-
Minimum requested flow water temperature
Hello, Does anybody have any measurement what is the lowest flow temperature value the Tado thermostat may request from a boiler connected via OpenTherm ? Does it go below 30 C ? Is it affected by any means if you configure that you have UFH in the system ? (as with UFH you may use really low flow temperature)
-
Energy Tariffs Setting
There is an option to set the cost of your daily usage. However there is no option, that I can find, to allow the daily standing charge to be set. I need usage * unit charge + daily charge. Can anyone help?
-
why does my question have to be approved?
Ive just posted a 15 minus write up question - it says it has to be approved. Can a mod please have a look and give me feedback as to whether theres an issue?
-
Wireless underfloor heating
I have a fully set up tado system across all of my house (rads in every room) except for my kitchen, which has UFH, where the heating is controlled vi a wireless non-tado thermostat. I want to add the kitchen to the tado set up so I can see usage through the app and control the heating remotely. However everything I’ve…
-
Heating on all the time since installing
Hi, We installed a Tado thermostat and 8 radiator TRVs in our home a couple months back. Since installing them we are finding that it is causing our boiler to be on most of the day (averaging 22 hours of the day). The boiler is switching on to heat 1 room them once that’s up to temp, it switches off but then another room…
-
viessmann vitodens 050-w and Opentherm
Hi, I've just had this boiler installed and want it to use Opentherm which the boiler is compatible for. The old boiler didn't have modulation. I've had the tado system for around 4 years now so have the below setup: extension kit which is wired directly into boiler. internet bridge. 6 wireless radiator thermostats. 5…
-
Does scheduling hotwater on Tado app help reduce energy consumption rather than keeping it turned on
Hi, I have noticed that there is a hot water option in the app. But I have never used it. We have a combi boiler. If I turn this off on the app, does it turn off the hot water in the boiler? Can schedule when to get hot water? please can Tado help advise on this? Many thanks, Naren.
-
New user, but can’t get the app setting to hold morning schedule
Just had new Baxi Boiler fittedalong with Tado wireless thermostat. having problems setting morning time schedule on my phone app, evening one seemed o.k. However the Boiler and heating came on at midnight last night! Tried again this morning to alter settings on app. The afternoon/evening one seems to hold now, but will…
-
App werkt maar airco slaat niet aan sinds ik in het buitenland ben.
Hallo, mijn Tadoo airco controller werkt niet. Vorige week geïnstalleerd in ons vakantiehuis in het buitenland. Alles werkte perfect via de app ook als we buitenshuis waren. Eenmaal terug in NL werkt het opeens niet meer. Op de app staat dat de airco aanstaat maar als ik op de camera in huis kijk zie ik dat deze niet…
-
Allow the Wireless Receiver to be controled by multiple thermostats or Wireless Temperature Sensor
For the moment, as I am told by the tado support, the wireless receiver can only receive instructions from one thermostat and from the connected radiator valves. For a rooms which need a constant temperature (such as a bedroom always at 16°C for example), a wireless temperature sensor could be enough and we wouldn't need…
-
Frost Protection turning heating on full
Hello all, I keep finding my heating is blazing during the night while frost protection is active due to the cold weather. I have to turn down the radiator temperature on the boiler to stop it heating the whole house during the night. My understanding was frost protection runs a low temperature throughout the system to…
-
Flow temp settings etc. to save energy
We have a Worcester Bosch boiler and this spring installed a few tado radiator valves, a tado smart thermostat for the whole central heating system, as well as a separate wired thermostat for the underfloor heating in the kitchen. Given the cost of fuel, we want this to be as energy efficient as possible come the winter. I…
-
I've lowered my CH water temperature - my rooms don't heat fully now - HELP
Hi all, I have changed my CH water temperature from about 70 deg to just over 50 deg. I wanted to see how my rads handled the heating of the rooms with the lower temperature, with one eye on needing a Heat Pump in the coming years. In the evening, I run the downstairs thermostats at 22 deg I changed the temperature on 01…
-
Thermostat is off but temperature is going up and up
I got 5 thermostats and if I switch one off completely because I'm not in that room or don't want high temperature in this room the thermostat make the noise to lower the temperature but the room is still heating up. Sometimes I set it on 18C degrees but it climbs up to 22c degrees because in other rooms thermostats…
-
geen warmte vraag indicatie in de tado app ondanks aanklikken icoon
Ik krijg sinds een paar dagen geen staafjes meer te zien en kan dus niet zien wanneer mijn warmtewisselaar (stadsverwarming) wordt aangesproken en hoe vaak. tot afgelopen weekend kreeg ik dat wel te zien, maar nu dus niet meer. de temperatuurgrafiek zie ik wel (en gaat dus omhoog en omlaag) evenals de buitentemperatuur en…
-
Recommended rechargeable battery
Hi. I know there is an ongoing debate about rechargeable batteries but if one _did_ wish to use them which ones would be the best to use? Thanks
-
Tado Wireless Starterkit with Salus Command Center
Hi guys! Recently I've hit a wall when I've bought the Starter Kit V3+ Wireless for my UFH system among two other Smart Wireless Sensors. My configuration stands this way: Boiler: Bosch Condens 2200W 6 Zone wiring center: Salus KL-06 with a PL07 module to control the pump 6 x Actuators: Salus T30NC230 I've connected all…
-
E151 Error with Atlantic Perfinox 4124 BVIR - Impossible to use TADO
Hello, Several issues with my TADO Wireless controlling an Atlantic Perfinox 4124 BVI R boiler. The system is set as OpenTherm. E151 with big noise when the system tries to run the boiler at a very low level. There are 3, it is on 1 that I have a problem with. Difficult to know what TADO is sending as everything is hidden.…
-
Main / Baxi E133 Fault during low temperature in away mode
I had my V3+ kit on with newly installed Main Compact Eco combi boiler. It was working really good on the first few days, while I set it at 20 degrees. However, when I turn it down a bit at night or away like 17 degrees. The ignition light didn’t turn on and it fails then. I checked and observed a few times and found that…
-
Can I turn off my boiler with Tado?
