-
Extension no longer paired
Hi All, In need of some help. I have a tado extension, thermostat and 12 TVRs. I have these all set up in my new property for a month without issue. The system controls both hot water to the cylinder and heating in a fully pumped s-plan system. The house is relatively large so some devices are at the periphery of the…
-
SRT disconnects at low temperatures?
Went away for a couple of days, so the heating was essentially set to a low setback temperature for the duration. Our kitchen, which is the coldest room in the house for a number of reasons, has a smart radiator thermostat that had new batteries about 2 months ago. As this room cooled down the thermostat started repeatedly…
-
Worcester Greenstar CDi and wireless thermostat
Hello Everyone I have recently purchased and tried to install a Tado system and a wireless extension kit to my worcester bosch Greenstar cdi30 It is controlled originally by a wireless thermostat, the DT20RF I beleive it is similar to the British Gas one. Any ideas on how to wire in the Tado ? I have followed instructions…
-
Tadoº conecting to Remeha Tzerra Ace
Hi there, I think that my Tado thermostat and CV Ketel not communicating properly. I also can't find much information about how to connect them physically (wiring) and what settings do I need to have on the Tadoº thermostat. Thanks, Regards, Vova Ford
-
TRV Control
I have changed from gas central heating to a Mitsubishi Ecodan ASHP and I want to use the Tado Bridge and Wireless thermostat from the gas CH system, to control TRV's on the radiators creating an upstairs zone. Is this practical? If so I may buy sufficient TRV's and a second Wireless Thermostat, to create upstairs and…
-
TRV Installation help/advice
Hi all, I have just transitioned to a tado control system and installed 2 out of 4 TRV using the app guide. Installation was straight forward but I have found that setting the valves to Off (frost protection) the 2 radiators were still heating up to full temperatures. Checked the pins on the valves weren't stuck and on 1…
-
Re: Geolocalizzazione non funziona
-
Tado & HomeKit
Hi I’ve noticed that my humidity levels on HomeKit app is way out compared to the Tado app. I have tired un pairing the device and removing the bridge which corrects it for 20mins or so and then the HomeKit app then reverts back to its old humidity level. Does anyone have any suggestions ?
-
is this right for me?
Having just had the expense of a new boiler, a Worcester bosch greenstar 8000 style, I thought it might be an idea to get Tado to utilise modulation and room by room temp control. will this work? i have read that Tado doesnt support modulation on this boiler and uses relay on/off for heat control. My plan is rip out my…
-
Understanding Thermostatic Valves
Hi, I'm considering the thermostatic valves to add to my existing tado smart thermostat set up. I understand that I can use these to avoid heating rooms I'm not using. What exactly do the valves consist of? Do I just remove the head (I believe this is the top bit where you would traditionally change the temperature) or is…
-
Switch to OpenTherm “clean” smart info
Hi, In a few weeks my boiler will be wired for OpenTherm (it’s on/off now) and the wires in the thermostat will be switched to the +/-. And of course the installation guy will make some config changes in the thermostat itself. So far so good. The question I have in this situation is: is it needed to “clean” the smart info…
-
My Tado System wont turn off the boiler
A week ago my Tado system decided to stop turning the boiler off and if i dont turn the power off it just keeps running ? I have been using it for a year with no problems until now. Can anyone help me.
-
Is Tado a product still in beta testing?
I ask as I'm surprised to find some very basic features not functioning properly: Invite of additional users not working correctly. Users dont receive the email to access Tado, they only receive the revocation email It when the router is offline (i.e. switched on, but has no internet connection for whatever reason) the…
-
Tado loses cloud connection after internet dropout and starts heating
Hi, I have noticed if my internet connection drops out momentarily my tado internet bridge does not reconnect and the cloud light flashes. When I then consult the app all the icons show remote connection not possible. I also noticed today that the heating fired up even though it was not supposed to be on. It appears in…
-
Tado thermostat not working
Hi, suddenly all my tado thermostats lost connection to the bridge, hence I can’t control them remotely anymore. my AC controllers are still connected to the bridge though and I can control them remotely. How can I resolve this?
-
Sync Issue when changing room temperature ?
