-
TRV on riser pipe heat accuracy
Anything that can be done to get the TRV to be more accurate. It's sat below a hot riser pipe which is going to make my temperature readings wrong. Any easy mods I can do to help with this?
-
Help
I have wired a wireless receiver, it replaces a myson mep2c. This only had L N and 2 other wires in the back of it. Those two wires went to HW on and CH on The wireless thermostat downstairs also controls hot water, that appears to working ok but the heating isn’t working. I have a wired thermostat upstairs which is…
-
Confused how the wireless thermostat works and few questions
Hi everyone, I got the "Wireless Smart Thermostat Starter Kit V3+ with Hot Water Control" but during installation realised that my thermostat is wired and the Wireless Receiver does not control the heating at all. So, is the receiver in this case only for the water control? Do I have to buy a wired thermostat now and have…
-
Tado setup question
Good morning I have just moved into a new house and I am looking for some advice on the best set up. I have a 2 zone heating system, upstairs and downstairs My plan was to buy a wired thermostat to control downstairs and hot water and a wireless thermostat to control upstairs. I also have a sun room which cools down alot…
-
Heatmiser DS-SB Replacement
Hi all, Just looking for some advice as I've emailed the installation support but anticipate quite a wait. I'm installing a Tado thermostat to replace an old Heatmiser DS-SB. In the app, there's some labelling that isn't matching my current wiring e.g. no SL. From what I can figure: L - COM N - P1 A1 - I'm confused at this…
-
Is the Tado Thermostat Accurate?
I have just set up a DHT11 sensor to monitor temp/humidity in another room and I thought I would put it next to the Tado Thermostat to compare. The results are: Tado Temp: 18.29 DHT11 Temp: 22.3 Tado Humidity: 68.8 DHT Humidity: 70 The humidity is pretty close but the actual temp is pretty different!
-
No manual on for boiler
Hello I currently don’t have internet and I can’t see an obvious way to switch the Tado wireless programmer to be manually on. There is only the test button. When I hit the test button the heating will remain on a loop where it will turn on for a couple mins then turn off, and this will repeat until I manually turn off the…
-
How to wire for 'wired smart thermostat' ?
Hi, I am upgrading my old underfloor heating from a Danfoss Living system to Tado. The wiring of the excisting relay you can see on the attached photo. How should I wire the Tado 'wired smart thermostat' ? HPNielsen
-
How can I sync the Home Screen to the Rooms and Devices
I have named all the rooms in the rooms and devices section. But when I go to the Home Screen it still says room 1, 2, etc. How can I sync the 2. Thank you
-
Which Tado kit do I need?
Hi! I would like to upgrade to a Tado smart thermostat and smart TRVs but my knowledge in this area is very limited. I have read other threads to try to work it out but get confused rather easily. I'd very much appreciate it if someone could tell me what I do/do not need. I live in a two-bedroom flat, the boiler is in the…
-
Y-plan 2 zone system on combi (Rads + UFH) with Tado wireless starter kit + wired thermostat
Thoughts on this? System boiler with 1 zone heating being replaced by combi with 2 zone heating (all radiators on zone 1, but now separating UFH to zone 2) The plumber wasn't familiar with Tado and its capabilities/limitations but having gone through it together we came up with the following modified diagram based on the…
-
Switching from Google Nest
Hi all, just after some advice please? I currently have Google Nest with a Heat Link connected to my boiler. The heat link then powers my thermostat in another room. I thought (wrongly) I would need the Wired Smart Thermostat starter kit, but this has just arrived and I don’t think this is correct. I thought, Tado would…
-
Wireless Receiver completely lost connection
We woke up to an extremely cold house this morning. The wireless receiver and all thermostatic valves are no longer connected. I have followed all of the help sections but nothing is working at all. Nothing has changed in the house so I simply cannot understand what’s happened. Any advice greatly welcomed.
-
Smart TRVs too hot
Hey all, my smart TRVs kick out far too much heat. I set them to 19 and they keep going to 25C. The radiator valve moves… help. I’m sweaty
-
Switching to electric boiler
I had until yesterday a system boiler that did both my hot water and central heating. I have installed a fischer aquafficient battery water heater and on Monday will have commissioned an 8kW WHBMULTIKW heat only from Fischer. I have a solar array and batteries so electric is more efficient to me than gas. I have an…
-
I have a radiator and the thermostat regulator contains a remote sensor in it.
