs communicate with the bridge or the wireless receiver or the router? If the bridge, can a bridge be plugged into a repeater? - my bathroom TRV which is furthest away from the router tends to lose contact a couple of times a day... i have a range extender in the middle of the flat which all…
-
Heating but No Hot Water
Hello, I'd very much appreciate any advice here. I recently purchased the Tado Starter Kit V3+ Wireless Smart Thermostat (incl. programmer with Hot Water Control). I also purchased Radiator TRVs. We have a Pumped heating system with Gravity Fed hot water system. Our previous Danfoss programmer indicated Pumped, and our…
-
TADO burn times.
I’ve now got 4 TRVs on the rasa testing them today-so far so good. 1) With regards heating if you install more TADO valves does the box get predictive and start giving you longer burn times? I’ve asked helpdesk if TADO can change fan speed and they say no-but can they change burn times instead? and are they useful?
-
Setting temp via Alexa always disables Resume Schedule at next time block.
When you manually override the schedule in the App, it normally defaults to resume schedule at the next time block in that days schedule. However, when setting the temperature through Alexa app, it seems to default to use the "Until you resume schedule" mode, so that it never reverts back without manual intervention. Is…
-
Setting Up Tado with UFH and Radiators with Vaillant Combi Boiler.
Hi, Hoping someone can help me here... I'm a pretty capable individual with DIY having done a few home renovations myself... however when it comes to this Tado system (which I have already purchased...) I'm kind of in limbo on how to set this up... Setup thus far. Boiler = Combi - Vaillant. I have a 6 way manifold with…
-
Is it possible to install 130 smart radiator valve sensors in one apartment building.
Is it possible to install 130 smart radiator valve sensors in one apartment building. We want to control all sensors from a central point.
-
Device not working
One of my radiator thermostats isn’t working - or at least, whilst it’s mounted. I can reset it and it wakes up, but the very moment I slide it onto its mount the thermostat becomes unresponsive
-
Boiler isn't enabled unless a certain SRV is calling for heat.
Hi, I have a Tado wireless Starter kit V3+ with 4no SRV's fitted for the last week. the SRV are installed as follows. 2no in the lounge (same room as the thermostat), 1no in the master bedroom, 1no in the office. When the lounge or bedroom are programmed to provide heat and the office isn't the boiler doesn't run unless I…
-
Help: Wiring Tado Wireless Smart Thermostat to Drayton Digistat SCR on Glow Worm Ultimate 35C
Hi, seeking help to wire Drayton Digistat SCR to the Wireless Smart Thermostat. I have already seen a post about this, but Drayton is wired differently, so I'm not sure what to do. Can you please help? Thank you
-
There is an option to set the cost of your daily usage. However there is no option, that I can fin
-
TRV Hunting
Hi - I'm new to the community and did look for an answer but am happy to be directed to a previous post if this has been covered. Most of my radiators work well with the tado controllers but one in particular hunts (taps loudly) as it is approcahing the set point and can do this for quite sometime. Any suggestions for…
-
Wireless Room Thermostat & Apparent Boiler Issues
Advice for anyone using TRVs in all rooms and notice their boiler appearing to cut out leaving them with no heating and an apparent boiler issue. Setup: We have Tado TRVs on all rads except one and the Wireless Room Thermostat (WRT) had been linked to the TRVs in our living room. Each room in the app has it's own schedule.…
-
Leaking valve
Hey all I’ve noticed that a few of my valves has small leaks. I’ve tried tightening them up by hand but I’m wondering if I need to use a wrench to do it instead? Could there be any other reason for small leaks? Cheers
-
Optimising my set up with Opentherm
Hi, It’s such a knowledgeable forum I’m hoping I can get some advice to make sure my setup is fully optimised. My setup is as follows - Veissmann Vitodens 111-W - Tado Wireless Extender Connected to boiler by Opentherm - Ground Floor - Room 1 has 2 x SRTs controlled by 1 Wireless Temp Sensor. Other rooms have no Tado…
-
Can I use Tado smart thermostats with Tuya smart TRVs in Tado app and with tado hub?
I have bought a house with several smart TRVs already installed and attached to a Tuya hub. I want to have a complete smart system so I’m thinking of installing a Hive or Tado hub and thermostat. But I want to be able to integrate the existing Tuya TRVs into the Tado system. Is this possible or will I have to control them…
-
Multiple Bridges, Single Account
I've asked this before, but I'm not sure I ever got a response. I know currently it is not possible, you need two accounts, which makes absolutely no sense. Are there any plans to change this? Am I looking at changing all my TRVs to a solution that does enable this? OR... is there a way of improving the range and…
-
Is my old version of the Internet bridge & thermostat compatible with v3 extension kit
Good evening all, I have one of the 1st starter kits consisting of a Internet bridge IB2853046784, wired thermostat RU2332166656 and wireless extension kit BU2178746624. I'm not sure what versions the hardware is. I'm thinking I need to replace my extension kit as it has an intermittent fault I need to know if the new v3…
-
Swapping faulty extension kit for wireless receiver, wiring problem
Hi all I think my extension kit is faulty with an intermittent fault sometimes it doesn't turn off the boiler even when it is commanded too. I have bought the new v3+ Wireless receiver but the terminals are labelled differently to the instructions for the extension kit I need to know which wire to put to which terminal on…
-
UK | Tado Frost Protection + Home Insurance = Not fit for purpose
I've just discovered that Tado frost protection defaults to a 4ºC. Most UK home insurance policies insist that a home is heated to 12ºC to avoid burst pipes (e.g. those hidden under suspended floors in older properties). There is no way to change this setting. If you manually turn off your heating and manually set the…
-
Comb boiler and rad full open
I seem to recall this ages ago-if using a combi boiler is one radiator meant to always be left fully open eg without a TRV and if so, is the outflow meant to be fully open as well?
-
What exactly does the high/ medium /low heat request do?
Does anyone understand this support page: How do I know how often tado° turns my heating system on and off? https://support.tado.com/en/articles/3478984-how-do-i-know-how-often-tado-turns-my-heating-system-on-and-off It says it shows: "heat request symbol as a number of wavy lines with 3 being a high heat request, 2…
-
Drayton Auto Balancing Valves
Both types of these valves are supported by tado according to their fitment list (no adapters needed) but just wondered if we have any early adopters on here or anyone reviewed and dismissed them. Body only kits are available about £25 in UK.