-
Away mode schedule
It would be great if Tado would support an away mode schedule: a schedule that only operates when away mode is triggered, instead of the current single away mode temperature. My use case: due to dynamic energy pricing it is wise to start heating around noon, even if I'm away. But if I'm home in the morning than heating…
-
Switched Fused spur / smart plug controller
Hi, I really like Tado and we have smart thermostats on all our radiators. However, we also like our electric fire on in the living room from time to time. It would be nice if there was a switched fused spur or smart plug option so we could control all our heating devices through Tado. We could control the fire through a…
-
Helpful for Tado to revert to the original temp when turned back on again, not just the default 21C
As you can see from the screen shot below, on a Friday there are 7 different time / heating slots in one room - all of which may need to be turned off when occupied and then turned back on again - often on an alternating weekly cycle Ideally there would be a second Heating on/off toggle switch that works for the entire day…
-
Automatic temperature/ventilator speed for TADO Smart AC control.
A growing number of people use air conditioners (AC) to heat their houses (cheap, available, efficient). Temperature measurement is done in the AC unit, close to the ceiling of the room.This location results in poor temperature control in the room (stagnant warm air layer). With the TADO Smart AC control you can measure…
-
Support for Viessmann PlusBus
Since 2020 the Viessmann Vitodens 2xx and 3xx range of gas boilers do not support KM-Bus or OpenTherm any longer. Viessmann decided to "upgrade" the interface on this boilers to PlusBus. This is an in-house developed protocol which they claim is an evolution from KM-Bus. However there is zero information to be found online…
-
Schedule by month/season
Ability to set schedules for a wider period than monday-sunday. If I cud set every day for the calendar year would be helpful/batch up months and seasons. Easier!
-
Open thermostat with empty battery.
It would be very helpful if there was an option in the app to leave the thermostats open (perhaps with a choice of 0-100%) when they run out of power. I currently have three thermostats, one of which constantly reports that it's out of power even when it's not, and this one also runs out of power much faster, requiring a…
-
Option to have Away turn off everything even manual settings
Often we occupy a room at random times during the day, when we leave home all the auto radiators shut down but not the manually set ones. It would be nice to have an option to turn all off when away from home is sensed. Once away from home it should still be possible to manually activate individual radiators to pre-heat…
-
Issues Notification
This morning the heating was registered as on but the temperature in all rooms was not increasing. I didn't notice. When I got up I noticed that the temp was low in all rooms. I checked the app and the Care and Protect part of the app registered that all valves were running at 100% but temp was not rising. On the Wireless…
-
24/7 Customer Support
This isnt a technical suggestion: tado needs a more engaging, 24/7 customer support. Monday to Friday for end user customer support is not good, especially for a service that is 100% cloud based. When something goes wrong a user needs to know, do I need to call a heating engineer or is it a fault with tado & their systems.…
-
Manage email notifications
I suggest a feature to manage which email notifications to receive. Concretely I often receive emails like "Your Smart Radiator Thermostat needs new batteries" despite being plenty informed via the app - and there is, quite surprisingly, no option to unsubscribe. My proposal is to let the users decide which emails they…
-
Heating configurations
Related in a way to being able to select multiple rooms - it would be handy to be able to create heating schedules based on different scenarios, for example; working from home, not working from home, one person away etc. Would be great to switch between them and have the schedule reflect the rooms I need heated and when…
-
Room temperature calibration
You can set a temperature offset but usually the offset is different depending on the actual room temp - so offset usually is accurate for high or low temperature but not the other (due to non-linear temperature profile of the room from a point not near the TRV). It would be great if I could take the TADO wall mounted…
-
Widget
Hallo het zou fijn zijn als de Tado applicatie ook een Widget kan oproepen op het beginscherm, misschien leuk voor de volgende upgrade !! Succes Met vriendelijke groet Stephan J Vestallen
-
A must change issue for Tado!
