-
Tado install on Vokera Easi-Heat I 29C
Good morning New to Tado and looking forward to getting to grips with it . . But I have a slight issue in regards to boiler selection for the wireless receiver. I have a Vokera Easi-Heat I 29C and was wondering if there's an alternative for this selection to get me under way ? Does anyone have the same issue and have done…
-
Will modulation work?
Hi all. I have been interested in getting tado for a while but have held off as I was having a new boiler installed which has now been completed. I have just had a Worcester Greenstar 4000 25kw combi NG installed so need some advice on whether or not the tado products can offer modulation on this boiler so that it can…
-
add LPG to Fuel type
would i be possible to add LPG to Heating Type with the calculations to work with graphed data to reflect price and KWH for unmetered connections
-
private
Hello I have Tado smart radiator thermostat v3+ 3 years old How do you get new hardware (update) so that you can reverse the display (orientation)
-
V3 Wireless Receiver Installation
Hi all, I have a quick question regarding the installation of the wireless receiver. Having taken the cover off the old programmer, I am left with the attached wiring. The yellow cable is for my water and the blue cable is for my heating according to the old unit. Is it just a case of putting the yellow cable to HW NO and…
-
Default for adjusting a TRV should be “until next change” or at least set as default
I quite often increase the heating in the front room using the TRV. That seems to set the temperature “until you resume the schedule” whereas if you use the app the default is “until next change”. This has resulted in me leaving the heating set on 20oC overnight a few times. Is there a way to change the default setting? If…
-
Temperature Display
Hi When you blink the display from the app can it display the current temperature rather than a pointless message. Regards John
-
Global boiler override schedule
My system gets turned on a lot as different rooms heat up at different rates. I’d like to have a global boiler override schedule so I can ensure it’s always off at certain times (including heating and hot water) rather than having to try and set weird on/off blocks for every room throughout the night/day to try and save…
-
Useless? Tado with Air Source Heat Pump
Hi Currently got a combi boiler with Tado thermostat and radiatorr valves around the house. Works great and help turn on/off the boiler when needed. However now considering to upgrade to an air source heat pump system. I understand that the thermostat and TRVs would still be working and compatible but what's the point ? I…
-
Siri issues
Siri understands my command, but can’t make it. Despite I ask a temperature of 19.5°, Siri will set it at 19°
-
Graph showing global boiler activity
I don’t think this exists, or I cannot find it. I’d love to be able to see the pattern of when my boiler is active globally rather than when each room is calling for heat.
-
Digital EMS Opentherm connection Worcester Bosch 42cdi
Hi It's clear that it is possible to control Bosch Combi boilers based on users actual experience. But can I ask if anyone done it with a Greenstar 42cdi?. I will try tado support but that at moment is taking a long time to get a response I asked WB. their response below. I have a WIRED room thermostat with digital…
-
No heating thrmo not firing boiler
I have no idea why but last week we realised the heating wasn't coming o, did some checks and the wireles throat is recording the right temp checking the app it's recognising that the temp is low and says the heating is on the wired controller is showing the heating is on but it will not fire the boiler,,,, the hot water…
-
Smart TVR Problem
If the Smart TVR is manually adjusted by rotating the top segment, it causes the body to rotate as if the battery is to be changed, this causes the body to become detached and subsequently loss of control of that valve.
-
Heating Not Turning On
Hi All I've recently installed the Wireless V3+ replacing a Potterton EP2 (Y Plan). It appears I've installed it correctly as all lights are on. I've then connected all of my Smart TRV's (including via the app). Everything should be working fine... however, none of the radiators are turning on when requested via the app...…
-
Optimal way to set up system. Starter kit and TRVs
Hi all, I’m just setting up my system and putting the TRVs on most radiators. The only one I’m not putting a Tado TRV on is the two bathrooms. My questions are, should I put the main wireless thermostat in the master bedroom and not put a TRV on that rad, or should I put it on the landing where there is no rad. Also,…
-
Wiring from a Sunvic TLM2253
I'm replacing a SUNVIC TLM2253 - but I can't work out what wire goes where on my Tado thermostat. I have two wires going into the Sunvic, plus an earth lead to the casing of the Sunvic. The help on the Tado app, suggests I need 3 and I don't have them in the positions they think I should. Attached is a photo - but the grey…
-
Smart AC Control Does Not Work With Auto Mode
After a couple of hours testing the Tado controller vs my AC unit's stock controller, I'm convinced the Tado has some serious issues with 'auto' mode. (For reference, the AC is a Daikin FTXB09AXVJU heatpump unit). When I select 'auto' heat/cool mode, auto fan, 76F degrees on the Daikin controller, temp holds reasonably…
-
Tado 3 zone?
