-
Hot water and geofencing
Hi, just like some advice to see if I have this set up correctly: Hot water is set to come on twice a day and in the advanced section, geofencing is set to off so that If I am out of the house, hot water still runs to schedule At the top of the page, away mode is set to OFF. Everything runs smoothly. When I go on holiday,…
-
Cannot change way schedules are adjusted for a room
Hi, I always make occasional changes to a schedule through an iPhone. For all of my rooms except one, this allows me to set a period before the schedule resets. The message on the screen says for instance “until 10.19 etc” But one room has adopted the “until you cancel” method (so i have to remember to cancel). I think i…
-
How to setup Tado for wet underfloor heating?
I have the Tado smart thermostat (wired thermostat) and extension kit (including internet bridge) installed to run my central heating radiator system and hot water in my house. I am having to an orangery/extension built at the rear of my lounge and the plan will be to run under wet floor UFH in the orangery on a separate…
-
Wired Thermostat stopped firing boiler
Hi, Recently had a TADO Wired Smart Thermostat (Starter Kit V3+) fitted to Worcester Greenstar CDi. I only have the thermostat/bridge and no other devices as yet. It worked for the first couple of days but now is not firing the boiler. I can hear it click when I adjust the temp but nothing is happening at the boiler. We…
-
Would Tado connected to Junkers CG2200W BUS ever work?
Hi! Are there any chances for tado software to support digitally the above mentioned boiler? The available relay mode is the least energy saving solution of all and not very environmentally friendly. This is a modern boiler using hysteresis to control the flame, allowing to use it for the most of time at minimal available…
-
Tado wired thermostat not communicating with my boiler
I have a Worcester Bosch Greenstar 37 CDi combi boiler. My installer has just connected a Tado Wired Thermostat Starter Kit V3+. ALl of the wifi pairing is fine, and it's communicating with the app and the Smart Radiator Thermostats fine. The only (critical) problem is that the Wired Thermostat isn't communicating with the…
-
Wiring New Tado Receiver - Changing from British Gas Hive.
Hello, I have just bought a Tado Starter Kit V3+ (Bridge Wall Thermostat and Receiver) Following and reading the set up instructions (but not yet physically fitting the Tado devices) they are very easy to follow, both for the Bridge and the Wall Thermostat, however the Receiver to me isn’t clear when trying to connect it…
-
Does anyone have a spare VR65 wiring centre?
After first confirming with Tado that my new Vaillant system boiler would be compatible with digital eBus and then having it installed, it transpired that actually it wasn't! "sorry for the inconvenience" was the reply from Tado!! Yes, their support and documentation is really really lacking knowledge and detail. Anyway,…
-
Does tado have devices online for developers?
I am programming remote-control algorithms for heat pumps, but do not own any tado products. So, instead of buying or chasing one down somewhere, I wondered if tado has some of their controls online for developing purposes? That would of course be greatly appreciated!
-
HomeKit show no response on 1/9 tado device
Hi there, I got 9 tado radiator termo., all 8 are connected to HomeKit without any issue, but one is keep saying no response, but all 9 are showing up on Tado App correctly no problem there. any suggestion of what I can do? Thanks.
-
Two Tado, two boilers, one house
I have 2 Tado thermostats in a house. Each one is connected to a boiler. 1 is connected via a wired connection to a system boiler. The other is wireless to a combi boiler. When the wired thermostat triggers it turns on both boilers and thus both heating circuits. When the wireless thermostat is triggered only the combi…
-
Extension kit - repalcement jumper
My builder has lost the jumper on the back of the extension kit. Does anyone know where I can get a replacement jumper?
-
Time Guard Immersion
Hi, I have a timeguard immersion heater as a back up, cycled weekly to prevent it scaling it would be useful if Tado had a similar device as a back up. The controller works online or with blue tooth and reverts to a stored program if it loses connection. And it can connect with an external hot water tank thermostat.…
-
There is only one room.
How do I add rooms used at different times of the day
-
Smart Radiator Thermostat is it just a head or a valve as well?
