-
Idris Crumlish
i have a worcester 24cdi combi boiler with British Gas rc plus thermostat will tado work
-
Adding a wireless thermostat to an existing wired system?
Just installed a wired thermostat (heating only, no hot water) plus several TRVs. Realised I also need a wireless thermostat. Can I just buy a wireless thermostat and it will connect to the existing system? Or do I need to also buy a wireless extension (costs a lot more)? Thanks RedTom
-
Lost access to extension kit still connected to phantom 'Home'
I have a two boiler home and had added a second Extension kit to a separate account. That worked fine. Then I made the mistake of moving from my first account to the second one through an invite. This gave me access to the second account and second extension kit, but I lost access to the first one. Unfortunately the…
-
Exchange from Satchwell 2259 thermo statto Tado
In my current thermostat, I have a Live, Neutral and Earth cable. Please can anyone advise if this is adequate to run a Tado? Thank You Ross
-
Replacement Smart thermostat to control Hot water
Ok so I have lost my original smart thermostat that controlled my hot water via the extension kit. I have a replacement smart thermostat which I have added to my devices which works ok for heating. Unfortunately my hot water is still looking for my original thermostat and I dont seem to be able to find how to swap the…
-
Replacing a Nest and how best to zone with TRVs
We inherited a Nest smart thermostat with our house, and I would like to replace with a Tado since i'd prefer the HomeKit integration - has anyone done a straight swap? If so are there any gotcha's with installing the extension unit (i.e. is the wiring the same?) And which kit do I need? Wired or Wireless? (I know the Nest…
-
What do the boiler levels really mean?
I noticed that when the current temperature is closer to the target temperature, the smart thermostat does not even turn on the boiler. it shows the heat demand as <10~15% like below. Is this intentional? when the demand shows two bars then it turns on the boiler. is this correct?
-
Moving from Honeywell duel to Tado single
HI My local installer sold me a lemon and while i asked about Tado he convinced me to take a terrible Honeywell setup. I need some advice on what to buy to move to Tado and bin the Honeywell kit. Current setup: 2 x Honeywell Lyric Wireless thermostats A Split home valve for each hoeywell to call for heat. HOWEVER this has…
-
Screw holes up and down, not on the sides
Tado smart Thermostat expects the screw holes to be on the sides. in my case its top and bottom. and there is no place to drill new holes. any ideas how to work around this? I would love to not use the tape and stay with the screws. Image here
-
Posted by mistake
Posted by mistake - sorry
-
Connect Vaillant turbotec plus vuw-soe 282/3-5 to Tado wireless extension kit.
Hi, I tried to connect my Vaillant turbotec plus vuw-soe 282/3-5 to Tado Wireless Reciver (BR0214113536) but when i tried to test the system, the boiler did not start to heat up. I tried to use bus + and - connection and i tied tu use 7, 8, 9 connection, but there no responese from boyler.
-
Help with replacing Satchwell TL35 Thermostat
I am trying to replace my old Satchwell TL 35 Thermostat with the Tado Smart Thermostat, but I am a little unsure of the wiring. There are 4 cables on the old stat, Red, Black, Black and Green (earth) - see attached photo. Where do these go on the new Tado Thermostat? Any help appreciated.
-
New Install Help..
Hi All I've just installed Smart Thermostat V3+ Starter Kit and I've got an issue where the boiler (Vaillant ecotech pro 28) replaced a Danfoss wired Thermostat using 2 wires COM/N0 The 2 Radiator valves work fine but the boiler is running all the time, I have everything switched to off on the app and its still running…
-
Tado Support - Not Responding to Installation issues?