Most of my radiators have Tado thermostats attached but I have a few that don't. One bedroom doesn't have a WiFi signal so I can't use a thermostat there. I have another 3 radiators that don't have thermostatic controls on them. All four of these radiators are on all the time because my Tado app controls individual…
-
Honeywell TRV to Tado SRT
HI All, Installed wired thermostat (V3+) followed instructions and boiler works as it should first time. Removed Honeywell TRV, i can't for the life of me get the Tado SRT to fit, even though its compatable (according to tado website). Do i need to use one of the adapters provided, or am i being stupid? I've tried…
-
Boiler not going off at night
I have TRVs on 4 radiators and when the requested room temperature is reduced at bedtime and there is NO heat requested the boiler still fires up. Any ideas??
-
Tado Product - which one?!
Hi I currently have a Vaillant combi + Vaillant vSmart wireless Thermostat. I have 11 radiators and I'm not really prepared to go all out Tado. I was tihking about putting a Tado system in of ~4 TRVs and see how it goes. Few questions: 1. Can I install a Tado smart TRV system alongside my current Vaillant setup? 2. If so,…
-
Wireless receiver not working!
Hi guys, i just buy my entire tado kit and I try to install it today. After I install and connect the Internet bridge and wireless thermostat I begin to install the wireless receiver after I tag all wires I respect all the instructions from app I turn on the power the wireless R turn on but when I press 3 sec the…
-
Part installation - poor comms to bridge
Hi, i've just started my Tado installation today, a little backwards - but internet bridge first, then ive installed all the TRV's before i have time next week to install the wireless Receiver to control the boiler. However, i've installed 13 valves - only 3 show as connected on the App, no matter where i've tried the…
-
Why won't my heating work but hot water does?
Just to say first, I have had no heating whatsoever for 3 days and today is day 4! I've installed the Tado Starter kit V3+ I have an Ideal ICOS M380 boiler. The cold water tank's in the loft and the hot water tank and wireless receiver in 1st floor bedroom cupboard, the boiler's downstairs in the kitchen. The system thus…
-
Moving from wired to wireless
I’ve currently got a wired system that controls two separate zones (upstairs and downstairs) using two Tado thermostats. Hot water is controlled via the wireless extension kit connected directly to the boiler. My downstairs (wired) thermostat is in the hall and does not reflect the temperature in the lounge. So I was…
-
Can rooms be grouped into a zone?
I have Tado TRVs in pretty much every room. What I'd like to be able to do is group rooms into a zone - e.g. group all bedrooms into 'upstairs' or living room + dining room into 'downstairs'. The use case for this is to have a standard schedule for up/downstairs, but still have the option to override things on a…
-
New user - using Tado offline, smart thermostat and wireless receiver not communicating?
Hi all, I've just installed my new Starter Kit on a Greenstar combi. Boiler is working OK. Wiring is correct - I can call for heat from pressing the heat button on the receiver and the receiver going into test mode. However, I can't manage to control the boiler from the wireless thermostat. I've raised the temperature on…
-
Wireless thermostat with SRV
Hi I’m sure this has been asked before. I’ve just had Tado wireless (and wired - 2 zones upstairs and downstairs) and I have some smart radiator thermostats I was planning to use downstairs. Questions: should the wireless thermostat be in a different room to the SRTs and which has priority. Eg - if SRT is set to 21c and…