I have a situation in my living room where there are two radiators controlled with one thermostat. The thermostat they have used looks like the one in the pictutre below and I would like to replace this one with tado smart thermostat and wondering how to include the remote sensor into the feed? Is this even required in…
-
Smart thermostats not controlling correctly
Hello, I've installed six smart radiator thermostats along with a wireless temperature sensor. I've also set up a wireless receiver and internet bridge, both of which are confirmed to be working. However, I'm encountering a significant issue. When I request heat for one thermostat and set others to frost mode or off, the…
-
Wireless Receiver Offline Strange Behaviour
Had my Taco installed for just over a year and has worked mostly fine. There's been a couple of occasions annoyingly where a temperature change as part of a schedule has not been sent to the Wireless Receiver, but by the time I've noticed it's all online and working again. Yesterday the Wireless Receiver went offline…
-
Combining a wired thermostat with wireless receiver?
I have an F&E system boiler comprising of: Kitchen: Gas Combi boiler with a wired thermostat in the living room 1st floor: Hot water cylinder with wired hot water and heating controller Attic: Cold water tank I have purchased: 1 x Internet Bridge (to be placed in basement) 1 x Wired thermostat to replace the living room…
-
Looking for some installer help...
Currently I have an deal Logic Combi2 C30 wired up with x2 Danfoss TPOne-M thermostats in dual zone (Upstairs and Downstairs) How would I go around getting Tado installed with dual zone and OpenTherm? Currently I bought two wired Tado's but think these are just running as on/off
-
Tado V3+ EU & Ideal Logic+ 24 Combi Setup. [UK]
I've currently moved into my first home and am looking to install the V3+ StarterKit. I've read quite a few posts here and still find myself largely confused with how to proceed. ( I have absolutely zero experience with any of this stuff ) I'm in possession of a Ideal Logic+ 24 Boiler which is OpenTherm compatible, and I…
-
Equipment List and Setup Query
Hi All, We are undergoing some building works and i am trying to plan my new UFH systems to help explain to the installers how i think it should work as part of switching to Tado which they are not familiar with. Is the below correct and what equipment would we need to achieve the below? The two extensions are having UFH…
-
Tado installation
Hi completely useless at this bought a wireless tado V3 starter kit but I have a wired thermostat in my hallway does this mean i have to get a wired tado thermostat instead of this wireless V3 one I bought and whatever one is needed how easy is it to setup or install. Thx in advance
-
SOLVED: tado setup for one boiler with two heating circuits (UFH and radiators)
Slightly odd one perhaps but as I spent quite a bit of time researching whether tado could work for my home's heating setup and didn't find any clear answers I wanted to post for others to see that it is possible -- and how! Original setup: one boiler (Vaillant EcoTec Plus 838 + two heating circuits, one for the underfloor…
-
Default settings for manual overrides
Am I the only one who keeps everything turned off and manually turns up a room of cold? The trouble with the way the app is configured for this way of working is that the default is to leave the room at the manual temp you set until the next scheduled change… this can mean it’s on for ever and defeats the objective of…
-
Wiring Sanity Check
Hi! My house has two heating zones, upstairs and downstairs, and a combo boiler so there is no hot water control. I'm replacing the existing in room thermostat with a Tado wired thermostat. The existing wiring looks like I was going to wire the Tado wired thermostat as: Old -> New N -> P1 L -> COM NO1 -> NO Strip back the…
-
Has anyone succeeded in making a ideal logic c24 work with Tado. I’m having issues
I have followed the instructions and I can’t seem to get tado to control the boiler.
-
Unable to connect on ipad
Old fella struggling to see Tado on ipad. 1. Works fine on my win11 pc and win7 laptop, all rooms visible and controllable. But on trying to get on my elderly ipad it will not connect. 2. Worked fine on my ipad several years ago but after bringing out of long term mothball I cannot login. 3. On page ‘app.tado.com’ it…
-
Tado installer in Cambridge
Can anyone recommend a Tado installer for a gas combi (logic heat h30) in Cambridge? Thanks
-
Can I use a Tado Smart Radiator Thermostat with: 'Danfoss FHV-R' ?
Can I use a Tado Smart Radiator Thermostat with: 'Danfoss FHV-R' ? (Regulating Combi Valve) As a replacement for a 'Danfoss FJVT'. https://assets.danfoss.com/documents/75214/AI147986474603en-010701.pd…