-
Worcester Greenstar Cdi Classic
Hi all I have connected a wired TADO thermostat to this boiler as per the TADO instruction and for a start 3 smart SRTs. All is working fine. the issue is that the wired thermostat is working in relay mode, and I was hoping to get it working HT-Bus (D17). I opened up the boiler with the intension of disconnecting the LR…
-
Hot water tank control
When the water tank is at temperature should the standard thermostat on the side of my tank tell the tado to click the hotwater to off and turn off the relay as when my hot water is on for 5 hours it runs the boiler that long!
-
Tado App showing Offline
The Heat and Hot Water been showing Offline here and there in the last few days and months. I checked the internet (high speed and stable), it is working fine, all other wireless devices are working. I've had to manually unplug the bridge so it can be reset. Then it'll come back on. I've seen quite a few people mentioning…
-
coloured tado units
I'm refurbing the house and the Tado in the kitchen is going to look really out of place with its white colour scheme strapped to an anthracite radiator.
-
installing Wireless thermostat v3
our heating has two separate systems wired onto the one boiler (Ideal) and we have a large hot water tank. The heating circuit for the house and the water is controlled by a Nest unit and a wired heat sensor. The underfloor zone (water based) is controlled by an EPH controller and freestanding thermostat/controller. I need…
-
How to adapt current system into modulation-capable weather compensation system
Hi everyone, I am looking to migrate my current setup to the tado ecosystem but I'm not fully sure about how to best go about this. Some background: I have topped up my loft insulation, had external PIR insulation installed, my radiators powerflushed before installation of an Ideal Vogue Max - 32Kw combi, in addition to a…
-
Need help to install Tado correctly
Hi, everyone. I have moved to the new apartment, tried to understand how heating and hot water work, and replaced old controllers to tado. I thought that I had one boiler and s plan. I have replaced the controller to tado. And the heating is switched off, but I have hot water and can't control it) So let's go step by step:…
-
Room types in Tado app
On the tado website, it suggests different temperature and humidity tolerances for rooms (bedrooms, living rooms, kitchens, bathrooms for example) Setting the room type in the app would allow different tolerances for air comfort
-
Balance AC geen melding laten geven als de Airco uit staat
Ik zou graag een nieuwe functie voorstellen. We hebben destijds gekozen voor de slimme airco bediening omdat deze beschikt over een functie die de airco in Eco stand zet als alle huisgenoten van huis zijn. Hoewel dit geen gratis optie is (beetje jammer, iets met marketing denk ik), hebben wij wel de optie aan gezet om…
-
How do I to set the zone controller to react to smart radiator thermostats call for heat?
I have a smart wired smart thermostat as my zone controller. I have nine smart rad TRV thermostats controlling the rads (measuring devices) in different rooms. There are no manual TRVs. Your example setup A. All smart rad TRVs are set to uss the single Zone Controller. What do I set the Zone Controller temp to? I don't…
-
Tado Bridge V2 without PIN code, how to retrieve it?
Hello, I just bought a second hand V2 Bridge on ebay but it came without the sticker containing the serial number and PIN and the QR code. The seller says he doesn't remember ever having a sticker on it but he contacted Tado which were unwilling/unable to share the PIN code; they suggested he shared his email and password…
-
Zones
Hi Can someone please help? We have two zones to our Tado system. A thermostat downstairs and one in the boiler room. We have TRVs on all the radiators in the house (15). The boiler installers didn’t explain how the zone systems interact with the TRVs. For example, I presume I cannot set one TRV to 24 degrees downstairs…
-
remove unneeded App icons
I don't use all functions in the app: how can I remove an Icon from the screen? If this is not possible: please add it you your list of ideas / suggestions. cheers StefanF
-
Humidity accuracy
How accurate do you think the humidity sensor is? My spare bedroom, with good airflow, no mould and at room temperature reached a humidity level of 71% whilst my bathroom, which I had showered in shortly before, only reached 67% even with the shower on. I feel like the sensors are pretty far off.
-
Offline?
Hi - I am new to Tado. Had so many problems with the system. Can someone pls explain why the whole system keeps going offline? Internet is good and all connected properly. Go on to app, every element is offline, TRVs, thermostat. What is most common reason please? Thank you!