My set up is a 3 zone system (upstairs, downstairs and hot water). I have a secure channelplus H37XL programmer with upstairs and downstairs set to permanently on and a Tado wired thermostat attached to those rooms. The hot water is just set to a normal schedule. I have a Tado extension kit from my previous house, and was…
-
Open or close valve without controlling heating system
It would be nice if we could control the valve full open or fully closed without start/stop heating system. Example, i need a radiator always opened because of the pressure system and dont want it to control the heating system, just let the current water flow in.
-
eliminazione modalità operativa su Termostato
Salve volevo farvi ragionare sulla scelta di eliminare la possibilità di impostare la modalità operativa su Termostato con il controllo clima In pratica adesso questa funzione non è più utilizzata perchè ritenuta obsoleta. Sono in disaccordo. Attualmente con l'ultimo aggiornamento avete impostato che il controllo clima da…
-
Do Smart TRV Basic Work With Wireless Temperature Sensors?
I really, really hope so 😬 I tested with a starter pack V3 with one Smart TRV and a wireless temperature sensor. It worked! So I then ordered 6 wireless temperature sensors and 8 Smart TRV's but accidentally Basic ones. I've only just spotted the difference, having installed one. Can anyone advise before I go further?…
-
Thermostat not triggering boiler when TRVs call for heat
Hi everyone, I'm going mad a bit over this issue. I have a fairly simply setup and can't understand why this isn't working properly. Here it goes: 2 rooms: 1 living room and 1 bedroom. Living room: Wired thermostat + 1 valve radiator. Bedroom: 1 valve radiator. To clarify: all three are tado products. Problem: TRV in the…
-
Connecting to logic C35
Hello, I have had tado connected to my logic combi c35 for a while, I changed broadband provider a few days ago and cannot work out how to get the Internet bridge connected to the new wifi, the light is flashing on and off.
-
Air Comfort is worthless, doesn't work
I recently upgraded to the v3+ app in order to get the Air Comfort functionality, which sounded quite useful. Except it doesn't work. I'm in the UK and the last couple of days have been lovely and warm. Therefore we've had the patio doors wide open all day in the same room as our Tado wall thermostat. Air Comfort is…
-
Away mode schedule
It would be great if Tado would support an away mode schedule: a schedule that only operates when away mode is triggered, instead of the current single away mode temperature. My use case: due to dynamic energy pricing it is wise to start heating around noon, even if I'm away. But if I'm home in the morning than heating…
-
Scheduling issue
I have four time blocks, three of them work but the first one in the morning does not.
-
Battery replacement
Only had the system for a couple of months and already being told batteries need replacing .on one rad i replaced a week ago and tado says they need replacing again . Any comments welcome !
-
Upgrading an old Tado system
I had Tado installed 10 yrs ago and looking to upgrade and fit smart valves. I currently have a Bridge, wireless thermostat and a receiver wired to a Potterton Titanium condensing boiler. I understand that I need a new bridge and thermostat for smart valves to work but can I keep my existing wired receiver. Thank you for…
-
Battery dimensions and the TRVs
After growing tired of the ongoing expense of replacing batteries in TRVs (wouldn’t be surprised if the cost of batteries is equal to or greater than any perceived cost of energy usage) I invested in Duracell rechargeables, only to find they get stuck inside the TRVs and it needs needle nose pliers to get them out risking…