I have installed 4x additional Smart TRV's and 2x Smart Thermostats to use a external temperature sensors, I need these configuring to call for heat and also the Smart Thermostats added to the rooms with the TRV's to control the temperature as they are behind curtains and the radiator temp is generally off by quite a bit.…
-
2 physical heating zones, 2 wired thermostats and multiple TRVs
Hi, My home which has the following setup... 2 physical heating zones (1 upstairs and 1 downstairs) 2 wired thermostats (1 controlling the upstairs zone and the other controlling downstairs) Ideal Logic+ Combi c30 boiler Multiple TRVs Both thermostats and all TRVs have been changed to Tado devices. I've created rooms in…
-
Setup
Hi just installed the tado v3 wireless wall thermostat, extension and 4 smart rad thermostats. I have 10 rads in total (2 towel rails, 4 rads fitted with the tado smart rad thermostats and 4 fitted with manual danfoss thermostats) am I right in thinking that the 4 rads with the danfoss thermostats and 2 towel rails work…
-
Heating system switched off
Good morning, So I recently installed the multi-room system of Tado, with an extension kit on the central heating system, 1 Smart Thermostat and 2 Smart Radiator Thermostats in the living room, one SRT in the master bed room and one SRT in the bath room. Our baby room and kitchen are not (yet) equipped with a SRT. Now, I…
-
Does Tado supports two heating system?
Hi, I am moving to a property where there is a separate annexe with its own central heating and hot water boiler system. How can I control my main house and the annexe with my Tado Home app? Regards, Dhruba
-
Set-up tado for hot water (Smart Thermostat V3+)
I can see that HotWater can be set-up for Hot Water. I have an extension kit that talks to by combi boiler but I cannot find anywhere in the app that let me configure the hot water like so: Where can I find the information regarding this aspect?
-
HELP for configuration
Hi have the following setting: 1 Smart Thermostat 4 Smart Radiator Thermostat (one on each room) I would like to drive the heating system mainly with the Smart Thermostat and I want to set the Smart Radiator to shut themselves if the temperature in the room reaches a certain temperature. What's the best configuration I…
-
Smart Radiator Thermostat valve heating off
If you turn heating off for a Smart Radiator Thermostat, will this shut the radiator valve by closing it?
-
Do I need the extension kit and thermostat? Honeywell system.
HI, I am looking for some advice. We want to replace the thermo stat with a Tado device. Don't need to control the hot water with Tado unless I have too. or its an easy swap out. Below are photos of my system. I have Worcester Greenstar HE condensing boiler and a cylinder in the airing cupboard. Do I just need to replace…
-
HOW CAN I CONTACT TADO
Use the chat! Well the bot said within 4hrs, then 1 day, then 1 week. There is no phone number, only an answerphone. My system hasnt worked correctly for months. This service is appalling. What is going on??????
-
Rooms in Zones
I have three zones in my house. Each zone has it’s own zone valve. I have a Tado thermostat for each zone. I now want to allocate individual rooms to each each zone. Rooms have one or more radiators with Tado TVRs. How do I do it?
-
Replacing Tado
Tado tech support seem to have given up and are suggesting I return it for a refund as the valves just can't keep reception with the bridge and it's messing around with my boiler. Does anyone have any experience of other systems? I remember doing so much research before I bought Tado and I more have to do that all over…
-
Online Installation Assistant
Hi All I'm moving house in the next couple of months, and want to integrate Tado into the system (the full monty i.e. thermostats and TRVs). I'd like to do as much homework on installation in advance as I can (more about the wiring side of things), but without having a product to register in the app, I can't get to the…
-
Smart radiator thermostats not turning on heating
I recently installed 2 wired smart thermostats. I then installed a radiator thermostat and found that it was not switing the hitting on in order to heat the room it was installed in. Has anyone had this problem.
-
Radiator valve heating loop allocation
We have 2 heating loops in our house, ground floor on one and upper floors on another and we have tado smart thermostats controlling each look. We have added 3 smart radiator valves but there is no way of telling them which heating loop/thermostat to request heat from???
-
Radiator valve heating loop allocation
We have 2 heating loops in our house, ground floor on one and upper floors on another and we have tado smart thermostats controlling each look. We have added 3 smart radiator valves but there is no way of telling them which heating loop/thermostat to request heat from???
-
Question re Smart TRV & general thermostat interaction
Hi, I’ve just had Tado installed and have Smart TRVs in all the main rooms (lounge, kitchen, bedrooms). No Smart TRVs in the hallway and bathrooms which are still manual valves. In hindsight I think that probably wasn’t the best set up. The house is narrow and over 3 floors, lounge on bottom, kitchen middle, main bedroom…