-
Technical support
As a complete novice I am so out of my depth with is equipment and it seems to me that you have to be a bit of a nerd to understand it at all. Why isn’t there a simple manual to help people like me? Why are there no people in areas of the country who will talk my plumber or electrician through this installation? I’m at my…
-
Error in app for newly installed radiator thermostat
I have just installed 2 thermostats, one comes up with error on the app. It shows as connected with good battery in the app. I have restarted it 3 times by removing the battery. On the thermostat display it shows a spanner, a home picture and a temperature reading. It is at firmware 66.4, the other one that I installed…
-
Tado, moving from boiler to heat pump. Including underfloor heating
Hello, I'm keen to install tado in our house. It uses a boiler, with three wired thermostats to control different areas of underfloor heating. However we have a plan in the mid-term to fit an air-source heat pump and hot water tank. I'd like to fit a tado system sooner rather than later. When we switch to the heat pump,…
-
Child Lock to shut screen off
My little one likes spinning the TRV through cot railings, want to be able to child Lock and shut led display off
-
HomeAssistant - Tado > Local Control
Hi all! Anyone been successful in setting up the Tado devices on Home Assistant locally? No reliance on cloud? If so, please share how you did! Thanks!
-
Finding correct adaptor for radiator valves
Apologies for a newbie’s simple question but what adapter should fit this type of radiator valve? https://photos.app.goo.gl/KtYiDfSBZwqZf3iF8
-
Solar
Hi. We have solar panels and a Solar Boost box next to the hot water tank as any excess power will heat the water. We have the timer on the Tado for the water but it does not work. It does if you specifically switch the water on. Any ideas?
-
Use Smart AC Controller as Wireless Temperature sensor
If people have a Smart AC Controller it would be good if it could be used like Wireless Temperature sensor with Smart Radiator Valves. That's could be easily done through Internet Bridge, they are in the same network. In addition if AC can't heat but there is a Smart Radiator Valve in that room, Smart AC Controller could…
-
Auto heat/cool boost
Thermostat automatically lowers or raises temperature if temperature hasn't reached set temperature. I.e if the AC is set at 22°c and the room temperature hasn't dropped to that temperature the thermostat will tell the AC to cool to chill lower than what's been set untill it gets to 22°c. Therefore making the condenser…
-
Smart Rad vs Basic Rad thermostat
I've installed 4 x Smart Rad thermostats, and I've just installed 2 x basic rad thermostats. Am i right in saying the only difference is the digital display on the smart rad? My basic rad thermostats show everthing the same on the app incl. humidity. And the control is the same. Seems a waste of money buying these…
-
Help getting Modulation on a Worcester Greenstar 28i Junior working
Hi, I've just installed an extension kit, bridge, and wireless thermostat but can't get any heating demand via toe digital connections. My boiler is quite old, but has digital terminals, labelled B B. As per Tados professional installer manual, I've connected these to the extension kit. Switch in position 1. Set the TS to…
-
Replacing Danfoss ECtemp Next Plus
I want to replace my Danfoss wired thermostat on a wet heating system with a Tado smart thermostat. I can find no information on whether this is possible. Any advice please?
-
Heating Valve always open
Recently moved into a house and paired all of the devices that were left in the house. However, the hot water value is now always open but none of the smart thermostats are calling for heat. Any suggestions as to how I fix this. Thanks.
-
Access to bad connection data and signal strength
To help with placing the internet bridge, It would be helpful if there was an easy way to see when devices (eg radiator thermostats, wireless boiler controller etc) have disconnected from the internet. A list of the times they disconnected/reconnected or even just a total count of the times this happened. Currently to see…
-
Smart Valve in Same Room as Smart Thermostat
Just about to extend my Tado system to the whole house. I have a Worcester Bosch condensing boiler with a wired thermostat. There is no by-pass circuit fitted in the plumbing. My Thermostat is Tado Smart and I have 4 Tado Smart Rad valves. Want to extend by adding 4 extra Smart Valves. Conventional wisdom is not to put a…