-
New combi boiler, smart wired thermostat permanently demanding heating
Hi all, Have just changed out our old system boiler for a new combi boiler. previously was running the system off the wired smart thermostat. we've tried to connect that to the new combi boiler but the boiler is constantly being given a demand for heating, even though all of the rads are turned off on the tado app. Is…
-
My Boiler would not start but Hot Water Works
Hi, and I hope someone can help me plz. I included my prev hardware details and boiler details. Main Combi Eco Elite 30 (Combi Boiler) Siemens RAA20 wired thermostat Siemens RWB27 timerswitch/programmer Bought Tado Starter Kit V3+ w/less thermostat Tado installation finds all the devices. I started by replacing RWB27. I…
-
ecoTec 24 installation troubles
I have a Vaillant ecoTec 24 boiler with VRT 350f wireless thermostat. I have installed my Tado thermostat as per instructions from the app for this model of boiler (using only black and grey wires to bus ports). Extension kit, bridge and thermostat are connected and working (as shown by app). Photos of installation below.…
-
Multiple Room Stats
Hi, I have a main room stat downstairs, which is in a "room" with 2 other radiators which have SRTs. This then obviously acts as I one room as far as heating goes. Upstairs I have 4 radiators with SRTs in 4 separate rooms. I have been thinking of getting another room stat for all of upstairs but not sure how it would work…
-
Wiring Question - Do I bypass / remove the existing controller ?
HI All, Just about to buy the wired started kit and additional wired thermostat. House has combi boiler, 2 wired stats (upstairs & downstairs), and a honeywell 7 day, 2 channel programmer. I understand that the internet bridge plugs into the router. THe wired stats replace the existing stats. What happens with my existing…
-
Tado wireless receiver dead?
Woke up this morning and boiler/underfloor heating circuit was dead. Seems during the night the 3Amp circuit fuse had blown. Replaced fuse and boiler/underfloor heating now working. But Tado Wireless receiver seems dead, no illuminated LED. My radiators cannot be turned on. Does anyone know if there is any internal fuse…
-
No power to wireless receiver
We had a major power cut in the area due to a fire. it took several hours before power was restored to the area, but since then I've had no power to the wireless receiver and as a consequence have no heating, hot water is ok. Could a power surge have caused the receiver to malfunction?
-
Multi zone heating with water tank installation help
Hi I'm a little stuck attempting to install my Tado equipment - I think because my setup is a little more complex than most houses, though not uncommon I don't think... Our current setup: 1 x Vaillant boiler 1 x Hot water tank 2 x Salus RT500RF wireless thermostat + receiver 1 x Salus EP200 The house is split into two…
-
Gravity system
I have a gravity system. Tado says it needs the blue setting for a this type of system. Having set it up for this requirement I note that even just asking for heat the water light comes on as well. Asking for water heat on its own is ok. Usually if you have a 3 position valve you can have either both on, or heating, or…
-
Offline installation instructions — wired thermostat
Hi, I am trying to install a wired thermostate, the old one is a Honeywell CM907. I need all the instructions offline because when I turn off the power, the WiFi goes and I can no longer access the bridge, and therefore instructions, via the app. I tried the chat but it's a hopeless robot, I'm afraid. Can I download the…
-
Logic Combi 30 .Central heating not working
I have tried to install tado wireless starter kit to my Logic combi 30 boiler as per app instructions. After installation receiver, bridge and thermostat all connect to internet and all lights on as should be. App shows everything working. However boiler will not turn central heating on. Receiver calls for heating but…
-
tado et clim mitsubishi heavy industris
bonjour, Je n'ai pas les réglages pour la puissance de ventilation ainsi que l'orientation des volets sur l'appli android! Pouvez vous m'indiquer si il y a un moyen de le rajouter. Cela pose vraiment un problème car je l utilise sur une maison secondaire, donc j'ai besoin de chauffer très rapidement avant que les…
-
Boiler and raditors always on
Hi all, i've noticed there is a few posts about this but none seem to help my situation. I've installed the Tado wiresless reciever next to my boiler (ideal system 15), a wirelss thermostat which is in my hallway and just one radiator thermostat at the moment. The problem i have is that no matter what i change in the app,…
-
VITOTRONIC 200 HO1A Installation
I’ve just tried wiring the internet bridge into my boiler control unit, but the cables shown in the app are different colours to the ones in my boiler. Instead of black and grey cables there are blue and brown cables. The existing cables connect with the existing exterior thermostat. So to me it seems logical that I would…
-
Wired thermostat in relay with wireless zone controller
Can I use the wired thermostat in relay mode to control an underfloor heating pump but connect it to the wireless zone controller to request for heat? Alternatively if I put the wired thermostat in the same room with a wireless thermostat could I pair them so the wireless thermostat would control the relay function on the…