I have the livingroom where there's the main thermostat and 4 TRV's on the radiators. They are all defined as being in the Livingroom. When I change the temperature in the Livingroom using the main thermostat, the TRV's do not sync meaning they don't adjust the temperature. This used to work. Changing temperatures in…
-
Replacing extension kit
I need to replace my extension kit which is faulty. The model I have is the BU01 which I believe does not exist anymore. Will I be able to replace it with the EK01 and use it with my existing thermostat or will everything need upgrading?
-
Mitsubishi MFZ-KJ-VE - fluctuating temperature
Got a Mitsubishi MFZ-KJ-VE (https://www.compareairconditioning.com.au/brands/mitsubishi-electric/console-split-system-mfz-kj-ve/) in our vacation house in Sweden. The Tado is set at 16 degree C when the house is empty. I think the temp varies to much. What’s your experience? Why is it stable one day and very fluctuating…
-
Tado installation in 60m2 flat
Hello, Im going to install tado devices at my home. I read some information about different devices and I would like to verify it here. Currently I have: 6x Heaters 1x wireless temperature regulation - programmer (model Auraton tx2005) 1x receiver (model Auraton tx) 1x gas boiler (model Ariston EGIS) - two functions. Heats…
-
Change of meter for energyiq
I've had a smart meter fitted, with its readings starting at zero. Is there a way to tell tado this? Also is there any plan to get tado to feed off smart meter readings automatically?
-
Manual operation.
Hi I recently moved into a property that has a Tado system installed. My vendor registered me as a user, so all good there. The problem is that I'm not on the Internet yet, and won't be until 4/1, BT are managing this, so the date is aspirational. So, I tried operating the system manually. I have two panels. The panel in…
-
Cold room, high temp on stat
I have a radiator in the hall, which a radiator in a bathroom is tapped off the pipe work just below the thermostat The problem I’m having is the thermostat is reading a higher temp, when the room is set to 16c, so the thermostat won’t switch on, as it thinks the room is already hot, I think the pipe feeding the always no…
-
Valliant ecobus - can I utilise instead of current 230v Y plan?
Hi All, I posted several weeks ago about getting my Valliant Ecotec 630 plus wired in to my extension kit for heating and hot water. I successfully wired that in using the Y plan on the 230V feed. It has however come to my attention that I likely have VR65 ebus on my system (I haven't opened up the boiler to check yet). If…
-
Tado firing heating outside of schedule without manual intervention
Tado keeps randomly firing up in the middle of the night on one of my wireless thermostats, when the schedule is set to off, even without manual intervention. When I open the app it says “resume schedule” at the top of the Home Screen, but neither of us have changed the heating. We wake up and find our upstairs is at 25…
-
Extension kit loses connection - sets boiler to 11😕
My Tado has largely been working well since I installed it, however the Extension Kit connected to the boiler randomly loses connection in the middle of the night - and it only seems to be the extension kit when I check in the app on the occasions I've noticed it is broken. I've tried moving the bridge progressively…
-
Best way to utilise Tado - efficiency
Hi. I live in a terrace house with an attic conversation which I use as my home office Monday to Friday. At the moment I have the system to turn off the intire heating system other than the radiator in my attic room. At around 5pm the system then turns off the attic room radiator and the living room is turned on. The…
-
Radiator valve says connect good but does not react to any commands
I’ve setup my kids radiator valve and it says now connected and good reception The room is bellow the kitchen which has the boiler receiver and another radiator valve that work perfectly. When I test the app and press say hi the valve does not react at all… and the temperature does not really change I’ve tried to reset…
-
Turn off tado and use a radiator normally
Hi, I've moved into a rented flat that uses tado. There's one thermostat sensor at the top of the stairs. The whole house is set up as one 'room'. This means that when on a cycle it just heats everything up like wild until the thermostat can sense it. I just want to turn on one radiator in the living room and not have all…
-
Wireless Receiver Device Error and dropping pressure
I have Tado installed in my house, I have heating as expected but have seen that recently the wireless receiver has the device error light lit up. This light along with the wireless connection lights flash briefly once about every 3 seconds. Also I have seen since installing Tado that the pressure in my boiler keeps…
-
Energy I Q
The new feature in the Tado app ‘Energy IQ’, only has the option of entering gas meter readings in cubic meters. Typical British meters show readings in cubic feet. Can the app be modified to use cubic feet reading to assess usage?