Hi all very newbie question. I've just bought 4 new radiators and I did not buy any valve at all, I'd like to install the Smart Radiator Thermostat, do I need to buy a TRV valve and then replace with the Tado Smart Radiator Thermostat or the Smart Radiator Thermostat comes with a valve? in other words, is the Smart…
-
Smart AC Control - "Updating Configuration"
Hi all, I got my first Smart AC Control unit (as a tester - will need about 6-7 more if I can get it all working). It arrived on Tuesday and I started setting it up. I seemed to be able to get it to control my Midea Breezeless AC unit. But then it goes into its "Configuring" mode, with the progress spinner message,…
-
Flow Through Radiator
Could anyone possibly advise on this, I fitted my devices and a smart thermostat and my flow through radiator hasn’t cooled at all in 2 days, is the wiring ok ? Or isn’t it compatible with my heating. Cheers for looking folks
-
Does anyone know how to access the rooms area in the app?
I can’t find how to change the room I’ve assigned to my thermostat. I’ve got some radiators on and some not and I think I’ve assigned the thermostat to the wrong room. It’s in the hall and I’ve got it in room 1. All the instructions I’ve found don’t apply to my app
-
Is there a possibility to add schedules per day an not for the complete week?
I need a schedule per day and not per week as everyday is different. My wife and children are coming home on different times each day.
-
Smart Thermostat not working
Worked great for several years. Suddenly stopped. Replaced batteries, cleaned contacts. No sign of life. Is there a way to bypass the thermostat and fire up the boiler until we can get a new one? Thanks in advance.
-
Can't get replacement thermostat to work.
Hi, I'm trying to replace an existing Tado Smart Thermostat with the same model, as the original one keeps depleting batteries. I thought it would be a simple job of just removing the old one and putting the new one in the existing socket. I've done this and registered the Thermostat and the Tado app can see it in the…
-
Hot Water Control
Hi, I have spoken to tado chat, and I am still unsure how to proceed. I am happy to contact a professional installer if needed. Here's the basic setup I have a tado wired thermostat and 6 TRVs upstairs this is working fine, downstairs I have underfloor zoned heating (and I am going to leave this alone). I have hot water…
-
No Hot Water, When Heating Isn’t On
Hi, We have had a new boiler installed (Worcester Greenstar 4000) with a cylinder, along with a Tado system (2 zones, one ground floor, another second floor), during the winter. As the weather has got warmer we have not had the heating on. But in doing this we are finding that we don’t have any hot water, even though the…
-
Existing System - Now won’t hear to temp
I’ve had Tado installed with the bridge / wireless stat / 4 x TRVs for over a year, always worked fine. Suddenly and for no apparent reason, it doesn’t want to hear the house to temp. Hot water works fine and switches properly. Overriding does nothing. When I Opened the app this morning and manually started hearing rooms…
-
Wiring Etc - Tado to Worcester 30i
Hoping one of the Guru's out there might help and put my mind at ease. Background: Recently had a Worcester 30i installed by British Gas, they used a contracted electrician to do the wiring. He also wired in my Honeywell wireless heating controller. Fast forward to current day and getting rid of Honeywell for Tado.…
-
Mixing TRVs and Thermostat
I recently installed the starter kit with a smart thermostat in my lounge with the TRV left fully open. All other rooms were left with conventional thermostats. Everything worked well. I have now added 3 Tado TRVs to the remaining rooms. I now have the problem that even if the room with the thermostat in is to temperature…
-
RAD Stat vs Wireless Sensor.
New to Tado - just installed the starter kit, very pleased. My question is would you have a wireless temperature sensor in the same room/location were you have a tado Radiator thermostat 🤔 Regards Bob
-
How to go about preventing a total system failure?
Before I had my new combi boiler and Tado installed I had an older system with a separate water tank. If that old boiler ever had issues I could simply use the condenser heater in the water tank and still have hot water. Now that my new boiler has Tado connected, as far as I can see I cant even force the boiler back to…
-
Do I need Tado to control my underfloor heating as well as the radiators?
Hi - hopefully a relatively easy question. I have a Worcester Bosch combi boiler, with what I think are two separate zones - one is 'almost all of the house' and the other is the underfloor heating in the kitchen. There is a wired thermostat for each, and a timer module which controls these separately. In the house there…
-
Ideal vogue 32 opentherm hot water preheat control
Just had our old boiler replaced and the new Ideal vogue 32 boiler is connected with opentherm. So now the boiler modulates which is great. However the hot water preheat on the boiler is set to off. Can turn on but Wondering if this can be controlled by tado by enabling hot water control in the smart thermostat. We have an…