We have a holiday home for rent, and it is very irritating that tenants can change the programs on the smart thermostat. They must be able to change the actual temperature, but not the settings and programs on the thermostat. Also kids can make changes unintentionally It would be a great improvement that changing…
-
Offer a cheaper radiator valve.
In rooms where a wireless temperature is used as the control device there is no need for the SRVs to be able to sense temperature. Why not offer a cheaper version which only opens and shuts the valve as demanded by the wireless sensor.
-
Room view: change from tiles to list
Hello I have several rooms, and floors, and I find since the early days that the tile view is quite confusing. I always waste time in finding a specific room. There is a lot of screen space wasted, so I must each time scroll down. On top of that the colour codes and why and how a tile would change colour remains unclear to…
-
Cylinder, stat
Hi does anyone know if there will be a Tado cylinder stat in development?
-
Smart AC control V3firmware 103.3 does not support quiet mode
2 x Panasonic AC & 1 x mitsubitshi A-A, all with quiet mode, which is one of the reasons they were bought. unfortunately Tado seems not to be supporting "Quiet mode", lowest setting on the fan speed does unfortunately not do it. request for this feature has been going on since 2021, how long time will it take to fix it ?…
-
Feature to turn off LEDs Internet Bridge
I like to have the availability to turn off the LEDs Internet Bridge.
-
Add 'Cubic Feet' to Measurement Units
I have figured out the main reason why the EnergyIQ does not work for UK users without a smart meter - the older style gas meters are imperial units, and the readings are in cubic feet, not cubic meters. Are you able to add this as a measurement unit on the app alongside cubic meters and kWh?
-
Set a manual time limit on Manual Away Mode to go back to auto.
Set a manual time limit on Manual Away Mode to go back to auto similar to the manual timer mode on the TRVs/Thermostats.
-
ZAPIER integration ?
Hello. Does anybody know if TADO will be allowing ZAPIER integration ? This would obviously allow TADO to be controlled by many devices on ZAPIERS list and also allow many scenarios to be played out.
-
Programmation "simple"
Bonjour Serait-il possible, plutôt que d'utiliser votre programmation intelligente qui est une véritable "usine à gaz" a programmer de pouvoir simplement démarrer et arrêter a une heure dite tout simplement !! Début à: , Fin à:, Froid ou Chaud, Température et c'est tout ! Merci d'un retour PS J'ai eu plusieurs échanges…
-
Provide configurable option for TRV to be a zone controller
I have noticed that in Energy IQ certain rooms consume more energy than others with Bathrooms, and Kitchen being higher on the list. Although these rooms are smaller, it is clear that the temp drops quicker due to ventilation and extractor fans. As such these TRV's switch on and call for heat at times that the boiler would…
-
Return to schedule in Alexa
Through Alexa routines I can use my Hue remote to turn up the heating in the room when I turn the light on which is great. But the only option is to turn the heating off or to a set temperature when I turn the light off. Would be useful if one of the options was return to schedule.
-
When heating a room, open valve in steps
When Tado heats up a room for example from 18c to 20c, it´s all or nothing. Because the valve is open all the way, it make a hissing noise. What if it opens in steps? That would minimize the noise coming through the valve. It´s not tado that is is causing the noise, but the valve being open full to reach the Temputure all…
-
POE ethernet
Make a power connection for the "Internet Bridge"using the POE option of a ethernet-switch. It will bee much easy to connnect the "Internet Bridge", just one wire. Best regard Peer Herbsleb
-
Geofencing able to adjust individual rooms
Would be a great feature if geofencing could turn on/off an individual’s room if they are not home instead of everyone having to be out of the house
-
MFA - 2FA authentication for increased security
Hi, A bit surprised that no 2FA is offered/configurable for increased security when signing in and/or starting the application. (And possibly but overkill linking it to actions in the app (home/away, changing schedule, .....) Other smarthome apps - MyQ, iRisco, Ring, ..... - all have (added) this feature to avoid…