-
Device grouping
Be able to group devices in to zones/areas Rather than having to turn all devices on if needed set a group for example downstairs/upstairs or whole house which would turn the grouped devices to the same settings
-
Géolocalisation status on Alexa routine
Hello, I want create a routine on Alexa with the status géolocalisation tado. No possibility to change the status. No possibility to test the status on automatic routine
-
“Saved Schedules” Idea
Hello, I have seen some posts about shift workers. To echo these. The way of editing schedules is very fiddly and time consuming, especially when you have a different shift pattern each week. It would be more beneficial to have “saved bank” of specific days and specific weeks you work, and you can quickly copy them into…
-
Timed Boost Function with a physical button
Hi All, would it be possible with a firmware update to setup the button on the thermostat to act as a boost button also. Its more for the older generation who find navigating mobile phones a pain. I have been looking into using a smart switch and IFTTT to try and mimic this boost function but can not. Although I have got a…
-
Cylinder, stat
Hi does anyone know if there will be a Tado cylinder stat in development?
-
Greenstar 8000 EMS compatibility
Please develop EMS compatibility with Worcester Bosch Greenstar 8000 range to permit proper modulation control.
-
[Energy IQ] Allow for new meter and continue entering meter readings
When replacing a meter, it becomes hard to continue entering meter readings as one has to add the last old meter reading to the new meter readings (and sometimes even subtract the first new meter reading from that number too). Under Energy IQ, provide a meter reset button, with for the date of changeover: ++ the first new…
-
Different colour radiator thermostats
We have raw metal radiators and the white radiator thermostat valves look out of place - I may try painting them but think would be a nice idea if Tado offered black and grey etc… as opposed to just white?
-
Quiet fan mode - AC units
Using the setup guide, and referencing the model of Mitsubishi Electric AC units that I have, it supported a lot of the modes that are possible. One omission that I would like to have added is the "quiet fan mode". We have a unit in the bedroom that we use every night and with the IR remote that came with the unit you can…
-
child proof fixation of the radiator thermostat
The radiotor thermostat comes loose way to easy. My 14 months old kid had it loose in no time. What is the point of having a child protection mode in the software, if the hardware is not child proof.
-
Apple Watch App
I've got quite a large Tado heating system installed on everything in my home. I've just got an Apple Watch. I get the notification when I leave home on the watch. However, I can't switch to away mode from the watch. This would be very useful (and also to be able to switch back to home mode). You definitely need to write…
-
Tado app for Apple Watch or other watch
It’ll be cool, we had an app for the watch for using on Apple Watch or other Stead of using the HomeKit it will be better than he had an app for the watch is the same way as the iPhone and iPad Don’t want to use HomeKit Can you make one please?
-
Reduce the comfort temperature range to 18-21°c
In the uk a room set for the comfort range of over 20°c can far exceed a comfortable temperature. I would suggest reducing this so my app doesn't think my house is cold all the time
-
Cooling for underfloor water systems
I have "centralized" machine for deliver heating or cooling (according to what it is configured by building manager). I am asking to include some kind of software switch to change between winter and summer mode, just to be able to manage cooling underfloor water system (set 25ºC temperature as a target and achieve it while…
-
Add imperial units to measurement options in EnergyIQ
Older style meters (pre-smart meters) still provide meter readings in imperial units - cubic feet. This means customers without smart meters cannot use the EnergyIQ, because it only allows you to add meter readings in cubic meters (new style meters).
-
Multi-Home Tado
Would be so great to have multi home support in the app. Such a pain having to log in and out all the time. If this is complex - and I realise that not everyone needs it - how about releasing "copies" of the App so we can download 2 or 3 of them and have them logged in individually. This may apply well to everyone. I want…
-
Duration for manual control through thermostat
I would like to set, using the app, the duration of the manual temperature control activated through a thermostat. I would like to choose between until you cancel until you resume schedule until the next time block Right now, there is no choice and "until you cancel" is the only behaviour.
-
Support 2 point calibration for adjusting temperature offset (Temperature Guesstimate)
It would be very helpful to enable 2 point calibration for adjusting the temperature measurement to match the middle of the room. Scenario as follows: At low temperature the thermostat reads the same as the temperature measured in the middle of the room e.g. 15°C so no offset required but at higher temperature the…
-
Responsive User Interface
The User Interface should be responsive to ensure it renders correctly on all screen sizes maximising the resolution to ensure the best possible usability. When programming complex schedules it's much easier to use the web interface on a PC or Mac where you should have the benefit of a large screen showing the full smart…
-
Allow naming of smart radiator thermostat
It would be really good if I could assign names to all of my smart thermostats. It would make it so much easier to identify which one needs its batteries changed.
-
Always show temperature on Tado ac
Have an option to set Tado ac to always show the current room temperature on display.
-
Wireless Receiver - status and history in application
I would welcome to see actual status (on/off) of Wireless receiver and chart with history in the application and web.
-
Integrate with smartthings
we need an official integration. Why would i not want to control some of the best smart elements of my house with my heating??? Makes no sense there is no official integration
-
Energy IQ - Usage is not based on actual meter readings
We were away from home for about one week and wanted to try an experiment with usage data. Our heating was in away mode throughout and did not switch on. I submitted regular meter readings within Energy IQ at the start of April, then on the day we left, and as soon as we returned, and on the following day. The meter…
-
Temporary off with timer
The current whole-house on/off feature is manually off, then manually on. It would be helpful to set a timer, so that we can turn the whole system off for a certain amount of time only.
-
Show the flame icon on the Tado thermostat display when the boiler is running
Very useful to have at a glance if the boiler is running without having access to the boiler display. This is standard in almost all the thermostats.
-
Scheduled "Call for heat"
atm we have the option to enable or disable a zone controller, and this stops the room calling for heat from the boiler. But, I think due to the cost of living crisis around the world atm, it would be a good option if Tado˚ could move this option to the Scheduling screen. My idea would be for each time block in the…
-
API Integration for Energy IQ
I use the energy provider Octopus In the UK, and they provide me with an API key for my account that can be used for getting meter readings and other things. It would be so good if, in Energy IQ, I could put in the API key so that the meter reading were added automatically.
-
Change room colour in app when heating
Can the app be changed to highlight those rooms that are heating
-
iOS 16.3 HomePod Temperature Sensor
With iOS 16.3 HomePods can now relay temperature and humidity data to HomeKit. I’ve had trouble with the room heat being cold on one side, and the tado valve is near radiator… I’m using the HomePod for offsetting the room temperature, could this be automatic ?