-
Other rooms overheating when reheating the living room
I noticed a strange behaviour from my Tado temperature graphs. Whenever Tado is "reheating" the living room, two of my other rooms heat up despite the individual smart knobs are set to a lower value. The said two rooms did not call for heating. However, their temperature rose up to 19.3 degrees, even though thermostats…
-
AC and normal heating in same room
In the bedroom we have underfloor heating. I already had a Tado thermostat installed that controlled the underfloor heating. Separately we now got a airconditioning unit that also heats. I have just purchased a Tado AC control unit (V3+) to control it. The question is: How to set this up? Do I tell them they are in the…
-
Big trouble for me
i am not sure i am set up properly i have 7 trvs and a thermostat. The trvs seem to be functioning correctly through the app although i cannot no matter what i do get alexa to find them. The thermostat is meant to function my kitchen rad as it doesn't have a trv that is suitable for the tado swap however i am not sure the…
-
migrating to tado
Hello community! I'd like to replace my current thermostats with the Tado ecosystem. Great so far, right? I'll describe below my current setup and end up with the questions. I have a boiler (Viessmann Vitodens 050-w) which powers the underfloor heatsystem at the lower floor and the radiators at the upper floor. At the…
-
Lifestyle LP722 replacement
I'm replacing my Lifestyle LP722 controller and hall thermostat with a tado wireless v3+ starter kit. The thermostat replacement seems simple enough. However, the instructions for the wireless receiver seem to imply that I should put it close to my boiler. Do I simply replace the LP722 with the tado wireless controller…
-
New taco installation
I have a Baxi condensing boiler controlled with a Lifestyle 720 programmer and a wired Honeywell thermostat in the hallway. I have 6 radiators fitted with British Gas branded thermostats. What do I need to replace the hall thermostat and programmer? Also, can the radiator thermostats be updated simply with taxi intelligent…
-
Upgrading Wireless Receiver to Digital Model
I have an existing Tado setup, with SRVs on the radiators and a wireless receiver (UK model). Everything works fine. The boiler has just been replaced and I want to take advantage of the digital control. I have ordered a new wireless receiver from the Tado Pro site. When it arrives, how do I go about swapping them over? Do…
-
Returning left-over adaptors to TADO!
I bought a smart thermostat and 6 smart radiator knobs. After I've done the installation, I have quite some adapters as a left-over. I don't need them anymore. Not now or in the future. Does Tado has a sustainability policy? Are they making it possible to return those left-over things which are in a perfect condition and…
-
My Internet is down and I'm about to leave for 4 days...
What the hell do I do? Virgin is investigating, they plan to check in 2 hours after I need to leave. Tado is stuck on heating the house and will now default to running the on schedule day and night? It's costing £10 a day without heating all through the night as well. What can I do? All I can think to stop it is shutting…
-
No mention on Tado website of wireless cylinder stat setup
I have Honeywell: Wireless enabled programmer (ST9420C) Wireless room thermostat (DT92E) Wireless cylinder thermostat (CS92A) And a Baxi system boiler. All I want to know is which kit I need to buy. The wireless starter kit makes no mention of a wireless cylinder stat.
-
Morning Schedule suddenly stopped working
Hi All - My Tado has been working fine since I put it in about 6 months ago but about 5 weeks ago, suddenly stopped turning on at the first time block in the morning. After starting it manually (by turning the heating down, waiting until the timer clicks and then turning it back up to the usual 21 degrees) it works fine…
-
New Tado. Central Heating working. Hot Water not working. Can anyone help, please?
Hello, I have a new Tado that I want to use to control our central heating and our hot water. My kit is a smart thermostat, receiver, and a bunch of smart radiator thermostats. It was installed by a professional gas engineer. It was installed yesterday. The central heating is working fine however the hot water is not…
-
I’ve bought a Tado wired thermostat which is obviously wired to my boiler. If I purchase a Tado Wire
Will an extra wireless thermostat help keep the rest of the house warm. I have a Tado wired thermostat wired to my boiler in the kitchen and the rest of the house isn’t very warm
-
Worcester Bosch Greenstar 4000 System GR4700iW 12 S NG system 12kw
I am planning on purchasing a new system boiler, Worcester Bosch Greenstar 4000 series 12kW its got some very good green features of being able to modulates down to 1.9kW central heating output. I also plan to have a 250L unvented tank. https://www.wolseley.co.uk/product/worcester-greenstar-4000-system-12kw/ The Worcester…
-
Week setting in beta 1
I noticed today that I am unable how to change the schedule week settings from Mon-Sun. Mon-Fri, Sat, Sun. And Mon, Tues, Wed, Thu, Fri, Sat, Sun. And how do I go back to normal version please as uninstall and reinstall always defaults to beta version!